Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on January 22, 2007.
As of Thursday, January 9th, 2025 this Executive Order has not been overturned or superceeded.

Approved Parts

Models
See PDF - Exhibit A

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-176-30
  • Executive Order 176-30 / D176-30
  • ARB # D-176-30
  • Executive Order No: D-176-30
  • C.A.R.B. No. D-176-30
  • Resolution D-176-30
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-176-30 PDF

D-176-30 Document:

CARB_D-176-30

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—176—30 Relating to Exemptions Under Section 27156 of the California Vehicle Code Dinan Engineering, Inc. Performance Camshafts Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and Safety Code and Executive Order G—02—003; IT IS ORDERED AND RESOLVED: That the installation of the Performance Camshafts, manufactured and marketed by Dinan Engineering, Inc. (865 Jarvis Drive, Morgan Hill, CA 95037) has been found not to reduce the effectiveness of the applicable vehicle pollution control system and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for the vehicles described in Exhibit A. The Performance Camshaifts feature changes in lift and duration for increased power at high RPM. The differences in lift and duration between the stock camshafts and the Performance Camshaifts are shown in Exhibit A. The Performance Camshafts are manufactured using the same material as the stock camshafts. This Executive Order is valid provided that the installation instructions for the Performance Camshaifts will not recommend tuning the vehicle to specifications different from those submitted by the device manufacturer. Changes made to the design or operating conditions of the Performance Camshafts, as exempt by the Air Resources Board, which adversely affect the performance of the vehicle‘s pollution control system shall invalidate this Executive Order. This Executive Order shall not apply to any Performance Camshafts advertised, offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer to an ultimate purchaser. Marketing of the Performance Camshafts using any identification other than that shown in this Executive Order or marketing of the Performance Camshafts for an application other than those listed in this Executive Order shall be prohibited: unless prior approval is obtained from the Air Resources Board. This Executive Order does not constitute any opinion as to the effect the use of the Performance Camshafts may have on any warranty either expressed or implied by the vehicle manufacturer.

12 This Executive Order is granted based on submitted emissions test data generated on a 2004 model—year BMW Z4 3.0i equipped with a 3.0L engine (4BMXVO3.OM5R test group), certified to the Ultra Low Emission Vehicle (ULEV) emission standards with the Performance Camshatfts installed. Testing consisted of a Cold—Start CVS—75 Federal Test Procedure (FTP) test cycle, a Supplemental Federal Test Procedure (SFTP) USO6 test cycle, and an On—Board Diagnostic I! (OBD !!) test. Test data showed that the Performance Camshatfts did not affect the vehicle‘s ability to perform OBD II monitoring. The results shown in the table below are in grams per mile with the CVS—75 FTP results multiplied by BMW‘s deterioration factors. Emission levels of the modified vehicle met the applicable emission standards. CVS—75 FTP SFTP USO6 NMOG CO NOx HCHO NMHC+NOx Co Standard 0.040 1.7 0.2 0.008 0.14 8.0 w/ Device 0.029 0.54 0.1 0.0004 0.048 0.48 The Air Resources Board reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add—on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222, et seq. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE PERFORMANCE CAMSHAFTS. No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action taken herein in any advertising or other oral or written communication. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. Executed at El Monte, California, this 2Z day of January 2007 o Annette Hebert, Chief Mobile Source Operations Division DINAN ENGINEERING, INC. — PERFORMANCE CAMSHAFTS — D—176—30

Exhibit A Part BMW Model Engine Number Model Years Displacement 3301 * 2001—03 3.0L 330xi 2001—05 3.0L D525— 330ci 2001—03 3.0L 525—0542 530i (E39) 2001—03 3.0L 23 3.0i 2001—02 3.0L 24 3.0i 2003—05 3.0L D525—0540 M3 2001—06 3.2L M—Roadster 2001—02 3.2L D525—0541 525—054 M—Coupe 2001—02 3.2L MS 2000—03 4.9L D525—0620 Z8 2000—03 4.9L D525—0110 Mini Cooper S ** 2002—06 1.6L * Excluding 2003 330i with the test group 3BMXVO03.OUL2 (LEV I1 ULEV) ** Excluding John Cooper Works models Performance Camshaft differences from stock camshaft specifications: Intake Exhaust Part Lift @ cam Duration Lift @ cam Duration Number (mm) (degrees) {mm) (degrees) D525—0542 +5.00% +3.94% +7.53% +3.33% D525—0540 +4.51% +4.48% +4.51% +3.82% D525—0541 +4.51% +4.48% +4.51% +3,82% D525—0620 +9.71% +4.69% +9.71% +4.69% D525—0110 +13.10% —3.91% +12.50% +6.25%


Document Created: 2007-02-07 13:38:03
Document Modified: 2007-02-07 13:38:03

Previous E.O. D-176-29 | Previous E.O. D-175 | Next E.O. D-176-31 | Next E.O. D-177