Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on October 14, 2008.
As of Thursday, December 26th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsRemarks
M-9603-SVT072007 through 2009 model year Ford Shelby GT500 5.4L MustangThe Shelby GT500 Cold Air Upgrade Kit (part numbers M-9603-SVT07) includes an open element high flow conical air filter, a new mass air flow sensor tube, and a new ECM calibration. Installation requires the removal of the stock air filter housing and the transfer of the mass air flow sensor electronics to the new mass air flow sensor tube.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-418-15
  • Executive Order 418-15 / D418-15
  • ARB # D-418-15
  • Executive Order No: D-418-15
  • C.A.R.B. No. D-418-15
  • Resolution D-418-15
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-418-15 PDF

D-418-15 Document:


CARB_D-418-15

                                     State of California
                                 AIR RESOURCES BOARD

                               EXECUTIVE ORDER D—418—15

                        Relating to Exemptions Under Section 27156
                                   of the California Vehicle Code

                                       Roush Industries
                            Shelby GT500 Cold Air Upgrade Kit

Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516
of the Health and Safety Code and Executive Order G—02—003;         _

IT IS ORDERED AND RESOLVED: That the installation of the Shelby GT500 Cold Air
Upgrade Kit, produced and marketed by Roush Industries of 777 Republic Drive, Allen
Park, Michigan 48101, has been found not to reduce the effectiveness of the applicable
vehicle pollution control systems and, therefore, is exempt from the prohibitions of Section
27156 of the Vehicle Code for the 2007 through 2009 model year Ford Shelby GT500 5.4L
Mustang.                      -

The Shelby GT500Cold Air Upgrade Kit (part numbers M—9603—SVTO7) includes an open
element high flow conical air filter, a new mass air flow sensor tube, and a new ECM
calibration. Installation requires the removal of the stock air filter housing and the transfer
of the mass air flow sensor electronics to the new mass air flow sensor tube.

This Executive Order is valid provided that the installation instructions for the Shelby
G1T500 Cold Air Upgrade Kit will not recommend tuning the vehicle to specifications
different from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the Shelby GT500 Cold Air
Upgrade Kit, as exempt by the Air Resources Board, which adversely affect the
performance of the vehicle‘s pollution control system shall invalidate this Executive Order.

This Executive Order shall not apply to any Shelby GT500 Cold Air Upgrade Kit
advertised, offered for sale, sold with, or installed on a new motor vehicle prior to or
concurrent with transfer to an ultimate purchaser.

Marketing of the Shelby GT500 Cold Air Upgrade Kit using any identification other than
that shown in this Executive Order or marketing of the Shelby G1T500 Cold Air Upgrade Kit
for an application other than those listed in this Executive Order shall be prohibited unless
prior approval is obtained from the Air Resources Board.

This Executive Order does not constitute any opinion as to the effect the use of the Shelby
G1T500 Cold Air Upgrade Kit units may have on any warranty either expressed or implied
by the vehicle manufacturer.


                                              lp.

This Executive Order is granted based on submitted emission test data generated on a
2007 model year Ford Shelby GT500 5.4L Mustang certified to the Low Emission
Vehicle II Low Emission Vehicle (LEV II LEV) emission standards. Test results on the
Shelby Mustang showed that emission levels, with Roush Industries‘ Shelby GT500 Cold
Air Upgrade Kit installed, met the applicable emission standards when tested using the
Cold—Start CVS—75 Federal Test Procedure (FTP) and the Supplemental Federal Test
Procedure (SFTP USO6/5C03) test cycles. Examination of the OBD I! system showed the
Shelby GT500 Cold Air Upgrade Kit did not affect OBD II system operation. Results from
emission testing conducted at the Roush Emissions Laboratory, Livonia, Michigan are
listed below with deterioration factors applied.

2007 Ford Shelby Mustang                 CVS—75 FTP
                                   NMOG     CO    NOx              HCHO
Standards                          0.075   3.4    0.05             0.015
Device Test                        0.046    1.1   0.03             0.001

                                     USO6/SC03
  ‘                            NMHC+NOx              CO
Standards 4k                     0.14/0.20           8.0/2.7
Device                           0.03/0.07           1.6/2.0

The Air Resources Board reserves the right in the future to review this Executive Order
and the exemption provided herein to assure that the exempted add—on or modified part
continues to meet the standards and procedures of Title 13, California Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF ROUSH INDUSTRIES‘
SHELBY GT500 COLD AIR UPGRADE KIT.

No claim of any kind, such as "Approved by the Air Resources Board", may be made with
respect to the action taken herein in any advertising or other oral or written
communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The
order may be revoked only after a ten—day written notice of intention to revoke the order, in
which period the holder of the order may request in writing a hearing to contest the
proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of
the request and the order may not be revoked until a determination is made after the
hearing that grounds for revocation exist.

Executed at El Monte, California,this       /6/     day of October 2008.



                                 W%/—
                                 Annette Hebert, Chief
                                 Mobile Source Operations Division


     ROUSH INDUSTRIES — SHELBY GT500 COLD AIR UPGRADE KIT — D—418—15



Document Created: 2008-10-31 14:35:28
Document Modified: 2008-10-31 14:35:28

Previous E.O. D-418-14 | Previous E.O. D-417 | Next E.O. D-418-16 | Next E.O. D-419