Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on December 14, 2016.
As of Wednesday, December 19th, 2018 this Executive Order has not been overturned or superceeded.

Approved Parts

Part Number
see pdf

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-701-19
  • Executive Order 701-19 / D701-19
  • ARB # D-701-19
  • Executive Order No: D-701-19
  • C.A.R.B. No. D-701-19
  • Resolution D-701-19
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-701-19 PDF

D-701-19 Document:



                                   State of California
                              AIR RESOURCES BOARD

                            EXECUTIVE ORDER D—701—19

                     Relating to Exemptions Under Section 27156
                                of the California Vehicle Code

                           Pacific Performance Engineering
                         PPE Exhaust Manifolds and Up—Pipes


Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section
39516 of the Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That the installation of the PPE Exhaust Manifolds
and Up—Pipes, manufactured and marketed by Pacific Performance Engineering, 303
North Placentia Avenue, Fullerton, California 92831, has been found not to reduce the
effectiveness of the applicable vehicle pollution control systems and, therefore, is
exempt from the prohibitions of Section 27156 of the Vehicle Code for the following
General Motors 6.6L diesel engine applications:

Part Number                Application

116111000                  2001 to 2004 model year Non—EGR Equipped Engines
116111200                  2002 to 2004 model year EGR Equipped Engines
116111400                  2004.5 to 2005 model year EGR Equipped Engines
116111600                  2006 to 2007 model year EGR Equipped Engines
116111800                  2007.5 to 2010 model year EGR Equipped Engines
116112000                  2011 to 2016 model year EGR Equipped Engines

The High Flow Exhaust Manifolds with Up—Pipes is a cast iron exhaust manifold with left
and right up—pipes only. Installation consists of the removal of the existing exhaust
manifold and up—pipes and replacing them with PPE‘s Exhaust Manifolds and
Up—Pipes. No changes are made to any component of the stock engine, including
engine calibration.                                        ‘

This Executive Orderis valid provided that the installation instructions for the PPE
Exhaust Manifolds and Up—Pipes will not recommend tuning the vehicle to specifications
different from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the PPE Exhaust Manifolds and
Up—Pipes, as exempt by the Air Resources Board, which adversely affect the
performance of the vehicle‘s pollution control system shall invalidate this Executive
Order.

Marketing of the PPE Exhaust Manifolds and Up—Pipes using any identification other
than that shown in this Executive Order or marketing of the PPE Exhaust Manifolds and
Up—Pipes for an application other than those listed in this Executive Order shall be
prohibited unless prior approval is obtained from the Air Resources Board.


                                             «Js


This Executive Order does not constitute any opinion as to the effect the use of the
PPE Exhaust Manifolds and Up—Pipes may have on any warranty either expressed or
implied by the vehicle manufacturer.

This Executive Order is granted based on a prior engineering evaluation and
comparative Supplemental Federal Test Procedure USO6 and SC03 tests and
On—Board Diagnostic II (OBD II) system test conducted at an independent laboratory
using a 2007 model year 6.6L Chevrolet K2500 diesel truck (test group 7GMXHO6.690).

The Air Resources Board reserves the right in the future to review this Executive Order
and the exemption provided herein to assure that the exempted add—on or modified part
continues to meet the standards and procedures of Title 13, California Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE PPE EXHAUST
MANIFOLDS AND UP—PIPES.

No claim of any kind, such as "Approved by the Air Resources Board", may be made
with respect to the action taken herein in any advertising or other oral or written
communication.

Violation of any of the above conditions shall be grounds for revocation of this order.
The order may be revoked only after a ten—day written notice of intention to revoke the
order, in which period the holder of the order may request in writing a hearing to contest
the proposed revocation. If a hearing is requested, it shall be held within ten days of
receipt of the request and the order may not be revoked until a determination is made
after the hearing that grounds for revocation exist.

Executed at El Monte, California, this     Z 7{      day of December 2016.



                                  Alet
              Annette Hebert, Chief
              Emissions Compliance, Automotive Regulations and Science Division




PACIFIC PERFORMANCE ENGINEERING — MANIFOLDS AND UP—PIPES —D—701—19



Document Created: 2017-01-20 17:02:00
Document Modified: 2017-01-20 17:02:00

Previous E.O. D-701-18 | Previous E.O. D-700 | Next E.O. D-701-20 | Next E.O. D-702