Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on June 11, 2001.
As of Monday, October 21st, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

ModelsModification
1983 and older vehicles with either a breaker or breakerless ignition systemThe XR700 and XRI are both designed to be installed under the vehicle's distributor cap, replacing the stock ignition system. The XR700 is applicable to vehicles with either a breaker or breakerless ignition system, and the XRI is only applicable on vehicles with a breaker point style ignition system. The XRI is equipped with an adjustable rev limiter.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-225-67
  • Executive Order 225-67 / D225-67
  • ARB # D-225-67
  • Executive Order No: D-225-67
  • C.A.R.B. No. D-225-67
  • Resolution D-225-67
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-225-67 PDF

D-225-67 Document:

CARB_D-225-67

(Page 1 of 2) State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—225—67 Relating to Exemptions Under Section 27156 of the Vehicle Code CRANE CAMS, INC. ._XR700 AND XRI IGNITION SYSTEMS Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the undersigned by Sections 39515 and 39516 of the Health and Safety Code and Executive Order G—45—9; IT IS ORDERED AND RESOLVED: That the installation of the XR700 and XRI ignition systems, manufactured by Crane Cams, Inc. of 530 Fentress Blvd., Daytona Beach, Florida 32114, has been found not to reduce the effectiveness of the applicable vehicle pollution control system and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for all applicable 1983 and older vehicles with either a breaker or breakerless ignition system. The XR700 and XRI are both designed to be installed under the vehicle‘s distributor cap, replacing the stock ignition system. The XR700 is applicable to vehicles with either a breaker or breakerless ignition system, and the XRI is only applicable on vehicles with a breaker point style ignition system. The XRI is equipped with an adjustable rev limiter. This exemption is issued based on information supplied by the device manufacturer which demonstrates that the XR700 and XRI ignition systems meets the requirements of _ compliance criteria for ignition systems as specified under "Procedures for Exemption of Add—On and Modified Parts" and therefore, will not increase emissions. This Executive Order is valid provided the installation instructions for these devices will not recommend tuning the vehicles to specifications different from those submitted by the vehicle manufacturer. Changes made to the design or operating conditions of the devices, as exempt by the Air Resources Board, which adversely affect the performance of a vehicle‘s pollution control system shall invalidate this Executive Order. , Marketing of these devices using any identification other than that shown in this Executive Order or marketing of these devices for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board.

CRANE CcaAMS Executive Order D—225—67 XR700 AND XRI IGNITION SYSTEMS (Page 2 of 2) THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF CRANE CAMS®‘ XR700 AND XRIIGNITION SYSTEMS. No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action taken herein in any advertising or other oral or written communication. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. ‘If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. Executive Orders D—47—2 and D—47—3, both dated May 1983, are superseded and of no further force and effect. Executed at El Monte, California, this (/ tL day of June 2001. . R. B. Syhmerfleld, Chfef Mobile Source Operations Division


Document Created: 2005-09-01 12:41:29
Document Modified: 2005-09-01 12:41:29

Previous E.O. D-225-66 | Previous E.O. D-224 | Next E.O. D-225-68 | Next E.O. D-226