Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on August 15, 1994.
As of Tuesday, December 11th, 2018 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
020-01-69361983-1994 Ford P/U (F150, F250, F350) 7.3L Diesel, Front Tank, standard bed

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-288-2
  • Executive Order 288-2 / D288-2
  • ARB # D-288-2
  • Executive Order No: D-288-2
  • C.A.R.B. No. D-288-2
  • Resolution D-288-2
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-288-2 PDF

D-288-2 Document:



                                                              (Page 1 of 2)

                              State of California
                              AIR RESOURCES BOARD


                          EXECUTIVE ORDER D—288—2
                 Relating to Exemptions Under Section 27156
                            of the Vehicle Code

                            TRANSFER FLOW, INC.
                         REPLACEMENT FILL NECK KIT


Pursuant to the authority vested in the Air Resources Board by Section 27156
of the Vehicle Code; and

Pursuant to the authority vested in the undersigned by Sections 39515 and
39516 of the Health and Safety Code and Executive Order G—45—5;

IT IS ORDERED AND RESOLVED:   That the installation of the Replacement Fill
Neck Kit, manufactured by Transfer Flow, Inc., of 1444 Fortress Street,
Chico, California, 95926, has been found not to reduce the effectiveness of
the applicable vehicle pollution control system and, therefore, is exempt
from the prohibitions of Section 27156 of the Vehicle Code for installation
on the vehicles listed in Exhibit A which is attached hereto and
incorporated herein.


This Executive Order is valid provided that installation instructions for
the Replacement Fill Neck Kit will not recommend tuning the vehicle to
specifications different from those submitted by Transfer Flow, Inc..

Changes made to the design or operating conditions of the Replacement Fill
Neck Kit, as exempt by the Air Resources Board (ARB), which adversely affect
the performance of a vehicle‘s pollution control system shall invalidate
this Executive Order.

Marketing of the Replacement Fill Neck Kit using an identification other
than that shown in this Executive Order or for an application other than
those listed in this Executive Order shall be prohibited unless prior
approval is obtained from the ARB.

In addition to the foregoing, the ARB reserves the right in the future to
review this Executive Order and the exemption provided herein to assure that
the exempted add—on or modified part continues to meet the standards and        s
procedures of Title 13, California Code of Reqgulations, Section 2222 et seq.

This Executive Order does not constitute any opinion as to the effect the
use of the Replacement Fill Neck Kit, may have on any warranty either
expressed or implied by the vehicle manufacturer.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF
CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED
BENEFITS OF TRANSFER FLOW, INC.‘S REPLACEMENT FILL NECK KIT.


TRANSFER FLOW, INC.                             EXECUTIVE ORDER D—288—2
REPLACEMENT FILL NECK KIT                       (Page 2 of 2)




No claim of any kind, such as "Approved by the Air Resources Board" may be
made with respect to the action taken herein in any advertising or other
oral or written communication.

Violation of any of the above conditions shall be grounds for revocation of
this order.  The order may be revoked only after ten day written notice of
intention to revoke the order, in which period the holder of the order may
request in writing a hearing to contest the proposed revocation.  If a
hearing is requested, it shall be held within ten days of receipt of the
request and the order may not be revoked until a determination after the
hearing that grounds for revocation exist.

Executed at El Monte, California, this fi’é&é       August,   1994.




                                      Mobile Source Division


                                  EXHIBIT A—1993



VEHICLE               MODEL     ENGINE     KIT            APPLICATION
MAKE                  ‘YEAR     SIZE       NUMBER         DESCRIPTION


Ford P/U              1983—93   7.3 L      020—01—6936    Front Tank,    standard
F150, F250,    F350             Dbiesel                   bed

Ford P/U              1983—93   7.3 L      020—01—6927    Rear tank,    dual wheel
F150, F250,    F350             Diesel                    bed

Ford P/U              1983—93   4.9    L   020—01—6939    Front tank,    standard
FP150, F250,   F350             5.0    L                  bed
                                5.8    L
                                7.5    L

Ford P/U              1983—93   4.9    L   020—01—6942    Rear tank,    dual wheel
F150, F250,    F350             5.0    L                  bed
                                5.8    L
                                7.5    L

Ford Cab Chassis      1987—93   7.3 L      020—01—8271    Front tank,    standard
F—Super Duty                    Diesel                    bed

Ford Cab Chassis      1987—93   7.3 L      020—01~—8290   Rear tank,    dual wheel
F—~Super Duty                   Diesel                    bed

Ford Cab Chassis      1987—93   7.5 L      020—01—8273    Front tank,    standard
F—~Super Duty                                             bed

Ford Cab Chassis      1987—93   7.5 L      020—01—8291    Rear tank,    dual wheel
F—Super Duty                                              bed


                                 EXHIBIT

VEHICLE             MODEL      ENGINE     KIT            APPLICATION
MAKE                XEAR       ___________DESCRIPTION
Ford P/U            1983—~94   7.3 L      020—01—6936    Front Tank,    standard
F150, F250, F350               Diesgsel                  bed

Ford P/U            1983—94    7.3 L      020—01—6927    Rear tank,    dual wheel
FP150, F250, F350              Diesel                    bed

Ford P/U            1983—94    4.9   L    020—01—6939    Front tank,    standard
F150, F250, F350               5.0   L                   bed
                               5.8   L
                               7.5   L

Ford P/UV           1983—94    4.9   L    020—01—6942    Rear tank,    dual wheel
F150, F250, F350               5.0   L                   bed
                               5.8   L
                               7.5   L

Ford Cab Chassis    1987—94    7.3 L      020—01~—8271   Front tank,    standard
F—Super Duty                   Diesel                    bed

Ford Cab Chassis    1987—94    7.3 L      020—01—8290    Rear tank,    dual wheel
F—Super Duty                   Diesel                    bed

Ford Cab Chassis    1987—94    7.5 L      020—01—8273    Front tank,    standard
F—Super Duty                                             bed

Ford Cab Chassis    1987—94    7.5 L      020—01~—8291   Rear tank,    dual wheel
F—Super Duty                                             bed



Document Created: 2005-09-01 12:40:11
Document Modified: 2005-09-01 12:40:11

Previous E.O. D-288-1 | Previous E.O. D-287 | Next E.O. D-288-3 | Next E.O. D-289