Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on February 13, 2017.
As of Wednesday, June 19th, 2019 this Executive Order has not been overturned or superceeded.

Approved Parts

Part Number
see pdf

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-265-50
  • Executive Order 265-50 / D265-50
  • ARB # D-265-50
  • Executive Order No: D-265-50
  • C.A.R.B. No. D-265-50
  • Resolution D-265-50
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-265-50 PDF

D-265-50 Document:



                                      State of California
                                  AIR RESOURCES BOARD

                                EXECUTIVE ORDER D—265—50

                                 Relating to Exemptions under
                              Section 27156 of the Vehicle Code

                                         FCA US LLC
                                     Mopar Performance
                        Cold Air Intake Assembly, Part No. 77072436

Pursuant to the authority vested in the Air Resources Board (ARB) by Section 27156 of the
Vehicle Code (VC); and

Pursuant to the authority vested in the undersigned by Sections 39515 and 39516 of the
Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That installation of the Cold Air Intake Assembly,
manufactured by FCA US LLC — Mopar Performance, 1000 Chrysler Drive, Auburn Hills,
Michigan 48326, has been found not to reduce the effectiveness of the applicable vehicle
pollution control systems, and therefore, the Cold Air Intake Assembly is exempt from the
prohibitions in VC Section 27156 for installation on the 2011 to 2017 model year Dodge
Challengers equipped with a 5.7L or a 6.4L gasoline engine and an SRT front inlet hood.

The Cold Air Intake Assembly consists of the following main components: A new direct fit
air filter box, hood mounted inlet duct assembly, conical air filter, and a hood bezel and
adaptor assembly. Proper installation does not require the removal or relocation of any
inlet sensor, stock intake tubing from the air filter box to the throttle body is retained, no
changes are made to the vehicle‘s ECU calibration.

This Executive Order is valid provided that the installation instructions for the Cold Air
Intake Assembly will not recommend tuning the vehicle to specifications different from
those of FCA US LLC — Mopar Performance.

Changes made to the design or operating conditions of the Cold Air Intake Assembly, as
exempt by the Air Resources Board, which adversely affect the performance of the
vehicle‘s pollution control system shall invalidate this Executive Order.

 The Air Resources Board reserves the right in the future to review this Executive Order
 and the exemption provided herein to assure that the exempted add—on or modified part
 continues to meet the standards and procedures of Title 13, California Code of
 Regulations, Section 2222, et seq.

 This exemption is issued based on prior emissions and OBD II data submitted from
 FCA US LLC — Mopar Performance in support of other Mopar Performance Executive
 Orders.

 The Air Resources Board reserves the right in the future to review this Executive Order
 and the exemption provided herein to assure that the exempted add—on or modified part
 continues to meet the standards and procedures of Title 13, California Code of
 Regulations, Section 2222, et seq.


THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE
COLD AIR INTAKE ASSEMBLY.

Marketing of the Cold Air Intake Assembly using any identification other than that shown
in this Executive Order or marketing of the Cold Air Intake Assembly for an application
other than those listed in this Executive Order shall be prohibited unless prior approval
is obtained from the Air Resources Board.

No claim of any kind, such as "Approved by the Air Resources Board", may be made
with respect to the action taken herein in any advertising or other oral or written
communication.

This Executive Order shall not apply to any Cold Air Intake Assembly advertised,
offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with
transfer to an ultimate purchaser.

Violation of any of the above conditions shall be grounds for revocation of this order.
The order may be revoked only after a ten—day written notice of intention to revoke the
order, in which period the holder of the order may request in writing a hearing to contest
the proposed revocation. If a hearing is requested, it shall be held within ten days of
receipt of the request and the order may not be revoked until a determination is made
after the hearing that grounds for revocation exist.

Executed at El Monte, California, this      {3       day of February 2017.




                 Annette Hebert, Chief
                 Emissions Compliance, Automotive Regulations and Science Division




 FCA US LLC — MOPAR PERFORMANCE—COLD AIR INTAKE ASSEMBLY—D—265—50



Document Created: 2017-07-14 11:19:09
Document Modified: 2017-07-14 11:19:09

Previous E.O. D-265-49 | Previous E.O. D-264 | Next E.O. D-265-51 | Next E.O. D-266