Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on July 28, 2016.
As of Tuesday, September 10th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part Number
See PDF

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-779
  • Executive Order 779 / D779
  • ARB # D-779
  • Executive Order No: D-779
  • C.A.R.B. No. D-779
  • Resolution D-779
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-779 PDF

D-779 Document:

CARB_D-779

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—779 Relating to Exemptions Under Section 27156 of the California Vehicle Code Omix—ADA Rugged Ridge Cold Air Intake Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and Safety Code and Executive Order G—14—012; IT IS ORDERED AND RESOLVED: That the installation of the Rugged Ridge Cold Air Intake, manufactured and marketed by Omix—ADA, 460 Horizon Drive, Suite 400, Suwanee, Georgia 30024, has been found not to reduce the effectiveness of the applicable vehicle pollution control systems and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for the following Jeep vehicles listed: Part Numbers Vehicle Year Engine 17750.07 Wrangler 2012—16 |3.6L Gas 17750.06 Wrangler 2007—11 |3.8L Gas 17750.01 Wrangler 1997—06 |4.0L Gas 17750.03 |Wrangler 2003—06 |2.4L Gas 17750.20 Cherokee 1991—01 4.0L Gas 17750.02 Wrangler 1997—02 2.5L Gas 17750.04 |Wrangler 1991—95 |4.0L Gas 17750.05 Wrangler 1991—95 |2.5L Gas 17750.22 |Grand Cherokee |1993—98 |5.2/5.9L Gas The Rugged Ridge Cold Air Intake consists of following main components: Conical element air filter, air intake tubing from throttle body to filter, and all necessary mounting hardware for proper installation. The stock air temperature sensor is retained in its stock location and orientation. No other changes are made for proper installation. Installation of the Cold Air Intake requires the removal of the stock air filter housing and intake air tubing. If the stock air filter housing contains the vehicle‘s tune—up & emissions control decal, a replacement decal must be placed in a similar location. Kit does not require an ECU upgrade. This Executive Order is valid provided that the installation instructions for the Rugged Ridge Cold Air Intake will not recommend tuning the vehicle to specifications different from those of the vehicle manufacturer. Changes made to the design or operating conditions of the Rugged Ridge Cold Air Intake, as exempt by the Air Resources Board, which adversely affect the performance of the vehicle‘s pollution control system shall invalidate this Executive Order. This exemption is issued based on submitted emissions test data, from the SEMA Garage, Diamond Bar, California, on a 2015 model year 3.6L Jeep Wrangler certified to the

LEV 2 ULEV emission standards and tested using the Cold—Start CVS—75 Federal Test Procedure (FTP) test cycle and the Supplemental Federal Test Procedure (SFTP USO6) test cycle. CVS—75 FTP NMOG CO NOx ~HCHO Standards, UL 0.070 2. 0.04 0.011 Device Test w/df, 2 test avg. 0.032 0.8 0.03 0.001 US06 NMHC+NOx CO Standards 4k 0.14 8.0 Device 0.06 0.5 Test results showed that the Rugged Ridge Cold Air Intake when installed on the vehicle did not cause exhaust emissions to exceed the applicable emission standards during the FTP and SFTP. This Executive Orderis also based on the On—Board Diagnostic II (OBD I1) testing conducted on the same test vehicle. The Rugged Ridge Cold Air Intake when installed on the test vehicle did not affect the vehicle‘s ability to perform its OBD II monitoring. The Air Resources Board reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add—on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222, et seq. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE RUGGED RIDGE COLD AIR INTAKE. No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action taken herein in any advertising or other oral or written communication. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. Executed at El Monte, California, this ZS day of July 2016. Annette Hebert, Chief Emissions Compliance, Automotive Regulations and Science Division OMIX—ADA — RUGGED RIDGE COLD AIR INTAKE — D—779


Document Created: 2016-08-02 15:21:07
Document Modified: 2016-08-02 15:21:07

| Previous E.O. D-778 | Next E.O. D-779-1 | Next E.O. D-780