Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 25, 2000.
As of Thursday, January 2nd, 2025 this Executive Order has not been overturned or superceeded.

Approved Parts

ModelsModification
1999 to 2001 GM V8 trucks, 1994 to 1997 Ford 4.6L passenger cars, 1996 to 2001 4.6L Mustang, and 1997 to 2001 4.6/5.4L trucks. Vehicles certified to Ultra Low Emission Vehicle (ULEV) or lower emission standards are excluded.The General Motors 4.8, 5.3, 6.0L Supercharger Kits includes the following main components: Eaton supercharger, intake manifold plenum, new fuel injectors (GM part number 17124531), new ECM calibration, and a throttle body adapter. The throttle body is moved to the supercharger inlet. The EGR valve is relocated onto the inlet duct between the throttle body and the supercharger inorder to preserve stock EGR function. All other emission-related components are in the stock location relative to the throttle body. The following are the supercharger pulley specifications: The 4.8L engine uses a 3.4" diameter pulley, the 5.3L engine uses a 3.3" diameter pulley, and the 6.0L engine uses a 3.2" diameter pulley. Maximum boost is limited to 5 psi. The General Motors 5.7L Supercharger Kits includes the following main components: Eaton supercharger with a 3.0" pulley, intake manifold plenum, throttle body adapter and FCC1 frequency calibrator. The throttle body is moved to the supercharger inlet. All other emission-related components are in the stock location. Maximum boost is limited to 6 psi. The Ford Supercharger Kits includes the following main components: Eaton supercharger, intake manifold plenum, intake manifold runners, intercooler, throttle body adapter, electric water pump, high flow fuel pump, and fuel pressure regulator. The EGR valve is relocated between the throttle body and the supercharger intake. All other emission-related components are in the stock location. The following are the supercharger pulley specifications: 4.6L engine uses a 2.94" diameter pulley, and the 5.4L engine uses a 2.4" diameter pulley. Maximum boost is limited to 6 psi.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-488-3
  • Executive Order 488-3 / D488-3
  • ARB # D-488-3
  • Executive Order No: D-488-3
  • C.A.R.B. No. D-488-3
  • Resolution D-488-3
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-488-3 PDF

D-488-3 Document:

CARB_D-488-3

(Page 1 of 4) State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—488—3 Relating to Exemptions Under Section 27156 of the Vehicle Code MAGNA CHARGER CORPORATION SUPERCHARGER KITS Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and ' Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of .the Health and Safety Code and Executive Order G—45—9; IT IS ORDERED AND RESOLVED: That the installation of the Supercharger Kits manufactured and marketed by Magna Charger Corporation of 3172 Bunsen Avenue, Unit D, Ventura, California 93003 has been found not to reduce the effectiveness of required motor vehicle pollution control devices and, therefore, is exempt from the prohibitions of Section 27156 of the California Vehicle Code for the following vehicle applications, excluding any vehicle certified to Ultra Low Emission Vehicle (ULEV) or lower emission standards: General Motors Model—Year Displacement Appliéations 1999—2001 4.8, 5.3, 6.0L Trucks 1999—2001 5.7L Trucks Ford 1994/1995 4.6L Full Size Passenger Cars 1994—1997 4.6L Thunderbird & . Cougar 1996—2001 4.6L Mustang 1997—2001 4.6/5.4L Trucks The General Motors 4.8, 5.3, 6.0L Supercharger Kits includes the following main components: Eaton supercharger, intake manifold plenum, new fuel injectors (GM part number 17124531), new ECM calibration, and a throttle body adapter. The throttle body is moved to the supercharger inlet. The EGR valve is relocated onto the inlet duct between the throttle body and the supercharger inorder to preserve stock EGR function. All other emission—related components are in the stock location relative to the throttle body. The following are the supercharger pulley specifications: The 4.8L engine uses a 3.4" diameter pulley, the 5.3L engine uses a 3.3" diameter pulley, and the 6.0L engine uses a 3.2" diameter pulley. Maximum boost is limited to 5 psi.

MAGNA CHARGER CORPORATION _ EXECUTIVE ORDER D—488—3 SUPERCHARGER KWITS (Page 2 of 4) The General Motors 5.7L Supercharger Kits includes the following main components: Eaton supercharger with a 3.0" pulley, intake manifold plenum, throttle body adapter and FCC1 frequency calibrator. The throttle body is moved to the supercharger inlet. All other emission— related components are in the stock location. Maximum boost is limited to 6 psi. The Ford Supercharger Kits includes the following main components: Eaton supercharger, intake manifold plenum, intake manifold runners, intercooler, throttle body adapter, electric water pump, high flow fuel pump, and fuel pressure regulator. The EGR valve is relocated between the throttle body and the supercharger intake. All other emission—related components are in the stock location. The following are the supercharger pulley specifications: 4.6L engine uses a 2.94" diameter pulley, and the 5.4L engine uses a 2.4" diameter pulley. Maximum boost is limited to 6 psi. This Executive Order shall not apply to any Magna Charger Supercharger Kits advertised, . offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer to an ultimate purchaser. This Executive Order is valid provided that the installation instructions for the supercharger will not recommend tuning the vehicle to specifications different from those of the vehicle manufacturer. Changes made to the design or operating conditions of the device, as exempted by the Air Resources Board (ARB), that adversely affect the performance of a vehicle‘s pollution control system shall invalidate this Executive Order. Marketing of this device using any identification other than that shown in this Executive Order or marketing of this device for an application other than those listed in this Executive Order shail be prohibited unless prior approval is obtained from the ARB. This Executive Order does not constitute any opinion as to the effect that the use of this device may have on any warranty either expressed or implied by the vehicle manufacturer. This exemption is issued based on submitted emissions test data from an independent laboratory which showed that the supercharger kit did not adversely affect exhaust emissions of the tested vehicle. The test results are shown below. Independent Laboratory Test Results 1999 5.3L GMC 1500 Truck, LEV Cert, NMOG CO NOX HCHO Device (g/mi) with dfs applied 0.077 1.7 0.2 0.001 Standard (g/mi) 0.1860 4.4 0.4 0.018

MAGNA CHARGER CORPORATION EXECUTIVE ORDER D—488—3 SUPERCHARGER Kits (Page 3 of 4) 1999 5.7L GMC Yukon 1500, LEV Cart. NMOG CO NOX HCHO Device (g/mi) with df‘s applied 0.100 2.1 0.2 0.001 Standard (g/mi) 0.160 44 0.4 0.018 1998 5.4L Ford Expedition, LEV Cert. * NMOG CO NOX HCHO Device (g/mi) with df‘s applied 0.113 3.2 0.1 0.001 Standard (g/mi) 0.195 5.0 0.6 0.022 Test results showed that the supercharger kit when installed on the vehicles did not cause tailpipe emissions to exceed the applicable emission standards during the Cold Start CVS—75 Federal Test Procedure. This Executive Order is also based on the On—Board Diagnostic II (OBD I1) testing conducted on the same test vehicles. Test data showed that the supercharger . kit when installed on the vehicle did not affect the vehicle‘s ability to perform its OBD 11 monitoring. However, the ARB finds that reasonable grounds exist to believe that use of the Magna Charger Corporation‘s Supercharger Kits may adversely affect emissions of motor vehicles when operating under conditions outside the parameters of the previously prescribed test procedures. Accordingly, the ARB reserves the right to conduct additional emission tests, in the future, as such tests are developed, that will more adequately measure emissions from all cycle phases. If such test results demonstrate that the supercharger kit adversely affects emissions during off—cycle conditions (defined as those conditions which are beyond the parameters of the Cold—Start CVS—75 Federal Test Procedure), this Executive Order shall be effectively rescinded as of the date the test results are validated. Further, if such test results or other evidence provides the ARB with reason to suspect that the supercharger kit will affect durability of the emission control systems, Magna Charger Corporation shall be required to submit durability data to show that the durability of the vehicle emission control system is not, in fact, affected and/or that the add—on modified part demonstrates adequate durability. In addition to the foregoing, the ARB reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add—on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222, et seq. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF MAGNA CHARGER CORPORATION‘S GENERAL MOTORS 5.3L SUPERCHARGER KIT. No claims of any kind, such as "Approved by the Air Resources Board" may be made with respect to the action taken herein in any advertising or other oral or written communication.

MAGNA CHARGER CORPORATION EXECUTIVE ORDER D—488—3 SUPERCHARGER KIits (Page 4 of 4) L oc Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after ten day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination after hearing that grounds for revocation exist. 'Executive Orders D—488, dated October 1999, D—488—1, dated February 1999, and D—488—2, dated May 2000 are superseded and of no further force and effect. Executed at El Monte, California, this flé’ day of September 2000 R. B. Summerfield, Chief Mobile Source Operations Division


Document Created: 2005-09-01 12:42:31
Document Modified: 2005-09-01 12:42:31

Previous E.O. D-488-2 | Previous E.O. D-487 | Next E.O. D-488-4 | Next E.O. D-489