Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 24, 2002.
As of Thursday, December 26th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
19371995-2002 Chrysler Trucks, 4 cyl.The JBA Headers are a shorty style header, manufactured out of either 16 gage stainless steel or 14 gage mild steel. The headers bolt to the stock connecting pipes and retain the oxygen sensor in the stock location.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-216-24
  • Executive Order 216-24 / D216-24
  • ARB # D-216-24
  • Executive Order No: D-216-24
  • C.A.R.B. No. D-216-24
  • Resolution D-216-24
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-216-24 PDF

D-216-24 Document:

CARB_D-216-24

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—216—24 Relating to Exemptions Under Section 27156 of the Vehicle Code Automotive Engineered Products JBA Headers Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the underSIgned by Section 39515 and Section 39516 of the Health and Safety Code and Executive Order G—02—003; . IT IS ORDERED AND RESOLVED: That the installation of the JBA Headers, manufactured and marketed by the Automotive Engineered Products, 7149 Mission Gorge Road, San Diego, California 92120 has been found not to reduce the effectiveness of the applicable vehicle pollution control system and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for the gasoline vehicle applications listed, excluding all minivans and the following engine families which have been certified to the Supplemental Federal Test Procedure (SFTP) standards: 2001 and 2002 model—year Jeep Grand Cherokee, engine family 1CRXTO242240, 2CRXTO4.72D0, and 2CRXTO4.02D2, and 2002 model—year Jeep Liberty, engine family 2CRXTO3.72D0. Part No. Vehicle Application 1937 . 1995—2002 Chrysler Trucks, 4 cyl. 1938, 1939 1992—2002 Chrysler Trucks, 6 cyl. 1940, 1945 1992—2002 Chrysler Trucks, 5.2L, 5.9L 1947 1965—1991 Chrysler Trucks, 273—360 CID 1948 1965—1991 Chrysler Passenger Cars, 273—360 CID 1949 2000—2002 Chrysler Trucks, 4.7L 1950, 1955 1993—2002 Chrysler Trucks, 8.0L 1951, 1952 1993—2002 Chrysler Passenger Cars, 8.0L 1505 1993—2002 Jeep vehicles, 5.2L, 5.9L 1507 1999—2002 Jeep vehicles, 5.9L 1509 1999—2002 Jeep vehicles, 4.7L 1525 1987—1990 Jeep vehicles, 6 cyl. 1526 1991—1999 Jeep vehicles, 6 cyl. 1527 2000—2001 Jeep vehicles, 6 cyl. This Executive Order is valid provided that the installation instructions for the JBA Headers will not recommend tuning the vehicle to specifications different from those of the vehicle manufacturer. The JBA Headers are a shorty style header, manufactured out of either 16 gage stainless steel or 14 gage mild steel. The headers bolt to the stock connecting pipes and retain the oxygen sensor in the stock location.

This Executive Order shall not apply to any JBA Headers advertised, offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer to an ultimate purchaser. Marketing of the JBA Headers using any identification other than that shown in this Executive Order or marketing of the JBA Headers for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. Exemption of the JBA Headers shall not be construed as exemption to sell, offer for sale, or advertise any component of the kit as an individual device. This Executive Order does not constitute any opinion as to the effect the use of the JBA Headers may have on any warranty either expressed or implied by the vehicle manufacturer. This Executive Order is granted based on the following submitted emissions test data conducted on a 2002 4.7L Dodge Ram truck, certified to the Ultra Low Emission Vehicle (ULEV) emission standards. _ NMOG CO NOX HCHO Emission Standards 0.100 4.4 0.4 0.009 Device test 2 w/ dfs 0.075 1.4 0.3 0.001 Test results showed that tailpipe emissions with the JBA Header installed met the vehicle‘s applicable emission standards during a Cold Start CVS—75 Federal Test Procedure. This Executive Order is also based on an On Board Diagnostic II (OBD II) testing which showed that the headers when installed on the vehicle did not affect the vehicle‘s ability to perform its OBD II monitoring. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF AUTOMOTIVE ENGINEERED PRODUCTS, INC.‘S JBA HEADERS. No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action taken herein in any advertising or other oral or written communication. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. Executed at El Monte, California, this Zfi'fli day of September 2002. Allen{Yons, Chief Mobile Source Operations Division AUTOMOTIVE ENGINEERED PRODUCTS—JBA HEADERS—D—216—24 AFTERMARKET PARTS SECTION


Document Created: 2005-09-01 12:43:11
Document Modified: 2005-09-01 12:43:11

Previous E.O. D-216-23 | Previous E.O. D-215 | Next E.O. D-216-25 | Next E.O. D-217