Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on March 6, 2003.
As of Thursday, December 13th, 2018 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
162002003 GM Hummer H2 6.0L

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-525-1
  • Executive Order 525-1 / D525-1
  • ARB # D-525-1
  • Executive Order No: D-525-1
  • C.A.R.B. No. D-525-1
  • Resolution D-525-1
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-525-1 PDF

D-525-1 Document:



                                                                        t
                                    ‘State of California
                                AIR RESOURCES BOARD                                   a

                              EXECUTIVE ORDER D—525—1

                       Relating to Exemptions Under Section 27156
                                  of the California Vehicle Code

                           Airforce One Performance Industries
                         Airforce One Performance Intake System

Pursuant to the authority vested inthe Air Resources Board by Sectlon 27156 of the
Vehlole Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516
of the Health and Safety Code and Executive Order G—02—003;

IT IS ORDERED AND RESOLVED: That the installation of the Airforce One Performance
Intake System, produced and marketed by Airforce One Performance Industries, 7720 W.
Sierra Hwy, Agua Dulce, California 91350, has been found not to reduce the
effectiveness of the applicable vehicle pollution control systems and, therefore, is exempt
from the prohibitions of Section 27156 of the Vehicle Code for the vehicles listed in
Exhibit A.

The Airforce One Performance Intake System includes the following main components:
open—element cotton gauze air filter, intake system tubing, heat shield (as applicable),
crankcase ventilation hose (as applicable, which may be silicone, and a color other than
black), assorted brackets, and hardware.

This Executive Order is valid provided that the installation instructions for the Airforce One
Performance Industries Airforce One Performance Intake System will not recommend
tuning the vehicle to specifications different from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the Airforce One Performance
Industries Airforce One Performance Intake System, as exempt by the Air Resources
Board, which adversely affect the performance of the vehicle‘s pollution control system
shall invalidate this Executive Order.

This Executive Order shall not apply to any Airforce One Performance Industries Airforce
One Performance Intake System advertised, offered for sale, sold with, or installed on a
new motor vehicle prior to or concurrent with transfer to an ultimate purchaser.

Marketing of the Airforce One Performance Industries Airforce One Performance Intake
System using any. identification other than that shown in this Executive Order or
marketing of the Airforce One Performance Industries Airforce One Performance Intake
.System for an application other than those listed in this Executive Order shall be
prohibited unless prior approval is obtained from the Air Resources Board.


                                                                         o
This Executive Order does not constitute any opinion as to the effect the use of the
Airforce One Performance Industries Airforce One Performance Intake Systems may
have on any warranty either expressed or implied by the vehicle manufacturer.

This Executive Order is granted based on an examination of the On—Board Diagnostic II
(OBD—I1) system of a 2002 model—year GM Suburban (engine family 2GMXAO05.3185,
MDV3, ULEV) in the modified configuration, and an engineering evaluation of the
emissions impact of the device if measured using the Cold—Start CVS—75 Federal Test
Procedure.

If evidence provides the ARB with reason to suspect that the Airforce.One Performance
Intake System will affect the durability of emission control systems, Airforce One
Performance Industries shall be required to submit durability data to show that the
durability of vehicle emission control systems are not, in fact, affected and/or that the
add—on or modified part demonstrates adequate durability.

The ARB reserves the right in the future to review this Executive Order and the exemption
provided herein to assure that the exempted add—on or modified part continues to meet
the standards and procedures of Title 13, California Code of Regulations, Section 2222,
et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF AIRFORCE ONE
PERFORMANCE INDUSTRIES® AIRFORCE ONE PERFORMANCE INTAKE SYSTEM.

No claim of any kind, such as "Approved by the Air Resources Board", may be made with
respect to the action taken herein in any advertising or other oral or written
communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The
order may be revoked only after a ten—day written notice of intention to revoke the order,
in which period the holder of the order may request in writing a hearing to contest the
proposed revocation. If a hearing is requested, it shall be held within ten days of receipt
of the request and the order may not be revoked until a determination is made after the
hearing that grounds for revocation exist.

Executed at El Monte, California, this     @fl/       day of March, 2003.




    ,                            Alle%:s,cmef
                                 Mobile Source Operations Division


AIRFORCE ONE PERFORMANCE INDUSTRIES — AIRFORCE ONE PERFORMANCE INTAKE SYSTEM —
                                    D—525—1


                                            Exhibit A




   MY      Make                     Model                        Engine        P/N

  2003    GM      Hummer H2                                       6.OL         16200

1996—1999 GM      Silverado, Suburban, Tahoe, Yukon, Sierra     5.0, 5.7L      16203
1999—2000 GM      Denali, Escalade                                5.7 L        16203

1996—1999 GM      Silverado, Suburbah, Tahoe, Yukon, Sierra       7A L         16204

                  Silverado, Suburban, Tahhoe, Yukon,
1999—2003 GM      Yukon XL, Denali, Sierra                    4.8, 5.3, 6.0L   16205
2001—2003 GM .    Avalanche                                      5.3, 6.0L     16205
2002—2003 GM      Escalade                                          6.0L       16205

1998—2002 GM      S—10, Jimmy, Blazer                             4.3L         16210



Document Created: 2005-09-01 12:44:20
Document Modified: 2005-09-01 12:44:20

Previous E.O. D-525 | Previous E.O. D-524 | Next E.O. D-525-2 | Next E.O. D-526