Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 4, 1997.
As of Wednesday, January 15th, 2025 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
220141995-1997 Camaro/ Firebird equipped with LT-1 5.7L gasoline engines

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-187-6
  • Executive Order 187-6 / D187-6
  • ARB # D-187-6
  • Executive Order No: D-187-6
  • C.A.R.B. No. D-187-6
  • Resolution D-187-6
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-187-6 PDF

D-187-6 Document:


CARB_D-187-6

                                                                                     (Page 1 of 2)

                                                    State of California
                                              AIR RESOURCES BOARD

                                           EXECUTIVE ORDER D—187—6
                                     Relating to Exemptions Under Section 27156
                                                  of the Vehicle Code

                                              SLP ENGINEERING, INC.
                                              52MM THROTTLE BODY

Pursuant to the authorigy vested in the Air Resources Board by Section 27156 of the Vehicle Code; and

Pursuant to the authority vested in the undersigned by Sections 39515 and 39516 of the Health and Safety
Code and Executive Order G—45—9;

IT IS ORDERED AND RESOLVED: That the installation of the 52MM Throttle Body, P/N 22014,
manufactured by SLP Engineering, Inc. of 1501 Industrial Way North, Toms River, NewJersey 08755, has
been found not to reduce the effectiveness of the applicable vehicle pollution control system and, therefore, is
exempt from the prohibitions of Section 27156 of the Vehicle Code for all 1995—97 Camaro/Firebird vehicles
equipped with the LT—1 5.7 liter gasoline engine.

The 52MM Throttle Body is a direct replacement to the stock General Motors 48MM throttle body that was
originally equipped with the above mentioned vehicles. The new throttle body also includes a new throttle
position sensor and idle air control valve, and bolts to all the stock General Motors components with no
modifications required.

This Executive Order is valid provided that installation instructions for this kit will not recommend tuning the
vehicles to specifications different from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the devices, as exempt by the Air Resources Board,
which adversely affect the performance of a vehicle‘s pollution control system shall invalidate this Executive
Order.

Marketing of this device using any identification other than that shown in this Executive Order or marketing
of this device for an application other than those listed in this Executive Order shall be prohibited unless prior
approval is obtained from the Air Resources Board.

This Executive Order does not constitute any opinion as to the effect the use of the device may have on any
warranty either expressed or implied by the vehicles manufacturer.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF
CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED
BENEFITS OF SLP ENGINEERING, INC.‘S 52MM THROTTLE BODY .

No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the
action taken herein in any advertising or other oral or written communication.


SLP Engineering, Inc.                                                                Executive Order D—187—6
52MM Throttle Body                                                                   (Page 2 of 2)




Violation of any of the above conditions shall be grounds for revocation of this order. The order may be
revoked only after ten day written notice of intention to revoke the order, in which period the holder of the
order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be
held within ten days of receipt of the request and the order may not be revoked until a determination after
hearing that grounds for revocation exist.

Executed at El Monte, California, this    E _ day of September 1997.



Document Created: 2005-09-01 12:42:11
Document Modified: 2005-09-01 12:42:11

Previous E.O. D-187-5 | Previous E.O. D-186 | Next E.O. D-187-7 | Next E.O. D-188