Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on February 2, 1995.
As of Friday, November 29th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Models
1994 and older gasoline-powered vehicles, EXCEPT those equipped with OBD II.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-372
  • Executive Order 372 / D372
  • ARB # D-372
  • Executive Order No: D-372
  • C.A.R.B. No. D-372
  • Resolution D-372
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-372 PDF

D-372 Document:


CARB_D-372

                                                  (Page 1 of 2)
                            State of California
                            AIR RESOURCES BOARD

                          EXECUTIVE ORDER D—372
                Relating to Exemptions Under Section 27156
                            of the Vehicle Code

                            AUTO TECH PRODUCTS
                      AUTO TECH PRODUCTS‘ PCV VALVE
Pursuant to the authority vested in the Air Resources Board by Section 27156
of the Vehicle Code; and    j                   >
Pursuant to the authority vested in the undersigned by Sections 39515 and
39516 of the Health and Safety Code and Executive Order G—45—5;

IT IS ORDERED AND RESOLVED: That the installation of the Auto Tech
Products‘ PCV Valve, a modified PCV valve, manufactured by Auto Tech
Products of 23681 Schooner Drive, Canyon Lake, California 92587, has been
found not to reduce the effectiveness of the applicable vehicle pollution
control system and, therefore, is exempt from the prohibitions of Section
27156 of the Vehicle Code on all gasoline powered— 1994 and older vehicles;
excluding‘ those equipped with OBD II.
This Executive Order is valid provided that installation instructions for
Auto Tech Products‘ PCV Valve will not recommend tuning the vehicle to
specifications different from those of the vehicle manufacturer.
Changes made to the design or operating conditions of the PCV Vaive, as
exemfit by the Air Resources Board, which adversely affect the performance of
a vehicle‘s pollution control system shall invalidate this Executive Order.

Marketing of this PCV Vaive using any identification other than that shown
in this Executive Order or marketing of the PCV Valve for an application
other than those listed in this Executive Order shall be prohibited unless
prior approval is obtained from the Air Resources Board.          —

This Executive Order does not constitute‘any opinion as to the effect that
the use of this PCV Valve may have on any warranty either expressed or
implied by the vehicle manufacturer.
THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
APPROVAL, OR ANY OTHER TYPE. OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF
CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED
BENEFITS OF AUTO TECH PRODUCTS‘ PCV VALVE.
No claim of any kind, such as "Approved by the Air Resources Board" may be
made with respect to the action taken herein in any advertising or other
oral or written communication.


Auto Tech Products                              EXECUTIVE ORDER D—372
                                                 (Page 2 of 2)



Violation of any of the above conditions shall be grounds for revocation of
this order.   The order may be revoked only after ten day written notice of
intention to revoke the order, in which period the holder of the order may
request in writing a hearing to contest the proposed revocation.   If a
hearing is requested, it shall be held within ten days of receipt of the
request and the order may not be revoked until a determination after hearing
that grounds for revocation exist.

Executed at El Monte, California, this Cf%




                                       Assistant Division Chief
                                       Mobité Source Division


                           State of California
                           AIR RESOURCES BOARD




                      EVALUATION OF AUTO TECH PRODUCTS
              PCV VALVE FOR EXEMPTION FROM THE PROHIBITIONS OF
VEHICLE CODE SECTION 27156 IN ACCORDANCE WITH SECTION 2222, TITLE 13, OF THE
                       CALIFORNIA CODE OF REGULATIONS




                              February 1995


                            State of California
                            AIR RESOURCES BOARD




                      EVALUATION OF AUTO TECH PRODUCTS
              PCV VALVE FOR EXEMPTION FROM THE PROHIBITIONS OF
VEHICLE CODE SECTION 27156 IN ACCORDANCE WITH SECTION 2222, TITLE 13, OF THE
                       CALIFORNIA CODE OF REGULATIONS




                                     by
                           Mobile Source Division
                            9528 Telstar Avenue
                          El Monte, CA    91731—2990




{This report has been reviewed by the staff of the California Air Resources
Board and approved for publication. Approval does not signify that the
contents necessarily reflect the views and policies of the Air Resources
Board, nor does mention of trade names or commercial products constitute
endorsement or recommendation for use.)


                                  SUMMARY


      Auto Tech Products of 23681 Schooner Drive, Canyon Lake, California

92587, has applied for an exemption from the prohibitions in Section 27156 of

the California Vehicle Code (VC) for their PCV Vaive.   The PCV Valve is

designed for installation on all gasoline powered 1994 and older vehicles,

excluding those equipped with OBD II.   Auto Tech Products submitted a completed

application and other required information.

       Based on emissions test data of the device, the staff concludes that
Auto Tech Products‘ PCV Valve will not adversely affect the exhaust emissions

on those applicable vehicles for which an exemption is requested.
       The staff recommends that Auto Tech Products be granted an exemption as

requested and that Executive Order D—372 be issued.


                                 CONTENTS

                                                        Page Number



SUMMARY
CONTENTS
I.        INTRODUCTION
II.       CONCLUSION
III.      RECOMMENDATION
IV.       AUTO TECH PRODUCTS‘ PCV VALVE DESCRIPTION
V.        DISCUSSION OF AUTO TECH PRODUCTS‘ PCV VALVE




                                         L


     vearere cone osints EseT00CFrue1o, or me
                        EVALUATION OF AUTO TECH PRODUCTS


                          CALIFORNIA CODE OF REGULATIONS


I.     INTRODUCTION

       Auto Tech Products of 23681 Schooner Drive, Canyon Lake, California
92587, has applied for an exemption from the prohibitions in Section 27156 of

the California Vehicle Code (VC) for their PCV Valve.      The PCV Valve is

designed for installation on all gasoline powered 1994 and older vehicles,
excluding those equipped with OBD II.   Auto Tech Products submitted a completed

application and other required information.

II.    CONCLUSIONS
       Based on emissions test data of the device, the staff concludes that
Auto Tech Products‘ PCV Valve will not adversely affect the exhaust emissions

on those applicable vehicles for which an exemption is requested.

III.   RECOMMENDATION

       The staff recommends that Auto Tech Products be granted an exemption for

their PCV Valve for instaliation on all gasoline powered 1994 and older
vehicles, excluding those equipped with OBD II.    The staff also recommends that
Executive Order D—372 be issued.
IV.    AUTO_TECH PRODUCTS‘ PCV VALVE DESCRIPTION
       Auto Tech Products‘ PCV Valve has been specifically designed for

installation on all gasoline powered 1994 and older vehicles, excluding those
equipped with OBD II.   The device operates in conjunction with the original
equipment manufacturer‘s (OEM) computer controlled fuel injection system and

emission control system already certified with the stock engine.

       The purpose of modifying the PCV valve of an engine is to vent blow—by

gases from the crankcase into the intake manifold freely regardless of engine
                                        —]—


vacuum.    Auto Tech Products‘ PCV Valve‘s orifice is designed to regulate gas

flow based on the speed of the engine.        This was accomplished by designing the

PCV valve to be activated by the use of a solencoid valve and the addition of a
small switch placed at the throttle linkage.

v.        DISCUSSION OF AUTO TECH PRODUCTS‘ PCV _VALVE
          Auto Tech Products, has requested that the PCV Valve be exempted for

all gasoline powered 1994 and older vehicles, exciuding those equipped with OBD

II.   Comparative emissions test data using the CVS—75 Federal Test Procedure

was conducted on two passenger cars to evaluate the emissions impact of the

device.     Auto Tech Products performed emissions testing at Environmental

Testing Corporation.

          Results of the exhaust emissions test data are shown in Table 1.


                                       Table 1
                                 CVS—75 TEST RESULTS

                                           NMHC         CO      Nox
1992 Mazda Miata 1.6L          Device      0.27        2.59     0.68
Test wt. 2500 lbs.             Baseline    0.32        3.31     0.62
H.P.   8.8                     Difference —0.05       —0.72     0.06

                                              NMHC     cCO      NOx
1994 Ford T—Bird 4.6L          Device         0.096   1.349     0.412
Test wt. 4000 1bs.             Base) ine      0.095   1.165     0.337
H.P. 9.0                       Difference     0.001   0.184     0.075


          The emissions test data generated at Environmental Testing Corp.

indicates that the HC, CO and NOx emissions of the vehicles, were within the
allowable limits of 0.1 gm/mi or 10 percent increase on HC and NOx and 1.0

gm/mi or 15 percent increase on CO for comparative emissions test data.        The

Air Resources Board did not conduct confirmatory testing to validate the
emissions data submitted by Auto Tech Products.

          Auto Tech Products has submitted all the required information and has

fulfilled the requirements for an exemption.
                                            «g—



Document Created: 2005-09-01 12:41:36
Document Modified: 2005-09-01 12:41:36

| Previous E.O. D-371 | Next E.O. D-372-1 | Next E.O. D-373