Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on October 9, 2012.
As of Tuesday, September 17th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
E90405A2011-2013 Toyota 3.5 liter SiennaThe assembly allows relocation of the stock fuel tank to the rear of the vehicle and includes relocation of the rear under floor catalytic converter using a replacement exhaust pipe.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-449-37
  • Executive Order 449-37 / D449-37
  • ARB # D-449-37
  • Executive Order No: D-449-37
  • C.A.R.B. No. D-449-37
  • Resolution D-449-37
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-449-37 PDF

D-449-37 Document:

CARB_D-449-37

State of California | AIR RESOURCES BOARD EXECUTIVE ORDER D—449—37 Relating to Exemptions under Section 27156 of the Vehicle Code The Braun Corporation Fuel TankAssembly Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and _ Pursuant to the authority vested in the undersigned by Sections 39515and 39516 of the _Health and Safety Code and Exeeutive Order G—02—003; IT IS ORDERED AND RESOLVED: That the installation of Fuel Tank Assembly, E90405A, manufactured by The Braun Corporation of 631 West 11"" Street, Winamac, Indiana 46996, has been found not to reduce the effectiveness of the applicable vehicle pollution control system, and therefore, the Fuel Tank Assembly is exempt from the prohibitions in Section 27156 of the Vehicle Code for installation on 2011 through 2013 — model—year Toyota Motor Corporation 3.5 liter Slenna minivan. , The assembly allows relocation of the stock fuel tank to the rear of the vehicle and — includes relocation of the rear undeffloor catalytic converter using a replacement exhaust pipe. — This Executive Ofder is based on testing and engineering evaluation for impact on emissions. Exemption of the Fuel Tank Assembly shall not be construed as an exemption to sell, offer for sale, or advertise any component of the assembly as individual devices. | ‘This Executive Order shallnot apply to any device advertised, offered for sale, sold with, or installed on a motor vehicle prior to or concurrent with transfer to an ultlmate purchaser — This Executive Order is valid provided thet installation instructions for the Fuel Tank Assembly do not recommend tuning the vehicle to specifications different from those of _ the vehicle manufacturer . Changes made to the design or operating conditions of the Fuel Tank Assembly, as exempt by the Air Resources Board, which adversely affect the performance of the vehicle‘s poliution control system shall invalidate this Executive Order. Marketing of the Fuel Tank Assembly using an identification other than that shown in this Executive Order or for an application other than those listed in this Executive Order . shall be prohibited unless prior approval is obtained from the Air Resources Board. |

—2. In addition to the foregoing, the Air Resources Board reserves the right in the future to review this Executive Order andthe exemption provided herein to assure that the exempted add—on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222 et seq. This Executive Order does not constitute any opinion as to the effect the use of the Fuel! Tank Assembly may have on any warranty either expressed or implied by the vehicle manufacturer. No claim of any kind, such as "Approved by the Air Resources Board," may be made with respect to the action taken herein in any advertising or other oral or written communication. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE BRAUN CORPORATION‘S FUEL TANK ASSEMBLY. > Violation of any of the above conditions shall be grounds for revocation of this Executive Order. The Executive Order may be revoked only after a ten—day written notice of intention to revoke the Executive Order, in which period the holder ofthe Executive Order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the Executive Order may not be revoked until a determination is made after a hearing that grounds for revocation exist. Executed at El Monte, California, this é day of October 2012. ert, Chief Mobile Source Operations Division THE BRAUN CORPORATION — FUEL.TANK ASSEMBLY — D—449—37


Document Created: 2012-11-02 13:04:07
Document Modified: 2012-11-02 13:04:07

Previous E.O. D-449-36 | Previous E.O. D-448 | Next E.O. D-449-38 | Next E.O. D-450