Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on November 25, 2008.
As of Saturday, November 23rd, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModificationRemarks
Series 4100001996 to 2003 selected Chrysler PCNoneContact manufacturer or distributor for specific vehicle application

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-280-58
  • Executive Order 280-58 / D280-58
  • ARB # D-280-58
  • Executive Order No: D-280-58
  • C.A.R.B. No. D-280-58
  • Resolution D-280-58
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-280-58 PDF

D-280-58 Document:

CARB_D-280-58

State of California — AIR RESOURCES BOARD EXECUTIVE ORDER D—280—58 Relating to Exemptions under Section 27156 and 38391 of the Vehicle Code Airtek, Inc. (d.b.a. Catco) "SGeries 410000 Three—way Catalytic Converters" WHEREAS, Vehicle Code Sections 27156 and 38395, and Title 13, California Code of Regulations (hereafter "CCR") Section 2222(h), authorize the California Air Resources Board and its Executive Officer to exempt new aftermarket catalytic converters from the prohibitions of Vehicle Code Section 27156 and 38391. WHEREAS, Airtek, Inc. (Airtek) of 4410 W. 37"" Avenue, Hobart, Indiana 46342, has applied to the Air Resources Board for exemption from the prohibitions in Vehicle Code Sections 27156 and 38391 to market its new aftermarket Series 410000 three—way catalytic converters (TWC) on selected 1996 through 2003 model year Chrysler passenger cars equipped with on—board diagnostic II (OBD—II) systems as specified in Appendix D—280—58 and incorporated hereln Series 410000 TW Cs will be used for single catalytic converter application. WHEREAS, pursuant to the authority vested in the Executive Officer by Health and Safety Code Section 39515 and in the Chief, Mobile Source Operations Division by Health and Safety Code Section 39516 and Executive Order G—02—003, the Air Resources Board finds that the above aftermarket catalytic converters comply with the California Vehicle Code Sections 27156 and 38395 and Title 13, California Code of Regulations, Section 2222(h). Emission performance of the catalytic converters was based on durability bench—aging by Southwest Research Institute using the Air Resources Board—modified RAT—A bench—aging cycle for 75 hours as specified in Appendix A to the "California Evaluation Procedures for New Aftermarket Catalytic Converters" as adopted on October 25, 2007. WHEREAS, previous emissions and OBD 1| compatibility tests conducted by Airtek, Inc. using a vehicle of weight classification and exhaust configuration similar to those listed in Appendix D—280—58 and certified to Low Emission Vehicle (LEV) standards resulted in the issuance of Executive Orders D—280—16, it was determined that the installation of Series 410000 on the vehicles listed in Appendix D—280—58 meets the requirements of California regulation for aftermarket catalytic converters. THEREFORE, IT IS HEREBY RESOLVED that Airtek, Inc.‘s 410000 TWCs are exempted from the prohibitions in Vehicle Code Sections 27156 and 38391 for installation on the approved vehicle appllcatlons specified in Appendlx D—280—58 subject to the following conditions:

— 2— ._ No changes are permitted to the catalytic converters as described in the application for exemption. Any changes to the catalytic converters or any of their components, and other factors addressed in this order must be evaluated and approved by the Air Resources Board prior to marketing in California. ._ Marketing of the catalytic converters using identifications other than those shown in the exemption application, and in this Executive Order, or marketing of the catalytic converters for application other than the ones shown in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. Exemption of these products shall not be construed as an exemption to sell, offer for sale, or advertise any components of the catalytic converters as individual devices. ._Any oral or written references to this Executive Order or its content by Airtek, Inc., its principals, agents, employees, distributors, dealers, or other representatives must include the disclaimer that the Executive Order or the exemption it provides is not an endorsement or approval of any emission reduction claims for the catalytic converters and is only a finding that the catalytic converters are exempt from the prohibitions of Vehicle Code Sections 27156 and 38391. | ._ Airtek, Inc.‘s installation instructions for the new catalytié converters must conform to requirements in Section (h) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007. ._ Installation of the catalytic converters shall not cause the relocation of an oxygen sensor. Oxygen sensors must be installed in the same location, position and orientation as prescribed in the original equipment manufacturer‘s configurations. ._ Upon installation, the catalytic converters must carry a manufacturer’s warranty for five (5) years or 50,000 miles as prescribed in Section (f)(2) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters as adopted . October 25, 2007. . Airtek, Inc. and its vendors may not advertise the new aftermarket catalytic converters as "high flow or easy flow" catalytic converters or use any phrase that could make them appear to perform better than the original equipment manufacturer (OEM) catalytic converters. ._ Any marketing arrangement of the new aftermarket catalytic converter by a third party, which involves the use of packaging identification different from the ones described in this Executive Order, must be approved by the Air Resources Board prior to shipment. | . Airtek, Inc., its associates, vendors, other businesses and individuals associated with Airtek, Inc. may not sell or supply new aftermarket catalytic converter substrates to a third party to be assembled in a different facility and marketed under this Executive Order without approval from the Air Resources Board. AIRTEK, INC. — CATALYTIC CONVERTER — D—280—58

— 3 — 10. Airtek, Inc. shall comply with the quality control procedures and reporting requirements in Section (f)(5) of the "Califorma Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007. 11. Quality control reports must be submitted on a quarterly basis and warranty information reports on a semi—annual basis, starting with periods covering January 1 through March 31, 2009 and January 1 through June 30, 2009, respectively. 12. Airtek, Inc. must provide a permanent label or stamp as specified under Section (f)(1) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted on October 25, 2007. 13. Airtek, Inc.‘s vehicle application catalog must conform with the requirements specified under Section (f)(4) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted on October 25, 2007. | Executive Order D—280—25 dated July 8, 2008, is hereby superseded and of no further force and effect. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a 30—day written notice of intention to revoke it, during which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within 30 days of receipt of the request, and the order may not be revoked until a determination is made, after the hearing, that grounds for revocation exist. Executed at El Monte, California, this S day of November 2008 . Annette Hebert, Chief ‘ Mobile Source Operations Division AIRTEK, INC. — CATALYTIC CONVERTER — D—280—58

APPENDIX D—280—58 AIRTEK INC‘S SERIES 410000 FOR CHRYSLER CORPORATION PASSENGER CARS i in & . Certification Weight Exhaust Total Converter . . Dir No. Model Vehicle Engl e Engine Family . 9 Monitored Universal FCt Year Model Size Level Class Type Converters Type Fit 1 Neon TCR122VJG2EK TLEV 412084 412651 412084 412651 q 1996 Breeze, TCR122VJG1EK Cirrus, | 412004 412128 Staratus TIER1 Neon 412084 412651 3 1997 5 VCR122VJG1EK reeze, . 412004 412128 Staratus 4 Neon VCR122VJG2EK TLEV 412084 412651 5 Breeze, Staratus 2 OL wWCrRXvo2.0vB1 TIER1 412004 412225 1998 Neon — 412084 412651 6 Breeze, WCRXVO122V30 LEV 412004 412225 Staratus 7 WCRXVO2.0VB2 N TIER1 412084 3 eon XCRXVO2Z.OVB2 412651 — Breeze " PC 5 10 TWC 1 9 Staratus XCRXVO122Vv30 LEv 412004 412225 Neon 412084 412651 10 SBtreeie' XCRXVO2.0VvB1 412004 4122250 1999 aratus TIER1 11 Neon XCRXVO2.0VBO a12651 12 _ XCRXVO2Z.OVB2 Breeze, 412084 Cirrus, 13 . 2.AL XCRXVO148V30 TLEV 412859 Sebring, — Stratus 14 Breeze, YCRXVO2.O0VB1 | TIER1 412004 412225 Staratus 2.OL 15 YCRXVO122V31 16 2000 Neon _ YCRXV122V30 412006 412094 Breeze, LEV 17 Cirrus, 2 .AL YCRXVO148V30 | 412084 412859 Staratus ' 18 2001 Neon 2.OL 1CRXVO2.0VDO 412006 412094 Page 1 of 2

APPENDIX 0—280—58 AIRTEK INC‘S SERIES 410000 FOR CHRYSLER CORPORATION PASSENGER CARS Model Vehicle Engine . . Certification Weight Exhaust Total . Converter . . Direct No. Year Model : Size Engine Family Level Class I Type Converters Type Monitored Universal — Fit Sebring, 19 2001 Stratus 2.AL 1CRXVO2.4VDO 412275 PT Cruiser, 412292 20 Neon 2.OL 2CRXVO2.0VDO 412094 Sebring, 21 2002 Stratus 2.AL 2CRXVO2.4VDO0 412275 PT Cruiser | 412292 27 Neo 0. 2cmv0zovo1 LEV PC 5 1 TWC 1 412006 . eon & 23 3CRXVO2.0VD0 412094 PT Cruiser 20 412292 24 2003 Sebring, 2.AL 3CRXVO2.4VDO & 412275 Stratus 25 PT Cruiser, 24L 3CRXVO2.4VD1 412292 ’ Neon 412094 Page 2 of 2


Document Created: 2008-12-05 15:54:36
Document Modified: 2008-12-05 15:54:36

Previous E.O. D-280-57 | Previous E.O. D-279 | Next E.O. D-280-59 | Next E.O. D-281