Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on August 15, 2005.
As of Friday, October 4th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
210511999 through 2006 model year General Motors trucks equipped with a 4.8, 5.3, or 6.0L engine, excluding 2006 model year vansThe Cold-Air Induction Package, Part Number 21051, consists of a high flow conical air filter, a heavy-duty composite air box assembly, and a large diameter composite intake tubing.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-187-17
  • Executive Order 187-17 / D187-17
  • ARB # D-187-17
  • Executive Order No: D-187-17
  • C.A.R.B. No. D-187-17
  • Resolution D-187-17
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-187-17 PDF

D-187-17 Document:

CARB_D-187-17

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—187—17 Relating to Exemptions Under Section 27156 of the California Vehicle Code SLP Performance Parts, Inc. Cold—Air Induction Package, Part Number 21051 Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and Safety Code and Executive Order G—02—003; IT IS ORDERED AND RESOLVED: That the installation of the Cold—Air Induction Package, Part Number 21051, manufactured and marketed by SLP Performance Parts, Inc., 1501 Industrial Way North Toms River, New Jersey 08755, has been found not to reduce the effectiveness of the applicable vehicle pollution control systems and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for 1999 through 2006 model year General Motors trucks equipped with a 4.8, 5.3, or 6.0L engine, excluding 2006 model year vans. The Cold—Air Induction Package, Part Number 21051, consists of a high flow conical air filter, a heavy—duty composite air box assembly, and a large diameter composite intake tubing. This Executive Order is valid provided that the instaliation instructions for the Cold—Air Induction Package will not recommend tuning the vehicle to specifications different from those submitted by the device manufacturer. Changes made to the design or operating conditions of the Cold—Air Induction Package, as exempt by the Air Resources Board, which adversely affect the performance of the vehicle‘s pollution control system shall invalidate this Executive Order. This Executive Order shall not apply to any Cold—Air Induction Package advertised, offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer to an ultimate purchaser. Marketing of the Cold—Air Induction Package using any identification other than that shown in this Executive Order or marketing of the Cold—Air Induction Package for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. This Executive Order does not constitute any opinion as to the effect the use of the Cold—Air Induction Package may have on any warranty either expressed or implied by the vehicle manufacturer.

«2. This Executive Order is granted based on emission test results in the modified configuration using the Cold—Start CVS—75 Federal Test Procedure (FTP), Supplemental Federal Test Procedure (SFTP USO08), and an examination of the On—Board Diagnostic II (OBD !I) system. A 2004 model year Chevrolet €1500 with a 5.3 liter engine (4GMXTO6.0187, LEV 1 SULEV) was used for the evaluation of the Cold—Air Induction Package. Results from emissions testing conducted at Automobile Club of Southern California, Diamond Bar, California, are shown below {in grams per mile with deterioration factors applied): CVS—75 USO6 NMOG CO NOx HCKHO NMHC+NOx CO Standards 50k 0.125 3.4 0.14 0.015 0.40 10.5 With Device 0.065 11 0.05 0.001 0.04 0.4 The emission test results in the modified configuration were below the applicable emission standards. Examination of the OBD II system showed the Cold—Air Induction Package does not affect OBD 11 system operation. The Air Resources Board reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add—on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222, et seq. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESQURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE COLD—AIR INDUCTION PACKAGE. No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action taken herein in any advertising or other oral or written communication. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. 185#— day of August 2005 Executed at El Monte, California, this _——fL2___— — feursre en Lyons, Chief Mobile Source Operations Division SLP PERFORMANCE PARTS, INC. — COLD—AIR INDUCTION PACKAGE — D—187—17


Document Created: 2005-11-18 11:46:58
Document Modified: 2005-11-18 11:46:58

Previous E.O. D-187-16 | Previous E.O. D-186 | Next E.O. D-187-18 | Next E.O. D-188