Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on October 10, 1996.
As of Thursday, August 22nd, 2019 this Executive Order has not been overturned or superceeded.

Approved Parts

Models
1996 and older model year vehicles equipped with ignition systems that require an ignition coil with a primary resistance of 0.6-1.0 ohms or that have active current limiting

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-414-1
  • Executive Order 414-1 / D414-1
  • ARB # D-414-1
  • Executive Order No: D-414-1
  • C.A.R.B. No. D-414-1
  • Resolution D-414-1
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-414-1 PDF

D-414-1 Document:



                                                               (Page 1 of 2)

                              State of California
Li




                              AIR RESOURCES   BOARD

                            EXECUTIVE ORDER D—414—1
                  Relating to Exemptions Under Section 27156
                              of the Vehicle Code

                           NOLOGY ENGINEERING, INC.
                           PROFIRE M7O IGNITION COIL



     ~Pursuant —to—theauthority — vested—inthe—Air—Resources—Board—{ARB) —
      by Section 27156 of the Vehicle Code; and

      Pursuant to the authority vested in the undersigned by Sections
      39515 and 39516 of the Health and Safety Code and Executive Order
      G—45—9,;
     IT IS ORDERED AND RESOLVED:  That the installation of the ProFire
     M7O Ignition Coil manufactured by Nology Engineering, Inc. of 7360
     Trade Street, San Diego, California 92121, has been found not to
      reduce the effectiveness of required motor vehicle pollution
      control devices and, therefore, is exempt from the prohibitions of
      Section 27156 of the Vehicle Code for installation on 1996 and
      older model year vehicles equipped with ignition systems that
      require an ignition coil with a primary resistance of 0.6—1.0 ohns
      or that have active current limiting.

      Changes to the factory emission control systems are limited to
     replacing the original equipment manufacturer (OEM) ignition coil
     with Nology Engineering, Inc.‘s ProFire M7O0 Ignition Coil.

      This Executive Order is valid provided that installation
      instructions for the ProFire M70 Ignition Coil will not recommend
      tuning the vehicle to specifications different from those submitted
      by the device manufacturer.

      Changes made to the design or operating conditions of the device,
      as exempted by the ARB, that adversely affect the performance of a
      vehicle‘s pollution control system shall invalidate this Executive
      Order .

     Marketing of this device using an identification other than that
     shown in this Executive Order or marketing of this device for an
      application other than those listed in this Executive Order shall
      be prohibited unless prior approval is obtained from the ARB.

      This Executive Order does not constitute any opinion as to the
      effect the use of this device may have on any warranty either
      expressed or implied by the vehicle manufacturer.


     NOLOGY ENGINEERING, INC.                                EXECUTIVE ORDER D—414—1
     PROFIRE M7O IGNITION COIL                                         (Page 2 of 2)


     THILS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
     ~ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
     AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
     ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF NOLOGY
     ENGINEERING, INC.!‘S PROFIRE M7O IGNITION COIL.

     No claim of any kind, such as "Approved by the Air Resources
     Board," may be made with respect to the action taken herein in any
     advertising or other oral or written communication.

     —section17500 of—theBusiness—andProfessions—CGode—RAkes 4UREFUCA—OP————o— _
     misleading advertising unlawful, and Section 17534 makes violation
     punishable as a misdemeanor.

     Section 43644 of the Health and Safety Code provides as follows:

           "43644,   (a)   No person shall install,        sell,   offer for sale,       or
           advertise, or,     except in an application to the state board for
           certification of a device,     represent,        any device as a motor
           vehicle pollution control device for use on any used motor
           vehicle unless that device has been certified by the state
           board.    No person shall sell,     offer for sale,        advertise,    or
           represent any motor vehicle pollution control device as a
           certified device which, in fact, is not a certified device.
           Any violation of this subdivision is a misdemeanor."

     Any apparent violation of the conditions of this Executive Order
     may result in its rescission or submission to the Attorney General
     of California for such action as he deems advisable.

     Violation of any of the above conditions shall be grounds for
     revocation of this Order.  The Order may be revoked only after a
     ten—day written notice of intention to revoke the Order, in which
     period the holder of the Order may request in writing a hearing to
     contest the proposed revocation.         If a hearing is requested,           it
     shall be held within ten days of receipt of the request and the
     Order may not be revoked until a determination after the hearing
     that grounds for revocation exist.

     The Bureau of Automotive Repair will be notified by copy of this
     order .                                                Z£

     Executed at El Monte,      California,   this       [ day of October 1996.


                                              ,,@,,W
                                                     .   Summerfield,   CHY
                                               qblle Ssource Operations Division
es



Document Created: 2005-09-01 12:43:02
Document Modified: 2005-09-01 12:43:02

Previous E.O. D-414 | Previous E.O. D-413 | Next E.O. D-414-2 | Next E.O. D-415