Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on April 13, 2017.
As of Tuesday, December 18th, 2018 this Executive Order has not been overturned or superceeded.

Approved Parts

Part Number
See PDF

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-411-12
  • Executive Order 411-12 / D411-12
  • ARB # D-411-12
  • Executive Order No: D-411-12
  • C.A.R.B. No. D-411-12
  • Resolution D-411-12
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-411-12 PDF

D-411-12 Document:



                                  State of California
                               AIR RESOURCES BOARD


                             EXECUTIVE ORDER D—411—12

                       Relating to Exemptions Under Section 27156
                                    of the Vehicle Code


                            Gibson Performance Corporation
                             Performance Exhaust Headers

Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section
39516 of the Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That the installation of the Performance Exhaust
Headers manufactured and marketed by Gibson Performance Corporation of 1270
Webb Circle, Corona, California 92879, has been found not to reduce the
effectiveness of required motor vehicle pollution control devices and, therefore, is
exempt from the prohibitions of Section 27156 of the Vehicle Code for the 1991
through 2011 model year Chrysler passenger cars and trucks listed in Exhibit A.

The Performance Exhaust Headers consists of tubular, short—length exhaust
manifolds made of 16 gauge steel, and the corresponding assembly hardware. As
applicable, oxygen sensors and exhaust gas recirculation sensors are removed from
the stock manifold and installed on similar locations on the Performance Exhaust
Headers. All other emission—related components are in their stock location. The
header kit is available in chrome, stainless steel or ceramic—coated steel.

Marketing of these devices using any identification other than that shown in this
Executive Order or marketing of this device for an application other than those listed
in this Executive Order shall be prohibited unless prior approval is obtained from the
Air Resources Board.

This Executive Order is valid provided that the installation instructions for the Ford
Exhaust Header Kit will not recommend tuning the vehicle to specifications different
from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the devices, as exempted by the
Air Resources Board, that adversely affect the performance of a vehicle‘s pollution
control system shall invalidate this Executive Order.


This Executive Order does not constitute any opinion as to the effect that the use of
these devices may have on any warranty either expressed or implied by the vehicle
manufacturer.

This exemption is issued based on prior data submitted from Gibson Performance
Corporation in support of other Gibson Performance Corporation‘s Executive Orders.

In addition, the Air Resources Board reserves the right in the future to review this
Executive Order and the exemption provided herein to assure that the exempted add—on
or modified part continues to meet the standards and procedures of Title 13, California
Code of Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE
PERFORMANCE EXHAUST HEADERS.

No claims of any kind, such as "Approved by the Air Resources Board" may be made
with respect to the action taken herein in any advertising or other oral or written
communication.

Violation of any of the above conditions shall be grounds for revocation of this order.
The order may be revoked only after a ten day written notice of intention to revoke the
order, in which period the holder of the order may request in writing a hearing to contest
the proposed revocation. If a hearing is requested, it shall be held within ten days of
receipt of the request and the order may not be revoked until a determination is made
after the hearing that grounds for revocation exist.


Executed at El Monte, California, this    )3 day of April 2017.




        Annette Hebert, Chief
        Emissions Compliance, Automotive Regulations and Science Division




  GIBSON PERFORMANCE CORPORATION — PERFORMANCE EXHAUST HEADERS — D—411—12


                                       Exhibit A
                                   (E.0.# D—411—12)
CHRYSLER
MCLC       ENGINE SIZE   2/4WD      TUBE         CHROME   STAINLESS   CERAMIC
300C
[o4—09    5.7L           |2wp      [1—1/2"      |N/A      [N/A        |ep31i4s—C

DODGE
 CHARGER
[o6—09   [5.7L     |2wp            [1—1/2"      [N/A      [N/A        [ep3i4s—c
 CHALLENGER
[2009    [5.7L     [2wD            [1—1/2"      N/A       [N/A        |ep31i4s—c
 MAGNUM WAGON
[o4—09   [5.7L     [2wo            [1—1/2"      [N/A      [N/A        [ep314Ss—C
 DAKOTA
 96—03    3.9L      2WD             1—1/2"       GP306    GP306S      GP306S—C
 04—06    4.7L      2/4WD           1—1/2"       GP316    GPp316S     GP316S—C
 00—03    4.7L      2/4WD           1—1/2"       GP307    GP307S      GP307S—C
 96—03    5.2L      2/4WD           1—1/2"       Gp301    GP301S      GP301S5—C
 92—95    5.2L      2/4WD           1—1/2"       GP300    GP3008      GP300S—C
 96—03    5.91      2/4WD           1—1/2"       Gp301    GP301S      GP301S—C
 92—95    5.91      2/4WD           1—1/2"       GP300    GP300S      GP300S—C
 DURANGO
 00—03    4.7L      2/4WD           1—1/2"       GP308    GP308S      GP308S—C
 96—03    5.2L      2/4WD           1—1/2"       GP301    GP301S      GP301S—C
 96—03    5.91      2/4WD           1—1/2"       GP301    Gp301S      GP301S—C
 04—06    5.7L      2WD             N/A          N/A      N/A         GP3175—C
 RAM TRUCK 1500
 04—07    4.7L      2/4WD           1—1/2"       GP316    GP316S      GP316S—C
 02—03    4.7L      2/4 WD          1—1/2"       GP309    GPp309S     GP309S—C
 96—03    5.2L      2/4WD           1—1/2"       GP301    GP301S      GP301S—C
 92—95    5.2L      2/4WD           1—1/2"       GP300    Gp3008S     GP300S—C
 03—08    5.7L      2/4WD           N/A          N/A      N/A         GP3115—C
 96—03    5.91      2/4WD           1—1/2"       GP301    Gp301S      GP301S—C
 92—95    5.91      2/4WD           1—1/2"       GP300    GP3008s     GP300S—C
 04—05    8.3L SRT  2WD             1—1/2"       N/A      GP31i2S     GP312S—C
 RAM TRUCK 2500/3500
 96—02    8.0L      2/4WD           1—1/2"       GP304    GP304S      GP304S—C
 04—05    5.7L      2 WD            N/A          N/A      N/A         GP311S—C
 2003     5.7L      2/4WD           1—1/2"       GP310    Gp310S      GP310S—C

JEEP
 CHEROKEE
[a1—99   [4.0L           [2/4wD     [1—1/2"      [GP400   |ep40os     |er400Ss—C
 GRAND CHEROKEE
[93—99   [4.0L           [2/4 wp    [1—1/2"      |er400   [Gr4oos     |ep400s—C
 WRANGLER
 91—99    4.0L TJ,¥J     4WD        1—1/2"       GP400    Gp400Ss      GP400S—C
 07—11    3.8L                      1—1/2"       GP403    GP403S       GP403S—C


   GIBSON PERFORMANCE CORPORATION — PERFORMANCE EXHAUST HEADERS — D 411—12





Document Created: 2017-07-18 08:39:14
Document Modified: 2017-07-18 08:39:14

Previous E.O. D-411-11 | Previous E.O. D-410 | Next E.O. D-411-13 | Next E.O. D-412