Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on February 9, 2016.
As of Friday, October 11th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
See PDFSee PDFSee PDF

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-541-15
  • Executive Order 541-15 / D541-15
  • ARB # D-541-15
  • Executive Order No: D-541-15
  • C.A.R.B. No. D-541-15
  • Resolution D-541-15
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-541-15 PDF

D-541-15 Document:


CARB_D-541-15

                                    State of California
                                AIR RESOURCES BOARD

                              EXECUTIVE ORDER D-541-15

                       Relating to Exemptions Under Section 27156
                                  of the California Vehicle Code

                                     Edge Products
                                  Jammer Cold Air Intake

Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and
Section 39516 of the Health and Safety Code and Executive Order G-14-012;

IT IS ORDERED AND RESOLVED: That the installation of the Jammer Cold Air Intake,
marketed by Edge Products of 1080 South Depot Drive, Ogden, Utah 94404, has been
found not to reduce the effectiveness of the applicable vehicle pollution control systems
and , therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for
the following diesel pickup/truck/SUV applications.

       P/Ns                Model Year    Make                        Engine
       38225, 38225-D      1994-2002     Dodge Ram                   5.9L
       38145, 38145-D      2003-2007     Dodge Ram                   5.9L
       38175, 38175-D      2007-2009     Dodge Ram                   6.7L
       38180 , 38180-D     2010-2014     Dodge Ram                   6.7L
       18210, 18210-D      1999-2003     Ford                        7.3L
       18155, 18155-D      2003-2007     Ford                        6.0L
       18185, 18185-D      2008-2010     Ford                        6.4L
       18215, 18215-D      2011-2015     Ford                        6.7L
       28132, 28132-D      2001-2004     General Motors              6.6L
       28135, 28135-D      2004-2005     General Motors              6.6L
       28142, 28142-D      2006-2007     General Motors              6.6L
       28172, 28172-D      2007-2010     General Motors              6.6L
       28220, 28220-D      2011-2012     General Motors              6.6L
       28230, 28230-D      2013-2014     General Motors              6.6L
       28248, 28248-D         2015       General Motors              6.6L

The Jammer Cold Air Intake includes the following main components: reusable air filter,
new air filter enclosure, super-scoop (optional) , intake system tubing, and assorted
brackets and hardware. Installation of the Air Intake System requires the removal of
the stock air filter housing and all intake air tubing. If the stock air filter housing
contains the vehicle's tune-up & emissions control decal, a replacement decal must
be placed in a similar location.

This Executive Order is valid provided the installation instructions for the Jammer Cold Air
Intake wi ll not recommend tuning the vehicle to specifications different from those of the
vehicle manufacturer.

Changes made to the design or operating conditions of the Jammer Cold Air Intake, as
exempt by the Air Resources Board , which adversely affect the performance of the
vehicle's pollution control system shall invalidate this Executive Order.

Marketing of the Jammer Cold Air Intake using any identification other than that shown in
this Executive Order; or marketing of the Jammer Cold Air Intake for an application other


                                                2.


than those listed in this Executive Order shall be prohibited unless prior approval is
obtained from the Air Resources Board.

This Executive Order shall not apply to any Jammer Cold Air Intake advertised , offered fo r
sale, sold with , or installed on a new motor vehicle prior to or concurrent with transfer to an
ultimate purchaser.

This Executive Order does not constitute any opinion as to the effect the use of the
Jammer Cold Air Intake may have on any warranty either expressed or implied by the
vehicle manufacturer.

This Executive Order is granted based on prior submitted OBD II testing on a 2008 model
year 6.7L diesel Dodge Ram and a 6.4L diesel Ford F-250, and emissions and OBD II test
data that was generated in support of Executive Orders D-161-80 and D-161-81 . The test
vehicles were a 2006 model year 4.0L gasoline Jeep Wrang ler, certified to the Low
Emission Vehicle I Ultra Low Emission Vehicle (LEV I ULEV) emission standards and a
2007 model year 5.4L gasoline Ford F-150 and 5.3L Chevrolet Tahoe, both certified to the
Low Emission Vehicle II Ultra Low Emission Vehicle (LEV II ULEV) and all modified with
the Jammer Cold Air Intake.

The Air Resources Board reserves the right in the future to rev iew this Executive Order
and the exemption provided herein to assure that the exempted add-on or mod ified part
continues to meet the standards and procedures of Title 13, Californ ia Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION ,
ACCREDITATION , APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERN ING
ANTI-POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF EDGE PRODUCTS'
JAMMER COLD AIR INTAKE.

No claim of any kind , such as "Approved by the Air Resources Board", may be made with
respect to the action taken herein in any advertising or other oral or written
communication .

Violation of any of the above conditions shall be grounds for revocation of th is order. The
order may be revoked only after a ten-day written notice of intention to revoke the order, in
which period the holder of the order may request in writing a hearing to contest the
proposed revocation. If a hearing is requested , it shall be held within ten days of receipt of
the request and the order may not be revoked until a determination is made after the
hearing that grounds for revocation exist.

Executed at El Monte, California, this _ ____;9:....___ _ day of February 2016.




              Annette Hebert, Chief
              Emissions Compliance, Automotive Regu lations an d Science Division



             EDGE PRODUCTS- JAMMER COLD AIR INTAKE- D-541-15



Document Created: 2016-03-24 15:13:34
Document Modified: 2016-03-24 15:13:34

Previous E.O. D-541-14 | Previous E.O. D-540 | Next E.O. D-541-16 | Next E.O. D-542