Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on October 11, 2016.
As of Monday, December 10th, 2018 this Executive Order has not been overturned or superceeded.

Approved Parts

Part Number
See PDF

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-761-1
  • Executive Order 761-1 / D761-1
  • ARB # D-761-1
  • Executive Order No: D-761-1
  • C.A.R.B. No. D-761-1
  • Resolution D-761-1
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-761-1 PDF

D-761-1 Document:



                                          State of California
                                      AIR RESOURCES BOARD

                                    EXECUTIVE ORDER D—761—1

                           Relating to Exemptions Under Section 27156
                                      of the California Vehicle Code

                                          JLT Performance
                                          JLT Air Intake Kit

Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of
the Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That the installation of the JLT Air Intake Kit,
manufactured and marketed by JLT Performance, 1008 Executive Boulevard, Chesapeake,
Virginia 23320, has been found not to reduce the effectiveness of the applicable vehicle
pollution control systems and, therefore, is exempt from the prohibitions of Section 27156
of the Vehicle Code for the following Chrysler vehicles listed:

    PN        Product        Year        Make                  Vehicle               Engine
 CAI—DHOS    Air In.take    2005—16      Dodge      Charger, Challenger, Magnum    5.7/6.1L NA
                 Kit        2005—16     Chrysler        300, 300C, 300 SRT8        5.7/6.1L NA
 CAI—DH64—   Air Intake     2011—16      Dodge     Charger SRT8, Challenger SRT8     6.AL NA
    11           Kit        2011—16     Chrysler               300 SRTS              6.AL NA
 CAI—SRTJ—   Air Intake
    06           Kit        2006—10      Jeep             Grand Cherokee             6.1L NA


The Air Intake Systems consists of the following main components: Open or closed
element air filter, air intake tubing from throttle body to filter, and all necessary mounting
hardware for proper installation. The stock manifold air pressure sensor is retained in its
stock location and orientation. Installation of the Air Intake System requires the
removal of the stock air filter housing and all intake air tubing. If the stock air filter
housing contains the vehicle‘s tune—up & emissions control decal, a replacement
decal must be placed in a similar location.

This Executive Order is valid provided that the installation instructions for the JLT Air Intake
Kit will not recommend tuning the vehicle to specmcatlons different from those of JLT
Performance.

Changes made to the design or operating conditions of the JLT Air Intake Kit, as exempt by
the Air Resources Board, which adverselyaffect the performance of the vehlcles pollution
control system shall invalidate this Executive Order.

This exemption is issued based on submitted emissions test data, from the SEMA Garage,
Diamond Bar, California, on a 2016 model year 5.7L Dodge Charger certified to the
LEV II ULEV emission standards and tested using the Cold—Start CVS—75 Federal Test
Procedure (FTP) and the Supplemental Federal Test Procedure (SFTP USO6) test cycles.


                                             CVS—75 FTP
                                   NMOG         CO    NOx            HCHO
Standards, UL                      0.070        2.1   0.04           0.011
Device Test w/idf, 2 test avg.     0.034          0.7   0.03         0.002

                                               USO6
                                 NMHC+NOx               cCO
Standards 4k                       0.14                 8.0
Device                             0.10                 0.3

Test results showed that the JLT Air Intake Kit, when installed on the vehicle did not cause
exhaust emissions to exceed the applicable emission standards during the FTP and SFTP.
This Executive Order is also based on the On—Board Diagnostic II (OBD II) testing
conducted on the same test vehicle. The JLT Air Intake Kit when installed on the test
vehicle did not affect the vehicle‘s ability to perform its OBD II monitoring.

The Air Resources Board reserves the right in the future to review this Executive Order and
the exemption provided herein to assure that the exempted add—on or modified part
continues to meet the standards and procedures of Title 13, California Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE
JLT AIR INTAKE KIT.

No claim of any kind, such as "Approved by the Air Resources Board", may be made with
respect to the action taken herein in any advertising or other oral or written communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The
order may be revoked only after a ten—day written notice of intention to revoke the order, in
which period the holder of the order may request in writing a hearing to contest the
proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of
the request and the order may not be revoked until a determination is made after the
hearing that grounds for revocation exist.

Executed at El Monte, California, this        ”         day of October 2016.




                      Annette Hebert, Chief
                      Emissions Compliance, Automotive Regulations and Science Division




                  JLT PERFORMANCE — JLT AIR INTAKE KIT — D—761—1



Document Created: 2017-01-20 16:55:14
Document Modified: 2017-01-20 16:55:14

Previous E.O. D-761 | Previous E.O. D-760 | Next E.O. D-761-2 | Next E.O. D-762