Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on December 18, 2013.
As of Tuesday, November 26th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
see pdfsee pdfsee pdf

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-701-4
  • Executive Order 701-4 / D701-4
  • ARB # D-701-4
  • Executive Order No: D-701-4
  • C.A.R.B. No. D-701-4
  • Resolution D-701-4
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-701-4 PDF

D-701-4 Document:


CARB_D-701-4

                                     State of California
                                AIR RESOURCES BOARD

                              EXECUTIVE ORDER D—701—4

                      Relating to Exvemvptions Under Section 27156
                                 of the California Vehicle Code

                             Pacific Performance Engineering
                               3" Stainless Steel Down Pipe


Pursuant to the authorlty vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersngned by Section 39515and Sectlon
39516 of the Health and Safety Code and Executive Order G—02—003;

IT ISs ORDERED AND RESOLVED That the installation of the 3" Stainless Steel Down
Pipe, manufactured and marketed by Pacific Performance Engineering, 303 North
Placentia Avenue, Fullerton, California 92831, has been found not to reduce the
effectiveness of the apphcable vehicle pollutlon control systems and, therefore, is
exempt from the prohibitions of Section 27156 of the Vehicle Code— for the followmg
2001 to 2013 model year General Motors plckups equipped with a 6. 6L diesel englne

Part Number         Apghcatlo
117000400           2001 to 2004
117000500           2004.5 to 2010
117000600           2011 to 2013

The 3" Stainless Steel Down Pipe is a direct replacement stainless steel down pipe
that is attached to the exhaust output of the stockturbocharger and the vehicle‘s
under floor exhaust system. The stock downpipe and the 3" Stainless Steel Down
Pipe share the same construction material, metal gage, interior volume, length, and
port size, the only difference is the stock pipe is square in the middle section and the   I
3" Stainless Steel Down Pipe is round throughout. The 3" Stainless Steel Down
Pipe has no mechanical or electrical user adjustments. No changes are made
to any component of the stock engine for installation, including engine
calibration, turbocharger, or any other component of the exhaust system.

This Executive Order is valid provided that the instailation instructions for the 3"
Stainless Steel Down Pipe will not recommend tuning the vehicle to specifications
different from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the 3" Stainless Steel Down
Pipe as exempt by the Air Resources Board, which adversely affect the performance of
the vehicle‘s pollution control system shall invalidate this Executive Order.


                                                2.


  Marketing of the 3" Stainless Steel Down Pipe using any identification other than that
  shown in this Executive Order or marketing of the 3" Stainless Steel Down Pipe for an
  application other than those listed in this Executive Order shall be prohibited unless
  prior approval is obtained from the Air Resources Board.

  This Executive Order does not constitute any opinion as to the effect the use of the
  3" Stainless Steel Down Pipe may have on any warranty either expressed or implied by
  the vehicle manufacturer.

  This Executive Order is granted based on an engineering evaluation and information
  supplied by Pacific Performance Engineering on the 3" Stainless Steel Down Pipe.
  Comparisons made between the stock and modified part demonstrated similarity in
  material type, port size, and basic design.

  The Air Resources Board reserves the right in the future to review this Executive Order
  and the exemption provided herein to assure that the exempted add—on or modified part
  continues to meet the standards and procedures of Title 13, California Code of
  Regulations, Section 2222, et seq.

 THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,    _
 ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
 AIR RESOURCES BOARD OF ANY CLAIMS OFTHE APPLICANT CONCERNING
 ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE 3" STAINLESS
 STEEL DOWN PIPE.

._ No claim of any kind, such as "Approved by the Air Resources Board", may be made
   with respect to the actlon taken herein in any advertising or other oral or written
  communication.

 Violation of any of the above conditions shall be grounds for revocation of this order.
 The order may be revoked only after a ten—day written notice of intention to revoke the
 order, in which period the holder of the order may request in writing a hearing to contest
 the proposed revocation. If a hearing is requested, it shall be held within ten days of
 receipt of the request and the order may not be revoked until a determlnatlonis made
 after the hearing that grounds for revocation exist.

 Executed at El Monte, California, this        18 * day of December 2013.


                                          rik White, Chief
                                 C%Mebfle Source Operations Division




           PACIFIC PERFORMANCE ENGINEERING — DOWN PIPE —D—701—4



Document Created: 2014-01-28 16:46:38
Document Modified: 2014-01-28 16:46:38

Previous E.O. D-701-3 | Previous E.O. D-700 | Next E.O. D-701-5 | Next E.O. D-702