Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on March 27, 2002.
As of Tuesday, September 10th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
49305, 493061998 1/2 to 1999 applicable trucks with the Cummins 5.9L ISB/ISC turbo-dieselThe Git Kit for Dodge Cummins ISB Pickup includes a large diaphragm replacement wastegate actuator, and a fuel calibration module.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-161-66
  • Executive Order 161-66 / D161-66
  • ARB # D-161-66
  • Executive Order No: D-161-66
  • C.A.R.B. No. D-161-66
  • Resolution D-161-66
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-161-66 PDF

D-161-66 Document:


CARB_D-161-66

                                           State of California
                                     AIR RESOURCES BOARD

                                    EXECUTIVE ORDER D—161—66

                            Relating to Exemptions Under Section 27156
                                         of the Vehicle Code

                                    / Gale Banks Engineering.
                            Git, Stinger, StingerPlus and PowerPack Kits


Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle
Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the
Health and Safety Code and Executive Order G—45—9;

IT IS ORDERED AND RESOLVED: That the installation of the Git, Stinger, StingerPlus and
PowerPack kits, manufactured and marketed by Gale Banks Engineering, 546 Duggan Avenue,
Azusa, California 91702 has been found not to reduce the effectiveness of the applicable
vehicle pollution control system and, therefore, is exempt from the prohibitions of Section 27156
of the Vehicle Code for the following truck/motorhome applications equipped with the 5.9L
Cummins ISB/ISC turbo—diesel engine:

Dodge Cummins Pickup


Kit                                 Model—Year*                  Part No.
GIT                                 1998 i                       49305
                                    1999                         49306
                                    1994—98                      46381
Stinger (std. cab)                  1998 1/                      49310
                 ‘                  1999                         49311
Stinger (ext. cab)                  1998 1                       49312
                                    1999                         49313
Stinger—Plus (std. cab) °           1999                         49320
Stinger—Plus {ext. cab)             1999                         49321
PowerPack (std. cab)                1999                         49330
PowerPack (ext. cab)            —   1999                         49331

Cummins ISB/ISC Powered Class A Motorhomes and Medium Duty Trucks


Kit                                 Model—Year*                   Part No.
[SB   Stinger                       1997   —   1999               49242
1SB   PowerPack                     1997   —   1999               49255
1SC   Stinger                       1997   —   1999               49292
ISC   PowerPack                     1997   —   1999               49293

* Excluded from this Executive Order are vehicles equipped with 1999 model—year
Cummins engine families, XCEXHO359BA1, XCEXHO359BAJ, and XCEXHO359BAK, which
have been certified to the EURO III emission standards under the Settlement Agreement.


                                                   2.


  The Git Kit for Dodge Cummins Pickup includes a large diaphragm replacement wastegate
  actuator, and a fuel calibration module or fuel calibration plate for earlier models.

  The Stinger Kit for Dodge Cummins ISB Pickup includes a low restriction air filter element,
  large diaphragm replacement actuator, mandrel bent turbine outlet pipe, intermediate pipe,
  extension pipe (where necessary), mulffler, tailpipe, and fuel calibration module.

_ The Stinger—Plus Kit for Dodge Cummins ISB Pickup includes a low restriction air filter
  element, replacement turbine housing with large diaphragm actuator, mandrel bent turbine
  outlet pipe, intermediate pipe, extension pipe (where necessary), muffler, tailpipe andfuel
  calibration module.

  The PowerPack Kit for Dodge Cummins ISB Pickup includes a low restriction air filter
  element, replacement inlet casting, replacement turbine housing with large diaphragm actuator,
  mandrel bent turbine outlet pipe, intermediate pipe, extension pipe (where necessary), muffler,
  tailpipe and fuel calibration module.

  The Stinger for class A motorhomes includes a replacement turbine housing with large
  diaphragm actuator and fuel calibration module.

  The PowerPack for class A motorhomes includes a replacement turbine housing with large
  diaphragm actuator, replacement inlet casting and a fuel calibration module.

  The fuel calibration module on all kits is an add on device that is designed to increase
  fuel pressure during boost conditions. It is installed between the electronic fuel pump
  and the MAP sensor.

  This Executive Order shall not apply to any Gale Banks Engineering‘s Git, Stinger, StingerPlus
  and PowerPack Kits advertised, offered for sale, sold with, or installed on a motor vehicle prior
  to or concurrent with transfer to an ultimate purchaser.

  This Executive Order is valid provided that the installation instructions for the Git, Stinger,
  StingerPlus and PowerPack Kits will not recommend tuning the vehicle to specifications
  different from those of the vehicle manufacturer.

  Changes made to the design or operating conditions of the Git, Stinger, StingerPlus and
  PowerPack Kits, as exempt by the Air Resources Board, which adversely affect the
  performance of the vehicle‘s pollution control system shall invalidate this Executive Order.

  Marketing of the Git, Stinger, StingerPlus and PowerPack Kits using any identification other
  than that shown in this Executive Order or marketing of the Git, Stinger, StingerPlus and
  PowerPack Kits for an application other than those listed in this Executive Order shall be
  prohibited unless prior approval is obtained from the Air Resources Board. Exemption of the
  Git, Stinger, StingerPlus and PowerPack Kits shall not be construed as exemption to sell, offer
  for sale, or advertise any component of the kit as an individual device.


        GALE BANKS—GIT, STINGER, STINGERPLUS AND POWERPACK KITS—D—161—66


                                                   —3—


 This Executive Order does not constitute any opinion as to the effect the use of the Git, Stinger,
 StingerPlus and PowerPack Kits may have on any warranty either expressed or implied by the
 vehicle manufacturer.

 This Executive Order is granted based on emissions test data which showed that the worst case
 kit, PowerPack, did not adversely affect tailpipe emissions during comparative Cold Start 505
 Federal Test Procedure. 1999:—Dodge Ram 2500 was used as the test vehicle.

                      HC      CO    NOX      PARTICULATES          Opacity
 Stock                0.17    1.0   9.0       0108                ————————————
 PowerPack            0.06    1.5   9.8       0.062               4.7% avg.
 Difference _        —O0.11   0.5   0.8       —0.046
 % Change            —65%     50%   8.8%       —43%

 Test results showed that tailpipe emissions during comparative Cold Start 505 Federal Test
 Procedure with the PowerPack installed on the vehicle did not cause exhaust emissions to
 exceed the baseline emissions by more than the allowed limits of 10 percent or 0.1 grams per
 mile on hydrocarbon (HC) and oxides of nitrogen (NOx), 15 percent or 1.0 grams per mile carbon
 monoxide (CO), and 15 percent or 0.03 grams per mile on particulates as specified in the
 "Procedures for Exemption of Add—On and Modified Parts".

 This Executive Order is also based on an On Board Diagnostic l1 (OBD II) testing conducted on
 the same vehicle. Test data showed that the PowerPack when installed on the vehicle did not
 affect the vehicle‘s ability to perform its OBD I! monitoring.

 In addition to the foregoing, the ARB reserves the right in the future to review this Executive
 Order and the exemption provided herein to assure that the exempted add—on or modified part
 continues to meet the standards and procedures of Title 13, California Code of Regulations,
 Section 2222, et seq.

 THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
 APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD
 OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY
 ALLEGED BENEFITS OF GALE BANKS ENGINEERING‘S GIT, STINGER, STINGERPLUS
 AND POWERPACK KITS.

 No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect
 to the action taken herein in any advertising or other oral or written communication.

 Violation of any of the above conditions shall be grounds for revocation of this order. The order
 may be revoked only after a ten—day written notice of intention to revoke the order, in which
~ period the holder of the order may request in writing a hearing to contest the proposed
 revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and
 the order may not be revoked until a determination is made after the hearing that grounds for
 revocation exist.


        GALE BANKS—GIT, STINGER, STINGERPLUS AND POWERPACK KITS—D—161—66


                                              ~4—


Executive :()fder D—161—60, dated September 2000, is superseded and of no further force and
effect. .

Executed at El_Monte, California, this ZZ’E day of March 2002.

                                 *




                                 Allen Lyons, Chief
                                 New Vehicle/Engine Programs Branch




      GALE BANKS—GIT, STINGER, STINGERPLUS AND POWERPACK KITS—D—161—66


                                       AFTERMARKET PARTS SECTION
                         VC Sections 27156 and 38391 Exemption Update Check—Out List

For each exemption update request, the project engineer is to complete this "check—out" list to make sure that
there are no changes in the applicable vehicles and device design.

ENERAL INFORMATION:
 1. Date application received:                             12/10/01
 2. Name of Applicant:                                     Jeremy Negen

 3. Address of Applicant:                                  546 S. Duggan Ave.
                                                           Azusa, CA 91702
 4 . _Applicant Phone:                                     626—969—9600
 5 . Name of Manufacturer:                                 Gale Banks Engineering

 6. Manufacturer‘s Phone:                                  same
 7. Address of Manufacturer:                               same
 8. Nameof Device:                                         Git, Stinger, StingerPlus and PowerPack Kits

 9. Latest EO and Date:                                    D—161—60, 9/00              |
 10. Device Testing:                                       manufacturer
 11. Vehicle application covered by existing EO‘s:         1997—1999 Dodge trucks and medium or heavy duty
                                                           trucks with the 5.9L Cummins turbo diesel

 12. Vehicle application now requested:                    same
 13. Pollution Control systems on previous                 OEM
 vehicle(s):

 14. Pollution control systems on present vehicle(s):      OEM
 15. Is present vehicle/engine a carryover from            N/A
 previous vehicle/engine?
 16. List design changes in device:                        Same theory of operation and design

 17. Will changes affect emissions?                         No

 18. Special reason to update besides inclusion of         Add Git Kit P/N 46381
 newer vehicle model:

 19. Are legal issues involved? If so, has ARB legal        No
 been consulted?

 20. EO number issued:                                      D—161—66
 21. Bases for issuance of an EO:                           Kit # 46381 is similar to the other exempted Git kits.
                                                            The theory of design and operation principles have
                                                            not changed.



Document Created: 2005-09-01 12:40:45
Document Modified: 2005-09-01 12:40:45

Previous E.O. D-161-65 | Previous E.O. D-160 | Next E.O. D-161-67 | Next E.O. D-162