Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on July 3, 2013.
As of Wednesday, November 27th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
46-100112003-2007 Dodge Ram pick-up truck, Diesel 5.9L L6 Cummins

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-550-10
  • Executive Order 550-10 / D550-10
  • ARB # D-550-10
  • Executive Order No: D-550-10
  • C.A.R.B. No. D-550-10
  • Resolution D-550-10
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-550-10 PDF

D-550-10 Document:

CARB_D-550-10

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D-550-1 0 Relating to Exemptions Under Section 27156 of the California Vehicle Code Advanced Flow Engineering BladeRunner Charged Air Manifold Pursuant to the authority vested in the Air Resources Board (ARB) by Section 27156 of the Vehicle Code ; and Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and Safety Code and Executive Order G-02-003 ; IT IS ORDERED AND RESOLVED : That the installation of the BladeRunner Charged Air Manifold , manufactured and marketed by Advanced Flow Engineering , 252 Granite Street, Corona , CA 92879 , has been found not to reduce the effectiveness of the applicable vehicle pollution control systems and , therefore , is exempt from the prohibitions of Section 27156 of the Vehicle Code for the diesel pick-up trucks listed below. Part No. Model-Year MFR Model Enqine Diesel 5.9L L6 46-10011 2003-2007 Dodge Ram pick-up truck Cummins Diesel 5.9L L6 46-10021 1998-2002 Dodge Ram pick-up truck Cummins F-series pick-up Diesel 6.0 L V8 Power 46-10031 2003-2004 Ford truck Stroke F-series pick-up . Diesel 6.0 L V8 Power 46-10041 2005-2007 Ford truck Stroke Diesel 5.9L L6 46-10051 1994-1998 Dodge Ram pick-up truck Cummins F-series pick-up Diesel 7.3 L V8 Power 46-10061 1999-2003 Ford truck Stroke The BladeRunner Charged Air Manifold is installed in place of the stock intake man ifold inlet. Installation consists of removal of the existing intake manifold inlet and replacement with the BladeRunner Charged Air Manifold. Design of the part is for increased flow into the intake ports of the engine for the purpose of increased vehicle performance . This Executive Order is valid provided that the installation instructions for the BladeRunner Charged Air Manifold will not recommend tuning the vehiGie to specifications different from those of the vehicle manufacturer.

-2- Changes made to the design or operating conditions of the BladeRunner Charged Air Manifold , as exempt by ARB , which adversely affect the performance of the vehicle's pollution control system shall invalidate this Executive Order. Marketing of the BladeRunner Charged Air Manifold using any identification other than that shown in this Executive Order or marketing of the BladeRunner Charged Air Manifold for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. This Executive Order does not constitute any opinion as to the effect the use of the BladeRunner Charged Air Manifold may have on any warranty either expressed or implied by the vehicle manufacturer. This Executive Order is granted based on engineering evaluation , comparative Supplemental Federal Test Procedure testing and On-Board Diagnostic II (OBD II ) system testing conducted at an independent laboratory using a 2005 model-year 5.9L Dodge Ram pick-up truck (test group 5CEXA0359BAE , LEV1 ULEV). ARB reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add-on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations , Section 2222 , et seq. Further, if test results or other evidence provides ARB with reason to suspect that the BladeRunner Charged Air Manifold will affect the durability of emission control systems, Advanced Flow Engineering shall be required to submit durability data to show that the durability of vehicle emission control systems are not, in fact, affected and/or that the add-on or modified part demonstrates adequate durability. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION , ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI-POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE ADVANCED FLOW ENGINEERING BLADERUNNER CHARGED AIR MANIFOLD. No claim of any kind , such as "Approved by the Air Resources Board" , may be made with respect to the action taken herein in any advertising or other oral or written communication . Advanced Flow Engineering - BladeRunner Charged Air Manifold- D-550-1 0

Vielation of any of the above conditions shall be grounds for revacation of this order. The order may be revoked only after a ten—day written noticeof intention to revoke the order, in which period the holder of the order may request in wriing a hearing to contest the proposed revocation. If a hearing is requested, t shall be held within ten days of receipt of the request and the order may not be revoked unta determination is made after the hesring that grounds for revocation exist J Executed at E1 Monte, California, this ___3""__ day of July 2013. AS vaill rik White, Chiet @%lobi\e Source Operations Division Advanced Flow Engineering — BladeRunner Charged Air Manifold — D—550—10


Document Created: 2013-08-20 11:01:14
Document Modified: 2013-08-20 11:01:14

Previous E.O. D-550-9 | Previous E.O. D-549 | Next E.O. D-550-11 | Next E.O. D-551