Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on April 26, 2013.
As of Wednesday, June 19th, 2019 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
see pdfsee pdfsee pdf

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-707
  • Executive Order 707 / D707
  • ARB # D-707
  • Executive Order No: D-707
  • C.A.R.B. No. D-707
  • Resolution D-707
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-707 PDF

D-707 Document:


State of California AIR RESOURCES BOARD 4 EXECUTIVE ORDER D—707 Relatmg to Exemptlons Under Sectlon 217156 of the California Vehlcle Code A&A Corvette Performance Ltd _ A&A Corvette Performance Supercharger _ Pursuanf to the aut‘hbrity' vested in the Air Resources Board by S_ection 27156 ef the Vehicle Code; and . . Pursuant to the authorify vested ih the undersigned by Section 39515 énd Section 39516 of the Health and Safety Code and Executive Order G—02—003; — IT IS ORDERED AND RESOLVED: That the installation of the A&A Corvette Performance Supercharger, manufactured and marketed by A&A Corvette Performance Ltd., 477 Lambert Street, Unit A, Oxnard, Callfornra 93036, has been found not to reduce \the effectlveness of the applicable vehrcle pollution control systems and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for the followmg 1997 ~ . to 2013 model year Chevrolet Corvettes: & Model Year Engine Displacement_ Kit Part Number .. SC Pulley Diameter _ 1997 to 2000 — _ . §.7L > AA—9700 22 3.8". 2001 to 2004 — S5.7ZL . AA—0104 3.8" 2005 to 2007 6.0L . AA—0507 ~4.0" 2008 to 2013 _ 6.2L ~ AA—0812 . o_ 4.0" 2006 to 2013 C 7.0L | : AA—06122 . 200 4.0" The A&A Corvette Performance Supercharger consrsts of the followrng main _ _ _components: Vortech V2SI centrifugal supercharger with either a 3.8 or 4.0 inch diameter pulley using the stock 7.25 inch diameter crankshaft pulley, intercooler, supercharger by—pass valve, air filter and plastic inlet duct (2008 and newer Corvette applications use the General Motors Corvette carbon adsorber pad in inlet duct) , ECU upgrade without user adjustments, replacement high flow fuel injectors, crankshaft pinning kit, and voltage booster for factory fuel pump. The stock radiator thermostat is . retained and nochanges are made to any fuel hose. The PCV breather hose may be _ replaced or modified with an SAE30R9 rated hose or a General Motors replacement equivalent. Maximum boost is 7 psi. ' — This Executive Order is valid provided that the installation instructions for the A&A : Corvette Performance Supercharger will not recommend tuning the vehicle to specifications. different from those of the kit manufacturer. Changes made to the design or operating conditions of the A&A Corvette Performance Supercharger, as exempt by the Air Resources Board, which adversely affect the performance of the vehlclespollution control system shall invalidate this Executive . ‘Order.

This Executive Order is granted based on submitted emission test data generated on one test vehicle modified with the A&A Corvette Performance Supercharger. Test results showed that emission levels, with the supercharger kit installed, met the applicable emission standards when tested using the Cold—Start CVS—75 Federal Test Procedure (FTP) test cycle and the Supplemental Federal Test Procedure (SFTP USO6/SC03) test cycle. Examination of the OBD II system showed that the supercharger kit did not affect OBD II system operation. Results from emissions testing conducted at Quantum Technologies, located at Lake Forest, California, are shown below, in grams per mile, with deterioration factors (df) applied. 2012 model year 6.2L Corvette CVS—75 FTP NMOG CO .NOx HCHO Standards, Useful Life 0.070 2.1 0.04 0.011 Device Test w/df 0.034 1.0 0.02 0:000 USO6/SC03 NMHC+NOx CO Standards 4k 0.14/0.20 8.0/2.7 Device 0.05/0.01 1.0/0.6 The Air Resources Board reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add—on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222, et seq. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE A&A¥ CORVETTE PERFORMANCE SUPERCHARGER. This Executive Order shall not apply to any A&A Corvette Performance Supercharger advertised, offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer to an ultimate purchaser. | Marketing of the A&A Corvette Performance Supercharger using any identification other than that shown in this Executive Order or marketing of the A&A Corveftte Performance Supercharger for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action taken herein in any advertising or other oral or written communication. A&A CORVETTE PERFORMANCE LTD.—CORVETTE SUPERCHARGER —D—707

Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contestthe proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. . Executed at El Monte, California, this web 4 day of April 2013. Erik White, Chief . %obile Source Operations Division ‘A&A CORVETTE PERFORMANCE LTD.—CORVETTE SUPERCHARGER —D—707



Document Created: 2013-07-23 17:22:16
Document Modified: 2013-07-23 17:22:16

| Previous E.O. D-706 | Next E.O. D-707-1 | Next E.O. D-708