Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 28, 2017.
As of Thursday, December 26th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
75-50532011-2016: FORD 6.7L F-250/350 Super Duty (2WD/4WD)
75-5053D2011-2016: FORD 6.7L F-250/350 Super Duty (2WD/4WD)
75-50542008-2010: FORD 6.4L F-250/350 Super Duty (2WD/4WD)
75-5054D2008-2010: FORD 6.4L F-250/350 Super Duty (2WD/4WD)

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-590-13
  • Executive Order 590-13 / D590-13
  • ARB # D-590-13
  • Executive Order No: D-590-13
  • C.A.R.B. No. D-590-13
  • Resolution D-590-13
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-590-13 PDF

D-590-13 Document:


CARB_D-590-13

                                 State of California
                        CALIFORNIA AIR RESOURCES BOARD

                              EXECUTIVE ORDER D—590—13

                       Relating to Exemptions Under Section 27156
                               of the California Vehicle Code

                                         S&B Filters
                                   Cold Air Intake System

Pursuant to the authority vested in the California Air Resources Board by Section 27156
of the Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section
39516 of the Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That the installation of the Cold Air Intake System,
produced and marketed by S&B Filters of 15461 Slover Avenue, Fontana, California
92337, has been found not to reduce the effectiveness of the applicable vehicle
pollution control systems and, therefore, is exempt from the prohibitions of Section
27156 of the Vehicle Code for the vehicles listed in Exhibit A.

The Cold Air Intake System includes the following main components: An open—element
air filter (either an oiled reusable or a dry disposable), heat shield (as applicable), intake
system tubing, crankcease ventilation hose (as applicable, which may be silicone, and a
color other than black), assorted brackets, and hardware.

This Executive Order is valid provided that the installation instructions for the Cold Air
Intake System will not recommend tuning the vehicle to specifications different from
those of the vehicle manufacturer.

Changes made to the design or operating conditions of the Cold Air Intake System, as
exempt by the California Air Resources Board, which adversely affect the performance
of the vehicle‘s pollution control system shall invalidate this Executive Order.

This Executive Order shall not apply to any Cold Air Intake System advertised, offered
for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer
to an ultimate purchaser.

Marketing of the Cold Air Intake System using any identification other than that shown in
this Executive Order or marketing of the Cold Air Intake System for an application other
than those listed in this Executive Order shall be prohibited unless prior approval is
obtained from the California Air Resources Board.


                                              Jg;

This Executive Order does not constitute any opinion as to the effect the use of the Cold Air
Intake System units may have on any warranty either expressed or implied by the vehicle
manufacturer.

This Executive Order is granted based on previous emission tests, in the modified
configuration (Executive Order D—590—9), using the Cold—Start Federal Test Procedure and
an examination of the On—Board Diagnostic II (OBD II) system. A 2015 Ford 6.7L F—250
(FFMXD06.71B, LEV—II ULEV) was used for the evaluation of the Cold Air Intake System.
Results from emissions testing conducted at the Automotive Testing and Development
Services, are shown below (in grams per mile):

                                    2015 Ford 6.7L F—250

FIP                  120k         NMHC         Co        NOx       PM
                Emission Level    0.042        0.21      0.17      0.012
          (w. DF & DAF applied)
                     STD           0.143       6.4       0.2       0.06

The emission test results, in the modified configuration, were below the applicable
certification standards. Examination of the OBD II system showed the Cold Air Intake
System does not affect OBD II operation.

If evidence provides the ARB with reason to suspect that the Cold Air Intake System will
affect the durability of emission control systems, S&B Filters shall be required to submit
durability data to show that the durability of vehicle emission control systems is not affected
and/or that the add—on or modified part demonstrates adequate durability.

The ARB reserves the right, in the future, to review this Executive Order and the
exemption, provided herein, to assure that the exempted add—on or modified part continues
to meet the standards and procedures of Title 13, California Code of Regulations, Section
2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
CALIFORNIA AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT
CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF S&B
FILTERS‘ COLD AIR INTAKE SYSTEM.

No claim of any kind, such as "Approved by the California Air Resources Board", may be
made with respect to the action taken herein in any advertising or other oral or written
communication.




            S&B FILTERS, INC. COLD AIR INTAKE SYSTEM KITS — D—590—13


                                              3+

Violation of any of the above conditions shall be grounds for revocation of this order. The
order may be revoked only after a ten—day written notice of intention to revoke the order, in
which period the holder of the order may request in writing a hearing to contest the
proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of
the request and the order may not be revoked until a determination is made after the
hearing that grounds for revocation exist.

Executed at El Monte, California, this    o?g A day of September 2017.




                      aiyp’lf/mw/
            _ zgAnnette Hebert, Chief
                    issions Compliance, Automotive Regulations and Science Division




            S&B FILTERS, INC. COLD AIR INTAKE SYSTEM KITS — D—590—13


                                                                     (Page 1 of 1)



                            ATTACHMENT A

                COLD AIR INTAKE SYSTEM KITS
             Model                                                       Engine
  PN         Years      Make                   Mode‘s                 Displacement


 75—5104
75—5104D   2011—2016    FORD__|_   F—250/350 Super Duty (2WD/MAWD)         6.7L
                                                                            #

 75—5105
75—5105D   2008—2010    FORD       F—250/350 Super Duty (2WD/MAWD)         6.AL
                                                                            _




           S&B FILTERS, INC. COLD AIR INTAKE SYSTEM KITS — D—590—13



Document Created: 2017-10-10 11:38:52
Document Modified: 2017-10-10 11:38:52

Previous E.O. D-590-12 | Previous E.O. D-589 | Next E.O. D-590-14 | Next E.O. D-591