Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on July 15, 2008.
As of Saturday, December 28th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModificationRemarks
Series 4120001996 to 2000 Selected BMW PCNoneContact manufacturer or distributor for specific vehicle application

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-280-28
  • Executive Order 280-28 / D280-28
  • ARB # D-280-28
  • Executive Order No: D-280-28
  • C.A.R.B. No. D-280-28
  • Resolution D-280-28
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-280-28 PDF

D-280-28 Document:

CARB_D-280-28

State of California AIR RESOURCES BOARD EXECU1-IVE ORDER D-280-28 Relating to Exemptions under Section 27156 of the Vehicle Code AirTek, Inc. (d.b.a. Catco) "Series 412000 OBD ll Compliant Three-way Catalytic Converter" WHEREAS, Vehicle Code Sections 27156 and Section 2222(h), Title 13, California Code of Regulations (hereafter "CCR), authorize the California Air Resources Board and its Executive Officer to exempt new aftermarket catalytic converters from the prohibitions of Vehicle Code Section 27156. WHEREAS, AirTek, Inc. (AirTek) of 4410 W. 37thAvenue, Hobart, Indiana 46342, has applied to the Air Resources Board for exemption from the prohibitions in Vet~icleCode Section 27156 to market its new aftermarket Series 4.12000 three-way catalytic converter (TWC) for installation on selected 1996 through 2000 model year BMW passenger cars equipped with on-board diagnostic II (OBD-II) systems as specified in Appendix D-280-28 and incorporated herein. The Series 412000 TWC will be used for single (one unit) or dual (two units) exhaust system applications for selected BMW passenger cars. Series 412000 TWC may also be installed on non-OBD ll vehicles (1995 and older) similar in engine and exhaust configuration to those listed in Appendix D-280-28. WHEREAS, pursuant to the authority vested in the Executive Officer by Health and Safety Code Section 39515 and in the Chief, Mobile Source Operations Division by Health and Safety Code Section 39516 and Executive Order G-02-003, Air Resources Board finds that the above aftermarket catalytic converter complies with the California Vehicle Code Section 27156 and Title 13, California Code of Regulations, Section 2222(h). The emissions performance of the catalytic converter was based on durability bench-aging by Southwest Research Institute, San Antonio, Texas, using Air Resources Board-modified RAT-A bench- aging cycle for 75 hours, as specified in the "Optional Evaluation Procedures for New Aftermarket Non-original Equipment Catalytic Converters Equipped with On-Board Diagnostic II (OBD II) Systems." WHEREAS, previous emissions and OBD II compatibility tests conducted by AirTek, Inc. using a vehicle of a weight classification and exhaust configuration similar to those listed in Appendix D-280-28 and certified to Low Err~issionVehicle (LEV) standards resulted in the issuance of Executive Order D-280-16, it was determined that the installation of Series 41 2000 TWC on the vehicles listed in Appendix D-280-28 meets the requirements of California regulations for aftermarket catalytic converters. IT IS HEREBY RESOLVED that the above catalytic converter 'is exempt from the prohibitions in Vehicle Code Section 27156 for installation on the vehicles listed in Appendix D-280-28 subject to the following conditions:

1. No changes are permitted to the catalytic converter as described in the application for exemption. Any changes to the catalytic converter or any of its cor~~ponents, and other factors addressed in this order must be evaluated and approved by the Air Resources Board prior to marketing in California. 2. Marketing of the catalytic converter using identifications other than those shown in the exemption application, and in ,this Executive Order, or marketing of the catalytic converter for application other than the ones shown in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. Exemption of these products shall not be construed as an exemption to sell, offer for sale, or advertise any components of the catalytic converter as individual devices. 3. Any oral or written references to this Executive Order or its content by AirTek, Inc., its principals, agents, employees, distributors, dealers, or other representatives must include the disclaimer that the Executive Order or the exemption it provides is not an endorsement or approval of any emission reduction claims for the catalytic converter and is only a finding that the catalytic converter is exempt from the prohibitions of Vehicle Code Section 27156. 4. AirTek, Inc.'s installation instr~~ctions for the new catalytic converter must conform to requirements in Paragraphs I and X of the "Optional Evaluation Procedures for New Aftermarket Non-original Equipment Catalytic Converters Equipped with On-Board Diagnostic II (OBD II) Systems." 5. Upon installation, the catalytic converter must carry a manufacturer's warranty for 50,000 miles on the substrates and 50,000 miles or five years on the shell and end pipes. 6. AirTek, Inc. and its vendors may not advertise the new aftermarket catalytic converter as a "performance, high or easy flow" catalytic converter or use any phrase that could make them appear to perform better than an OEM catalytic converter. 7. The new aftermarket catalytic converter substrate may not be sold or supplied to a third party by AirTek, its associates, vendors, other businesses, and individuals associated with AirTek, to be assembled in a different facility and marketed under this Executive Order. 8. Any marketing arrangement of the new aftermarket catalytic converter by a third party, which involves the use of packaging identification different from the ones described in this Executive Order must be approved by Air Resources Board prior to shipment. 9. AirTek must submit the required quality audit and production q~~antity reports for its aftermarket catalytic converter semi-annually, coveqing the periods January 1 through June 30, and July 1 through Decerr~ber31. AIRTEK, INC. - CATALYTIC CONVERTER - D-280-28

Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten day written notice of intention to revoke it, during which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request, and the order may not be revoked until a determination is made, after the hearing, that grounds for revocation exist. + J Executed at El Monte, California, this / day of July 2008. fc-J5&4&-./ dAnnette Hebert, Chief %obile Source Operations Division AIRTEK, INC. - CATALYTIC CONVERTER - D-280-28

Model Engine Certification Weight Exhaust Total Converter Direct No. Vehicle Model Engine Family Monitored Universal Year Size Level Class Type Converters Type Fit 318i, 318is, 318iC, 318iAC, 318iA, 318isA, 1.9L TBM1.9VJIGKEK Tierl TWC 412005 412078 318ti, 318tiA, 1996 23, 73A 328iA, 328isA, 2.8L & 412084 left 328iAC, 328is, TBM2.8VJGKEK 2TWC 3.2L or right 328iC, M3 23, Z3A 2.8L VBM2.8VJGKFK 412005 328i, 328is, 328iA, 328isA, TBD 328i 1997 convertible, 2.8L & 412084 left VBM2.8VJGKEK 2TWC 3281A 3.2L or right convertible, M3, M3A, 528iA, PC 528i 318i, 318iC, TLEV 318iA, 318iAC, 318isA, 318tiA, 1.9L WBMXVO1L.9M44 412078 318ti, 318is, 23, 23A 323is, 323i TWC 412005 convertible, 1998 323isA, 3231A 2.5L & WBMXVO2.8Z35 convertible, 23, 2.8L Z3A, 23 coupe, TBD 23 coupe A 412084 left 528i, 528iA 2.8L WBMXVO2.8M52 2TWC or right


Document Created: 2008-07-16 11:19:12
Document Modified: 2008-07-16 11:19:12

Previous E.O. D-280-27 | Previous E.O. D-279 | Next E.O. D-280-29 | Next E.O. D-281