Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on February 25, 1998.
As of Friday, May 24th, 2019 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
6065, 6075 6084, 6085 6086, 60871995 and older GM vehicles equipped with a 262-400 CID engine

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-215-33
  • Executive Order 215-33 / D215-33
  • ARB # D-215-33
  • Executive Order No: D-215-33
  • C.A.R.B. No. D-215-33
  • Resolution D-215-33
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-215-33 PDF

D-215-33 Document:



                                                                                 (Page 1 of 2)

                                              State of California
                                        AIR RESOURCES BOARD


                                     EXECUTIVE ORDER D—215—33
                               Relating to Exemptions Under Section 27156
                                            of the Vehicle Code


                                     EDELBROCK CORPORATION
                                 Performer Aluminum Cylinder Heads


 Pursuant to the authority vested in the Air Resources Board by Section 27156 ofthe Vehicle Code; and

 Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and
 Safety Code and Executive Order G—45—9;

 IT IS ORDERED AND RESOLVED: That the installation of the Performer Aluminum Cylinder Heads,
 manufactured and marketed by the Edelbrock Corporation, 2700 California Street, Torrance, California
 90509—2936 has been found not to reduce the effectiveness of the applicable vehicle pollution control
 system and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for the
 following vehicle applications:

. Vehicle Application               Engine Disp.(CID)               Model—Year             Part No.
 General Motors                        262—400                      1995 and older         6065, 6075,
                                                                                           6084, 6085,
                                                                                           6086, & 6087
                                       389—502                      1995 and older         6044, 6045,
                                                                                           6046, 6047,
                                                                                           6049, 6054,
                                                                                           6055, 6056*,
                                                                                           6057*, & 6058+*
 Ford                                  289, 302, & 351              1995 and older          6031, 6032,
                                                                                            6034 thru 6039
 * Vehicles without secondary air injection

 This Executive Order is valid provided that the installation instructions for the Performer Aluminum
 Cylinder Heads will not recommend tuning the vehicle to specifications different from those of the vehicle
 manufacturer.

 Changes made to the design or operating conditions of the Performer Aluminum Cylinder Heads, as
 exempt by the Air Resources Board, which adversely affect the performance of the vehicle‘s pollution
 control system shall invalidate this Executive Order.

 Marketing of the Performer Aluminum Cylinder Heads using any identification other than that shown in
 this Executive Order or marketing of the Performer Aluminum Cylinder Heads for an application other
 than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air
 Resources Board. Exemption of the Performer Aluminum Cylinder Heads shall not be construed as
 exemption to sell, offer for sale, or advertise any component of the kit as an individual device.


EDELBROCK                                                        Executive Order D—215—33
Performer Aluminum Cylinder Heads                                (Page 2 of 2)


This Executive Order does not constitute any opinion as to the effect the use of the Performer Aluminum
Cylinder Heads may have on any warranty either expressed or implied by the vehicle manufacturer.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF
ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY
ALLEGED BENEFITS OF THE EDELBROCK CORPORATION‘S PERFORMER ALUMINUM
CYLINDER HEADS.

No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the
action taken herein in any advertising or other oral or written communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The order may be
revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of
the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it
shall be held within ten days of receipt of the request and the order may not be revoked until a
determination after hearing that grounds for revocation exist.

Executive Order D—215—16, dated December 22, 1994, is superseded and of no further force and effect.

Executed at El Monte, California, this   3’5 da




                                   R. B. Shmmerfield,    Chief
                                   Mobile Source Operations Division



Document Created: 2005-09-01 12:45:53
Document Modified: 2005-09-01 12:45:53

Previous E.O. D-215-32 | Previous E.O. D-214 | Next E.O. D-215-34 | Next E.O. D-216