Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on November 18, 2008.
As of Sunday, December 29th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModificationRemarks
Series 110000 & 6100001999 to 2002 Toyota passenger carsNoneContact manufacturer or distributor for specific vehicle application

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-280-40
  • Executive Order 280-40 / D280-40
  • ARB # D-280-40
  • Executive Order No: D-280-40
  • C.A.R.B. No. D-280-40
  • Resolution D-280-40
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-280-40 PDF

D-280-40 Document:

CARB_D-280-40

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—280—40 Relating to Exemptions under Section 27156 and 38391 of the Vehicle Code Airtek, Inc. (d.b.a. Catco) "Series 110000 & 610000 Three—way Catalytic Converters WHEREAS, Vehicle Code Sections 27156 and 38395, and Title 13, California Code of Regulations (hereafter "CCR") Section 2222(h), authorize the California Air Resources Board and its Executive Officer to exempt new aftermarket catalytic converters from the prohibitions of Vehicle Code Section 27156 and 38391. WHEREAS, Airtek, Inc. (Airtek) of 4410 W. 37"" Avenue, Hobart, Indiana 46342, has applied to the Air Resources Board for exemption from the prohibitions in Vehicle Code Sections 27156 and 38391 to market its new aftermarket Series 110000 & 610000 three—way catalytic converters (TWC) on selected 1999 through 2002 Toyota passenger cars equipped with on—board diagnostic II (OBD—II) systems as specified in Appendix D—280—40 and incorporated herein. Series 110000 & 610000 TW Cs will be used for multiplecatalytic converter system applications, with Series 110000 as the front catalytic converter and Series 610000 as the rear catalytic converter. These catalytic converters may be sold as a universal or direct fit system. WHEREAS, pursuant to the authority vested in the Executive Officer by Health and Safety Code Section 39515 and in the Chief, Mobile Source Operations Division by Health and Safety Code Section 39516 and Executive Order G—02—003, the Air Resources Board finds that the above aftermarket catalytic converters comply with the California Vehicle Code Sections 27156 and 38395 and Title 13, California Code of Regulations, Section 2222(h). Emission performance of the catalytic converters was based on durability bench—aging by Southwest Research Institute using the Air Resources Board—modified RAT—A bench—aging cycle for 75 hours, as specified in Appendix A to the "California Evaluation Procedures for New Aftermarket Catalytic Converters" as adopted on October 25, 2007. WHEREAS, previous emissions and OBD 1| compatibility tests conducted by AirTek, Inc. on vehicles with similar weight classification and exhaust emission standards to those listed in Appendix D—280—40, resulted in the issuance of Executive Order D—280—15 and D—280—20, it was determined that the installation of Series 110000 & 610000 TWCs on the vehicles listed in Appendix D—280—40 meets the requirements of California regulations for aftermarket catalytic converters. THEREFORE, IT IS HEREBY RESOLVED that Airtek,; Inc.‘s Series 110000 & 610000 TWCs are exempted from the prohibitions in Vehicle Code Sections 27156 and 38391

for installation on the approved vehicle applications specified in Appendix D—280—40 subject to the following conditions: 1. No changes are permitted to the catalytic converters as described in the application for exemption. Any changes to the catalytic converters or any of their components, and other factors addressed in this order must be evaluated and approved by the Air Resources Board prior to marketing in California. Marketing of the catalytic converters using identifications other than those shown in the exemption application, and in this Executive Order, or marketing of the catalytic converters for application other than the ones shown in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. Exemption of this product shall not be construed as an exemption to sell, offer for sale, or advertise any components of the catalytic converters as individual devices. Any oral or written references to this Executive Order or its content by Airtek, Inc., its principals, agents, employees, distributors, dealers, or other representatives must include the disclaimer that the Executive Order or the exemption it provides is not an endorsement or approval of any emission reduction claims for the catalytic converters and is only a finding that the catalytic converters are exempt from the prohibitions of Vehicle Code Sections 27156 and 38391. Airtek, Inc.‘s installation instructions for the new catalytic converters must conform to requirements in Section (h) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007. Installation of the catalytic converters shall not cause the relocation of an oxygen sensor. Oxygen sensors must be installed in the same location, position and orientation as prescribed in the original equipment manufacturer‘s configurations. Upon installation, the catalytic converters must carry a manufacturer‘s warranty for five (5) years or 50,000 miles as prescribed in Section (f)(2) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007 . Airtek, Inc. and its vendors may not advertise the new aftermarket catalytic converters as "high flow or easy flow" catalytic converters or use any phrase that could make them appear to perform better than the original equipment manufacturer (OEM) catalytic converters. Any marketing arrangement of the new aftermarket catalytic converter by a third party, which involves the use of packaging identification different from the ones described in this Executive Order, must be approved by the Air Resources Board prior to shipment. AIRTEK, INC. — CATALYTIC CONVERTER — D—280—40

— 3 — 9. Airtek Inc., its associates, vendors, other businesses and individuals associated with Airtek Inc. may not sell or supply new aftermarket catalytic converter substrates to a third party to be assembled in a different facility and marketed under this Executive Order without approval from the Air Resources Board. 10. AirTek, Inc. shall comply with the quality control procedures and reporting requirements in Section (f)(5) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007. 11. Quality control reports must be submitted on a quarterly basis and warranty information reports on a semi—annual basis, starting with periods covering January 1 through March 31, 2009 and January 1 through June 30, 2009, respectively. 12. Airlek, Inc. must provide a permanent label or stamp as specified under Section (f)(1) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted on October 25, 2007. 13. AirTek, Inc.‘s vehicle application catalog must conform with the requirements as specified under Section (f)(4) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted on October 25, 2007. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a 30—day written notice of intention to revoke it, during which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within 30 days of receipt of the request, and the order may not be revoked until a determination is made, after the hearing, that grounds for revocation exist. | Ca li fo rn ia , thi s _/ Z" ‘d ay of November 2008. Executed at El Monte, Saowses ,:. : \/"‘ ecq x efi'r' \ Z’} LtAAA <* / /z;;‘ifiAnnette Hebert, Chief —~ Mobile Source Operations Division AIRTEK, INC. — CATALYTIC CONVERTER — D—280—40

APPENDIX D—280—40 _ AirTek INC. 110000/610000 for Toyota Passenger Cars Model . Engine . . Certification Weight Exhaust Converter Total Monitored R No. Vehicl d E e Famil | i i ° Year ehicle Model Size ngine Famy | Level Class Type _Type Converters Converter Universal| Direct Fit AVALON, 1 1999 CAMRY, XTYXVO3.0GXB SOLARA LEFT CAMRY, 112004 EXHAUST SOLARA, WU CAT MANIFOLD 2 . 2000 SOLARA vyxv03.0FX8 WU— 112959 CONVERTIBLE 3 AVALON YTYXVO3.O0FFC 2WUTWC/T CAMRY, 3.0L LEV PC D/Y we / 3 ALL SOLARA, | | 4 1TYXVO3.O0FF 2001 SOLARA 3.0FFB RIGHT SIDE CONVERTIBLE 612004R ASSEMBLY— 5 AVALON 1TYXVO3.O0FFC UNDER 112259 CAMRY, BODY CAT AUTO TRANS SOLARA, | MODELS 6 20 02 SOLARA TYXVO3.O0FFB 2TYXVO3.O0FF CONVERTIBLE PAGE 1 OF 1


Document Created: 2008-11-21 15:09:43
Document Modified: 2008-11-21 15:09:43

Previous E.O. D-280-39 | Previous E.O. D-279 | Next E.O. D-280-41 | Next E.O. D-281