Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 12, 2014.
As of Tuesday, November 26th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part Number
see pdf

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-701-8
  • Executive Order 701-8 / D701-8
  • ARB # D-701-8
  • Executive Order No: D-701-8
  • C.A.R.B. No. D-701-8
  • Resolution D-701-8
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-701-8 PDF

D-701-8 Document:


CARB_D-701-8

                                   State of California
                               AIR RESOURCES BOARD

                              EXECUTIVE ORDER D—701—8

                      Relating to Exemptions Under Section 27156
                                 of the California Vehicle Code

                             Pacific Performance Engineering
                            Ford OEM Replacement Up—Pipes


Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516
of the Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That the installation of the Ford OEM Replacement
Up—Pipes, manufactured and marketed by Pacific Performance Engineering, 303 North
Placentia Avenue, Fullerton, California 92831, has been found not to reduce the
effectiveness of the applicable vehicle pollution control systems and, therefore, is exempt
from the prohibitions of Section 27156 of the Vehicle Code for the following trucks
equipped with a Ford diesel engine.

Part Number          Model—Year           Displacement

316119503            2003 and 2004              6.OL
316119504            2004 to 2007               6.0L

The Ford OEM Replacement Up—Pipes are a direct replacement stainless steel pipe
that is attached between the exhaust manifolds and turbocharger inlet, the pipes Y
together at the turbocharger inlet, same as stock. The EGR port is located on the
up—pipes. The stock up—pipes and the Ford OEM Replacement Up—Pipes share the
same construction material, metal gage, interior volume, length, and port size. Retains
all stock connections, requires no modifications for installation. The Ford OEM
Replacement Up—Pipes has no mechanical or electrical user adjustments. No
changes are made to any component of the stock engine for installation,
including engine calibration, turbocharger, or any other component of the
exhaust system.

This Executive Order is valid provided that the installation instructions for the Ford OEM
Replacement Up—Pipes will not recommend tuning the vehicle to specifications different
from those of the vehicle manufacturer.

Changes made to the design or operating conditions of the Ford OEM Replacement
Up—Pipes as exempt by the Air Resources Board, which adversely affect the performance
of the vehicle‘s pollution control system shall invalidate this Executive Order.

Marketing of the Ford OEM Replacement Up—Pipes using any identification other than
that shown in this Executive Order or marketing of the Ford OEM Replacement


                                             e


Up—Pipes for an application other than those listed in this Executive Order shall be
prohibited unless prior approval is obtained from the Air Resources Board.

This Executive Order does not constitute any opinion as to the effect the use of the
Ford OEM Replacement Up—Pipes may have on any warranty either expressed or
implied by the vehicle manufacturer.

This Executive Order is granted based on an engineering evaluation and information
supplied by Pacific Performance Engineering on the Ford OEM Replacement Up—Pipes.
Comparisons made between the stock and modified part demonstrated similarity in
material type, port size, and design.

The Air Resources Board reserves the right in the future to review this Executive Order
and the exemption provided herein to assure that the exempted add—on or modified part
continues to meet the standards and procedures of Title 13, California Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE FORD OEM
REPLACEMENT UP—PIPES.

No claim of any kind, such as "Approved by the Air Resources Board", may be made
with respect to the action taken herein in any advertising or other oral or written
communication.

Violation of any of the above conditions shall be grounds for revocation of this order.
The order may be revoked only after a ten—day written notice of intention to revoke the
order, in which period the holder of the order may request in writing a hearing to contest
the proposed revocation. If a hearing is requested, it shall be held within ten days of
receipt of the request and the order may not be revoked until a determination is made
after the hearing that grounds for revocation exist.

Executed at El Monte, California, this      l Z      day of September 2014.




              Annette Hebert, Chief
              Emissions Compliance, Automotive Regulations and Science Division




           PACIFIC PERFORMANCE ENGINEERING — UP—PIPES —D—701—8



Document Created: 2014-09-15 16:42:37
Document Modified: 2014-09-15 16:42:37

Previous E.O. D-701-7 | Previous E.O. D-700 | Next E.O. D-701-9 | Next E.O. D-702