Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on April 18, 1995.
As of Tuesday, June 25th, 2019 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
38441994-1995 fuel injected Ford/ Lincoln/ Mercury vehicles with 5.0L engine and 65 mm throttle body

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-215-18
  • Executive Order 215-18 / D215-18
  • ARB # D-215-18
  • Executive Order No: D-215-18
  • C.A.R.B. No. D-215-18
  • Resolution D-215-18
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-215-18 PDF

D-215-18 Document:



                                                     (Page 1 of 2)

                               State of California
                               AIR RESOURCES BOARD

                           EXECUTIVE ORDER D—215—18
                  Relating to Exemptions Under Section 27156
                             of the Vehicle Code

                              EDELBROCK CORPORATION
                           THROTTLE BODIES & EGR PLATES

Pursuant to the authority vested in the Air Resources Board by Section 27156
of the Vehicle Code; and

Pursuant to the authority vested in the undersigned by Sections 39515 and
39516 of the Health and Safety Code and Executive Order G—45—5;

IT IS ORDERED AND RESOLVED: That the installation of the Throttle Bodies &
EGR Plates manufactured by BBK Performance, Inc. of 2451 Pomona Rincon,
Corona, California 91720 and marketed by the Edelbrock Corporation of 2700
California Street, Torrance, California 90509—2936 has been found not to
reduce the effectiveness of the applicable vehicle poliution control system
and, therefore, is exempt from the prohibitions of Section 27156 of the
Vehicle Code for the following fuel injected Ford, Lincoln, and Mercury
vehicle applications:

           Passenger Cars — 5.0L 1994 & 1995 Model Year

           65 mm throttle body, part no. 3844
    G NJ




           70 mm throttle body, part no. 3845
           75 mm throttle body, part no. 3846

           EGR plate, part no. 3835 must be used with part nos. 3844, 3845,
           and 3846 throttle bodies, except for OEM intake manifold
           applications .


           Passenger Cars / Irucks — 5.0L 1993 and older

     1.    65 mm throttle body, part no. 3824 &
           65 mm EGR plate, part no. 3827

     2.    70 mm throttle body, part no. 3825 &
           70 mm EGR plate, part no. 3828

    3.     75 mm throttle body, part no. 3826 &
           75 mm EGR plate, part no. 3829


           TIrucks — 5.0 & 5.81 1987—95 Model Year

    1.     56 mm twin throttle body, part no. 3837
    2.     61 mm twin throttle body, part no. 3838


EDELBROCK CORPORATION                           EXECUTIVE ORDER D—215—18
                                                (Page 2 of 2)



Changes made to the design or operating conditions of the throttle bodies
and EGR plates, as exempt by the Air Resources Board, which adversely affect
the performance of a vehicle‘s pollution control system shall invalidate
this Executive Order.

Marketing of the throttle bodies and EGR plate using any identification
other than that shown in this Executive Order or marketing of the throttle
bodies and EGR plates for an application other than those listed in this
Executive Order shall be prohibited unless prior approval is obtained from
the Air Resources Board.

This Executive Order does not constitute any opinion as to the effect the
use of the throttle bodies and EGR plates may have on any warranty either
expressed or implied by the vehicle manufacturer.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF
CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED
BENEFITS OF THE EDELBROCK CORPORATION‘S THROTTLE BODIES AND EGR PLATE.

No claim of any kind, such as "Approved by the Air Resources Board" may be
made with respect to the action taken herein in any advertising or other
oral or written communication.

Violation of any of the above conditions shall be grounds for revocation of
this Executive Order. The order may be revoked only after ten day written
notice of intention to revoke the order, in which period the holder of the
order may request in writing a hearing to contest the proposed revocation.
If a hearing is requested, it shall be held within ten days of receipt of
the request and the order may not be revoked until a determination after
hearing that grounds for revocation exist.

Executed at El Monte, California, this




                                        . Summerfiel «4
                                      gistant Division Chief
                                    Mobile Source Division



Document Created: 2005-09-01 12:39:40
Document Modified: 2005-09-01 12:39:40

Previous E.O. D-215-17 | Previous E.O. D-214 | Next E.O. D-215-19 | Next E.O. D-216