Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 15, 2015.
As of Thursday, December 26th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
57-90252005 - 2014 Toyota Tacoma V6 4.0LRetains factory air box with hydrocarbon adsorber

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-269-52
  • Executive Order 269-52 / D269-52
  • ARB # D-269-52
  • Executive Order No: D-269-52
  • C.A.R.B. No. D-269-52
  • Resolution D-269-52
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-269-52 PDF

D-269-52 Document:

CARB_D-269-52

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D-269-52 Relating to Exemptions Under Section 27156 of the California Vehicle Code K&N Engineering, Inc. Fuel Injection Performance Kit and Typhoon Intake Systems Pursuant to the authority vested in the Air Resources Board (ARB) by Section 27156 of the Vehicle Code (VC); and Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and Safety Code and Executive Order G-14-012 ; IT IS ORDERED AND RESOLVED : That installation of the Fuel Injection Performance Kit and Typhoon Intake Systems, produced and marketed by K&N Engineering , Inc. of 1455 Citrus Street, Riverside, California 92507 , has been found not to reduce the effectiveness of the applicable vehicle pollution control systems and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for the vehicles listed in the attached Exhibit A. The Fuel Injection Performance Kit and Typhoon Intake Systems include the following main components: open-element reusable air filter, intake system tubing, assorted brackets , and hardware. This Executive Order is valid provided that installation instructions for the Fuel Injection Performance Kit and Typhoon Intake Systems will not recommend tuning the vehicle to specifications different from those of the vehicle manufacturer. Changes made to the design or operating conditions of the Fuel Injection Performance Kit and Typhoon Intake Systems, as exempt by the ARB, which adversely affect the performance of the vehicle's pollution control system shall invalidate this Executive Order. This Executive Order shall not apply to any F,uellnjection Performance Kit or Typhoon Intake System advertised, offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer to an ultimate purchaser. Marketing of the Fuel Injection Performance Kit and Typhoon Intake Systems using any identification other than that shown in this Executive Orqer or marketing of the Fuel Injection Performance Kit and Typhoon Intake Systems for- an application· other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the ARB.

-2- This Executive Order does not constitute any opinion as to the effect the use of the Fuel Injection Performance Kit and Typhoon Intake Systems may have on any warranty either expressed or implied by the vehicle manufacturer. This Executive Order is granted based on prior evaluations by K&N Engineering , Inc. (D-269-22, D-269-26 , and D-269-40) which determined that the Fuel Injection Performance Kit and Typhoon Intake Systems would not cause an adverse effect on emissions of the selected vehicles, nor does it affect the vehicles' ability to perform On- Board Diagnostic II (OBD II) system monitoring. ARB reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add-on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222 , et seq. Further, if test results or other evidence provides the ARB with reason to suspect that the Fuel Injection Performance Kit and Typhoon Intake Systems will affect the durabil ity of emission control systems , K&N Engineering , Inc. shall be required to submit durability data to show that the durability of vehicle emission control systems are not, in fact, affected and/or that the add-on or modified part demonstrates adequate durability. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION , APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI-POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE K&N ENGINEERING, INC . FUEL INJECTION PERFORMANCE KIT AND TYPHOON INTAKE SYSTEMS. No claim of any kind , such as "Approved by the Air Resources Board", may be made with respect to the action taken herein in any advertising or other oral or written communication. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten-day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested , it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. Executed at El Monte, California , this /S day of September 2015 . Annette Hebert, Chief Emissions Compliance , Automotive Regulations and Science Division K&N Engineering - Fuel Injection Performance Kit and Typhoon Intake Systems- D-269-52

Exhibit A -" . Part Number Model Year Make Model Engine Remarks 'I f • .I Retains factory air box with 57-9025 2005-2014 Toyota Tacoma V6 4.0L hydrocarbon adsorber 2007-2013 Toyota Tundra V8 5.7L Retains factory air box lid 57-9031 2007-2013 Toyota Sequoia V8 5.7L Retains factory air box lid 2014-2015 Toyota Tundra V8 4.6L Retains factory air box lid 57-9036 2014-2015 Toyota Tundra V8 5.7L Retains factory air box lid Polished ; retains factory air 2013-2014 Lexus GS350 V6 3.5L box lid 69-8704TP Polished ; retains factory air 2013- 2014 Lex us IS350 V6 3.5L box lid K&N Engineering- Fuel Injection Performance Kit and Typhoon Intake Systems- D-269-52


Document Created: 2015-09-17 14:08:38
Document Modified: 2015-09-17 14:08:38

Previous E.O. D-269-51 | Previous E.O. D-268 | Next E.O. D-269-53 | Next E.O. D-270