Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on February 18, 2015.
As of Sunday, December 22nd, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part Number
see pdf

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-176-43
  • Executive Order 176-43 / D176-43
  • ARB # D-176-43
  • Executive Order No: D-176-43
  • C.A.R.B. No. D-176-43
  • Resolution D-176-43
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-176-43 PDF

D-176-43 Document:


CARB_D-176-43

                                    State of California
                                AIR RESOURCES BOARD

                              EXECUTIVE ORDER D-176-43

                       Relating to Exemptions Under Section 27156
                                  of the California Vehicle Code

                                    Dinan Corporation
                             High Flow Cold Air Intake System

Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516
of the Health and Safety Code and Executive Order G-14-012;

IT IS ORDERED AND RESOLVED: That the installation of the High Flow Cold Air Intake
System, produced and marketed by Dinan Corporation of 865 Jarvis Drive, Morgan Hill,
California 95037, has been found not to reduce the effectiveness of the applicable vehicle
pollution control systems and , therefore, is exempt from the prohibitions of Section 27156
of the Vehicle Code for the following 2006 to 2013 model year BMW vehicles.

Part No.    Engine Displacement           Model Year            Model
D760-0020        5.0L                     2006 to 2010           M5
D760-0021        5.0L                     2006 to 2010           M6 and M6 Convertible
D760-9000*       3.0L                        2006                325i, 325xi, 330i, 330xi
D760-9000*       3.0L                     2007 to 2011           328i/328xi (sedan/wagon)
D760-9001 *      3.0L                     2007 to 2013           328i/328xi (coupe)

*Excluding the following engine test groups certified to Low Emission Vehicle II
Super Ultra Low Emission Vehicle emission standard: 7BMXV03.0N51,
8BMXV03.0N51, 9BMXV03.0N51, ABMXV03.051 R, BBMXV03.051 R, CBMXV03.051 R,
and DBMXV03.051 R.

The High Flow Cold Air Intake System is a modification made to the stock air filter
housing bottom (dirty air side) . A hole is cut and tubing is attached to capture cold air
from the bottom of the vehicle. No changes are made to the stock air flow meter or
housing lid .

This Executive Order is valid provided that the installation instructions for the High Flow
Cold Air Intake System will not recommend tuning the vehicle to specifications different
from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the High Flow Cold Air Intake
System , as exempt by the Air Resources Board , which adversely affect the performance
of the vehicle's pollution control system shall invalidate this Executive Order.


                                              -2-


Marketing of the High Flow Cold Air Intake System using any identification other than that
shown in this Executive Order or marketing of the High Flow Cold Ai r Intake System for
an application other than those listed in this Executive Order shall be prohibited unless
prior approval is obtained from the Air Resources Board .

This Executive Order does not constitute any opinion as.to the effect the use of the High
Flow Cold Air Intake System units may have on any warranty either expressed or implied
by the veh icle manufacturer.

This Executive Order is granted based on a prior Executive Order for Dinan Corporation
(D-176-32) which exempted the High Flow Cold Air Intake System on BMW vehicles
certified to the Low Emission Vehicle II Ultra Low Emission Vehicle
(LEV II ULEV) emission standards. Similar effect on vehicle emissions is expected with
the installation of the High Flow Cold Air Intake. on vehicles listed in this Executive Order.

The Air Resources Board reserves the right in the future to review this Executive Order
and the exemption provided herein to assure that the exempted add-on or modified part
continues to meet the standards and procedures of Title 13, California Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI-POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF DINAN
CORPORATION'S HIGH FLOW COLD AIR INTAKE SYSTEM .

No claim of any kind , such as "Approved by the Air Resources Board", may be made with
respect to the action taken herein in any advertising or other oral or written
communication .

Violation of any of the above co'nditions shall be grounds for revocation of this order. The
order may be revoked only after a ten-day written notice of intention to revoke the order,
in which period the holder of the order may request in writing a hearing to contest the
proposed revocation . If a hearing is requested , it shall be held with in ten days of receipt
of the request and the order may not be revoked until a determination is made after the
hearing that grounds for revocation exist.

Executed at El Monte, California , this      [8      day of February 2015.




        Annette Hebert, Chief
        Emissions Compliance, Automotive Regulations and Science Division



    DINAN CORPORATION- HIGH FLOW COLD AIR INTAKE SYSTEM- D-176-43



Document Created: 2015-02-23 16:52:58
Document Modified: 2015-02-23 16:52:58

Previous E.O. D-176-42 | Previous E.O. D-175 | Next E.O. D-176-44 | Next E.O. D-177