Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on March 29, 2016.
As of Monday, December 17th, 2018 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
See PDFSee PDF

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-761
  • Executive Order 761 / D761
  • ARB # D-761
  • Executive Order No: D-761
  • C.A.R.B. No. D-761
  • Resolution D-761
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-761 PDF

D-761 Document:



                                     State of California
                                 AIR RESOURCES BOARD

                                 EXECUTIVE ORDER D—761

                        Relating to Exemptions Under Section 27156
                                   of the California Vehicle Code

                                       JLT Performance
                                       JLT Air Intake Kit

Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of
the Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That the installation of the JLT Air Intake Kit,
manufactured and marketed by JLT Performance, 1008 Executive Boulevard, Chesapeake,
Virginia 23320, has been found not to reduce the effectiveness of the applicable vehicle
pollution control systems and, therefore, is exempt from the prohibitions of Section 27156
of the Vehicle Code for the following Ford vehicles listed in Exhibit A.

The Air Intake Systems consists of the following main components: Open or closed
element air filter, air intake tubing from throttle body to filter, and all necessary mounting
hardware for proper installation. The stock manifold air pressure sensor is retained in its
stock location and orientation. Installation of the Air Intake System requires the
removal of the stock air filter housing and all intake air tubing. If the stock air filter
housing contains the vehicle‘s tune—up & emissions control decal, a replacement
decal must be placed in a similar location.

This Executive Order is valid provided that the installation instructions for the JLT Air Intake
Kit will not recommend tuning the vehicle to specifications different from those of JLT
Performance.

Changes made to the design or operating conditions of the JLT Air Intake Kit, as exempt by
the Air Resources Board, which adversely affect the performance of the vehicle‘s pollution
control system shall invalidate this Executive Order.

This exemption is issued based on submitted emissions test data, from the SEMA Garage,
Diamond Bar, California, on a 2015 model year Ford 2.3L Turbo Mustang certified to the
LEV 3 ULEV 70 emission standards and tested using the Cold—Start CVS—75 Federal Test
Procedure (FTP) test cycle and the Supplemental Federal Test Procedure
(SFTP USO6/SC03) test cycle.


Useful Life FTP     NMOG+NOx              Co          HCHO
Emission Level
(w/ df applied)         0.063             9.3         0.000

     Standards          0.070             17          0.004


Useful Life SFTP            NMOG+NOx            CO
Emission Level
(Composite w/ df)               0.03            0.3

     Standards                  0.11            4.2

Test results showed that the JLT Air Intake Kit when installed on the vehicle did not cause
exhaust emissions to exceed the applicable emission standards during the FTP and SFTP.
This Executive Order is also based on the On—Board Diagnostic II (OBD 1I) testing
conducted on the same test vehicle. The JLT Air Intake Kit when installed on the test
vehicle did not affect the vehicle‘s ability to perform its OBD II monitoring.

The Air Resources Board reserves the right in the future to review this Executive Order and
the exemption provided herein to assure that the exempted add—on or modified part
continues to meet the standards and procedures of Title 13, California Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE
JLT AIR INTAKE KIT.

No claim of any kind, such as "Approved by the Air Resources Board", may be made with
respect to the action taken herein in any advertising or other oral or written communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The
order may be revoked only after a ten—day written notice of intention to revoke the order, in
which period the holder of the order may request in writing a hearing to contest the
proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of
the request and the order may not be revoked until a determination is made after the
hearing that grounds for revocation exist.
                                                 %.
Executed at El Monte, California, this    __e2 7 —__ day of March 2016.



                     gfimfléwu’
                        nnette Hebert, Chief
                  K7€‘<Emissions Compliance, Automotive Regulations and Science Division




                    JLT PERFORMANCE — JLT AIR INTAKE KIT — D—761


                                                              Exhibit A


      PN                           Product                      Year      Make             Vehicle                Engine
  CAI—FME—15                    Air Intake Kit                2015—16|     Ford            Mustang              2.3L Turbo
 CAI—FMV6—15                    Air Intake Kit                2015—16|     Ford            Mustang                3.7L NA
 CAI—FMV6—11                    Air Intake Kit                2011—14|    Ford             Mustang               3.7L NA
JLTIK—GT500—10                  Induction Kit                 2010—14|    Ford         Mustang GT500            5.4/5.8L SC

CAI2—FMM—0304       |Air Intake Kit (filter in fenderwel!)

                                                              2003—04|]   Ford       Mustang GT (Mach 1          4.6L NA
RAIZ—FMM—0304       Air Intake Kit (filter under hood)                                      e  (        )

 BK—FMM—0304          Air Intake Kit— Filter and Heat
CAI2—FMC—0304       |Air Intake Kit (filter in fenderwell)

    Al2—FMC—0304     Air Intake Kit (filt        der   hood
$                     i Intake Ki {filteruader B660) yuusol               Forg          Mustang Cobra             4.6L SC
BK—FMCGB—9604           i Intake
                      Air     ke Kit—
                                   | Filt
                                       ilter and d Heat
                                                    Hea
                                 Shield only

CAI2—FMC—9901       |Air Intake Kit (filter in fenderwell)
                                                              1999—01|    Ford          Mustang Cobra             4.6L NA
RAIZ—FMC—9901        Air Intake Kit (filter under hood)


CAI2—FMC—9698       |Air Intake Kit (filter in fenderwell)
                                                              1996—98|     Ford         Mustang Cobra             4.6L NA
 RAIZ—FMC—9698       Air Intake Kit (filter under hood)

                    Air Intake Kit (filter in fenderwell)
        —FMB—O1
    EAlz—FM                                                     2001       Ford       Mustang GT (Bullitt)        4.6L NA
    RAIZ—FME—O1      Air Intake Kit (filter under hood)

CAI2—FMG—9604       |Air Intake Kit (filter in fenderwell)
                                                              1996—04|     Ford           Mustang GT              4.6L NA
 RAIZ—FMG—9604       Air Intake Kit (filter under hood)

RAI—FMMA—0304                   Air Intake Kit                2003—04|     Ford       Mercury Marauder            4.6L NA


JLT—CV@MTC—9403       Air Intake Kit (filter and air box                            Crown Vict‘oriaf Mercury
                                     only)                                        Grand Marquis, Lincoln Town
                                                              1993—03|     Ford    Car (2003 w/ external IAT)     4.6L NA
                                                                                    Crown Victoria, Mercury
                      Air Intake Kit (filter and air box                          Grand Marquis, Lincoln Town
JLT—CVGMTC—0304                      only)                    2003—04|     Ford               Car                 4.6L NA
    BAI2—FL—9904                 Air Intake Kit
                         —           ——                                              F—150 Lightning, Harley
                                ke Kit (Filt    d heat        |1999—04]    Ford                                    t
     Brugagy           Altiniakesheild
                                   HtOlierand
                                       only)
                                              has                                     Davidson (2002—03)          5.4LSC
    RAI—FEF—9703                Air Intake Kit                1997—03|     Ford        F—150, Expedition        4.6/5.4L NA
    CAl—F15050—15               Air Intake Kit                2015—16|     Ford              F—150                5.0L NA





Document Created: 2016-05-02 16:30:59
Document Modified: 2016-05-02 16:30:59

| Previous E.O. D-760 | Next E.O. D-761-1 | Next E.O. D-762