Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on November 30, 1992.
As of Monday, October 21st, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

ModelsRemarks
1993 and older model-year diesel-powered vehiclesAs of 5/2/2006, the U.S. EPA cancelled National Fuelsaver Corp.ÔÇÖs fuel additive registration for the Platinum Gasaver/Platinum Vapor Injector. Use of this device will be considered a violation of federal laws. Additional information is available at: http://epa.gov/EPA-AIR/2006/May/Day-02/

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-134-3
  • Executive Order 134-3 / D134-3
  • ARB # D-134-3
  • Executive Order No: D-134-3
  • C.A.R.B. No. D-134-3
  • Resolution D-134-3
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-134-3 PDF

D-134-3 Document:

CARB_D-134-3

(Page 1 of 3) State of California Air Resources Board EXECUTIVE ORDER D—134—3 Relating to Exemptions Under Section 27156 of the Vehicle Code NATIONAL FUELSAVER CORPORATION PLATINUM VAPOR INJECTION wWHEREAS, Vehicle Code Section 27156 and Title 13 California Code of modified parts from the prohibitions of Vehicle Code Section 27156. WHEREAS, National Fuelsaver Corporation has applied to the ARB for exemption from the prohibitions of Vehicle Code Section 27156 for the Platinum Vapor Injection. wWHEREAS, pursuant to the authority vested in the Executive Officer by Health and Safety Code Section 39515 and in the Chief, Mobile Source Division by Health and Safety Code Section 39516 and Executive Order G—45—5, the ARB finads: Platinum Vaper Injection is an add—f>n injects vapzr inzc the intftake menifold of a mofrorsr P —® _The Platinum Vapor Injection is intended for use with & required pollution control system. [emnn. The Platinum Vapor Injection by being installed in the engine alters the original design of a motor vehicle pollution control system. The Platinum Vapor Injection is a device subiject to the prohibitions of Vehicle Code Section 27156 arni an add—on part as defined by 13 CCR Section 1900(b)(1). The Platinum Vapor Injection does not reduce the ef rectiveness Of any required motor vehicle pollution control device basis on which the Platinum Vapor Injection wi decrease in emission or an increase in fuel s: It has not been determined what effect use cf the Platinum Vapor Injection may have on any warranty, either expressed or implied, by the manufacturer of a motor vehicle on which the device is installed.

NATIONAL FUELSAVER CORPORATION . EXECUTIVE ORDER D—134—3 PLATINUM VAPOR INJECTION (Page 2 of 3) 8. The Platinum Vapor Injection is not a certified motor vehicle pollution control device pursuant to Health and Safety Code Section 43644. 9. The ARB by granting an exemption to National Fuelsaver Corporation for the Platinum Vapor Injection does not recommend or endorse in any way the Platinum Vapor Injection for emissions reduction, fuel economy, or any other purpose. IT IS HEREBY RESOLVED that the Platinum Vapor Injection is exempt from the; T prohibitions of Vehicle Code Section 27156 for installation on 1993 and earlier model—year diesel—powered vehicles subject to the following conditions: 1. This exemption shall not apply to any device, apparatus, or mechanism advertised, offered for sale or sold with, or installed on, a motor vehicle prior to or concurrent with transfer to an ultimate purchaser. 2. No changes are permitted to the device as described in the application for exemption. Any changes to the device, applicable model year, or other factors addressed in this order must be evaluated and approved by the ANZ prior to marketing in alifornie. 3. Marketing of this device using an identification other than that shown in this Executive Order or marketing of this device for an application other than those listed in Executive Order shall be 20t prohibited unless prior approval is obtained from the ARB. Exemption of this product shall not be construed as an exemption to sell, offer for sale, or advertise any component of the product as an individual device. 4. Any oral or written references to this Executive Order or its content by the National Fuelsaver Corporation, its principals, agents, employees, distributors, dealers, or other representatives must include the disclaimer that the Executive Grder or the exemption it provides is not an endorsement or approval of any fuel economy or emissions reduction claims for the Platinum Vapor Injection and is conly a finding that the device is exempt from the prohibitions of Vehicle Code Section 27156. 5. No claim of any kind, such as "Approved by the Air Resources Board" may be made with respect to the action taken herein in any advertising or other oral or written communication.

NATIONAL FUELSAVER CORPORATION _ EXECUTIVE ORDER D—134—3 PLATINUM VAPOR INJECTION (Page 3 of 3) Viocolation of any of the above cond itions shall be grounds for revocati this order. The order may be revoked only afte on of r a ten—day written notice of intention to revoke the order, in which period the hslider of the request in writing a hearing to cont order may est the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of request and the order may not be the revoked until a determination afte that grounds for revocation exis r hear ing t. Executive Order D~189, dated April 18, 1989, is of no further force or effect. * > Executed at El Monte, California, this 5{2 day of November, 1992. R. B/ Summerfierd Assistant Divisiozs Chief Mobile Source Division


Document Created: 2005-09-01 12:43:48
Document Modified: 2005-09-01 12:43:48

Previous E.O. D-134-2 | Previous E.O. D-133 | Next E.O. D-134-4 | Next E.O. D-135