Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on May 13, 1998.
As of Thursday, January 2nd, 2025 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
1534, 52mm1985-88 Camaro/Firebird/Corvette, 5.0/5.7L

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-245-10
  • Executive Order 245-10 / D245-10
  • ARB # D-245-10
  • Executive Order No: D-245-10
  • C.A.R.B. No. D-245-10
  • Resolution D-245-10
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-245-10 PDF

D-245-10 Document:


CARB_D-245-10

                                                                              (Page 1 of 2)

                                              State of California
                                          AIR RESOURCES BOARD


                                        EXECUTIVE ORDER D—245—10
                                   Relating to Exemptions Under Section 27156
                                                ofthe Vehicle Code


                                          BBK PERFORMANCE, INC.
                                       52mm and 5§mm Throttle Bodies


Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 ofthe Health and Safety
Code and Executive Order G—45—9;

IT IS ORDERED AND RESOLVED: That the installation of the 52mm and 58mm Throttle Bodies,
manufactured and marketed by BBK Performance, Inc. 1611 Railroad Street, Corona, California 91720 has been
found not to reduce the effectiveness of the applicable vehicle pollution control system and, therefore, is exempt
from the prohibitions of Section 27156 of the Vehicle Code for the following vehicle applications:

Part No.           Vehicle Application          Engine                Size               Model—Year

1534            Camaro/Firebird/Corvette          5.0/5.T7L           52mm               1985—88
1536            Camaro/Firebird/Corvette          5.0/5.TL            S8mm               1985—88
1537            Camaro/Firebird/Corvette            5.0L              52mm               1989—92
1539            Camaro/Firebird/Corvette          5.0/5.7L            58mm               1989—92
1540            Camaro/Firebird/Impala SS/           5.TL             52mm               1992/93
                        Corvette
1542            Camaro/Firebird/Impala SS/          5.7L              58mm               1992/93
                        Corvette
1543            Camaro/Firebird/Impala SS$/         5.TL              52mm               1994—97
                        Corvette
1544            Camaro/Firebird/Impala SS/          5.TL              58mm               1994—97
                        Corvette

This Executive Order is granted based on submitted emissions test data on a 1995 Impala SS, certified to a tier 1
emission standard. Test results showed that tailpipe emissions with the 58mm Throttle Body installed on the
vehicle met the vehicle‘s applicable emission standard during a Cold Start CVS—75 Federal Test Procedure. This
Executive Order is also based on On Board Diagnostic II (OBD II) testing conducted on a 1997 Camaro. Test
data showed that the 58mm Throttle Body when installed on the vehicle did not affect the vehicle‘s ability to
perform its OBD II monitoring.

This Executive Order is valid provided that the installation instructionsfor the 52mm and S8mm Throttle Bodies
will not recommend tuning the vehicle to specifications different from those of the vehicle manufacturer.

Changes made to the design or operating conditions ofthe 52mm and 58mm Throttle Bodies, as exempt by the
Air Resources Board, which adversely affect the performance of the vehicle‘s pollution control system shall
invalidate this Executive Order.


BBK Performance, Inc.                                                  Executive Order D—245—10
The 52mm and 58$mm Throttle Bodies                                     (Page 2 of 2)




Marketing of the 52mm and 58$mm Throttle Bodies using any identification other than that shown in this
Executive Order or marketing of the 52mm and 58mm Throttle Bodies for an application other than those listed
in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board.
Exemption of the 52mm and 58mm Throttle Bodies shall not be construed as exemption to sell, offer for sale, or
advertise any component of the kit as an individual device.

This Executive Order does not constitute any opinion as to the effect the use of the 5Z2mm and 5&mm Throttle
Bodies may have on any warranty either expressed or implied by the vehicle manufacturer.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY
CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED
BENEFITS OF THE BBK PERFORMANCE, INC.‘S 52MM AND 58MM THROTTLE BODIES.

No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action
taken herein in any advertising or other oral or written communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked
only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may
request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within
ten days of receipt of the request and the order may not be revoked until a determination after hearing that
grounds for revocation exist.

Executive Order D—245—9 dated December 1997, is superseded and of no further force and effect.
                                             L*
Executed at El Monte, California, this _/3 dgrpf May 1998.


                                   R. B.Summerfield, Chief
                                   Mobile Source Operations Division



Document Created: 2005-09-01 12:42:39
Document Modified: 2005-09-01 12:42:39

Previous E.O. D-245-9 | Previous E.O. D-244 | Next E.O. D-245-11 | Next E.O. D-246