Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on November 17, 1997.
As of Wednesday, January 15th, 2025 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
300-481967-1986 GM vehicles equipped with 5.7L enginesIt is an intake manifold manufactured out of aluminum with high rise dual plane design, divided plenum, EGR provision, and square flange carburetor mounting

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-115-9
  • Executive Order 115-9 / D115-9
  • ARB # D-115-9
  • Executive Order No: D-115-9
  • C.A.R.B. No. D-115-9
  • Resolution D-115-9
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-115-9 PDF

D-115-9 Document:

CARB_D-115-9

(Page 1 of 2) State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—115—9 Relating to Exemptions Under Section 27156 of the Vehicle Code HOLLEY PERFORMANCE PRODUCTS CHEVY SYSTEMAX INTAKE MANIFOLD, P/N 300—48 Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the undersigned by Sections 39515 and 39516 of the Health and Safety Code and Executive Order G—45—9; T IS ORDERKED AND RESOLVED: That the installation of the Chevy SysteMAX Intake Manifold, manufactured by Holley Performance Products of 2800 Griffin Drive, Bowling Green, Kentucky 42102, _ has been found not to reduce the effectiveness of the applicable vehicle pollution control system and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for 1967—86 General Motors 5.7L engines. The Chevy SysteMAX Intake Manifold, P/N 300—48 is an intake manifold manufactured out of aluminum with high rise dual plane design, divided plenum, EGR provision, and square flange carburetor mounting. This Executive Order is valid provided that installation instructions for this device will not recommend tuning the vehicles to specifications different from those submitted by the vehicle manufacturer. Changes made to the design or operating conditions of the devices, as exempt by the Air Resources Board, which adversely affect the performance of a vehicle‘s pollution control system shall invalidate this Executive Order. Marketing of this device using any identification other than that shown in this Executive Order or marketing of this device for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. This Executive Order does not constitute any opinion as to the effect the use of the ignition modules may have on any warranty either expressed or implied by the vehicles manufacturer. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF HOLLEY‘S CHEVY SYSTEMAX INTAKE MANIFOLD. No claim of any kind, such as "Approved by the Air Resources Boardfi'ay be made with respect to the action taken herein in any advertising or other oral or written communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after ten day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination after hearing that grounds for revocation exist. Executed at El Monte, California, this Q@S of Novembper 1997. .B Summerfiel&/ Chief Mobile Source Operations Division


Document Created: 2005-09-01 12:14:49
Document Modified: 2005-09-01 12:14:49

Previous E.O. D-115-8 | Previous E.O. D-114 | Next E.O. D-115-10 | Next E.O. D-116