Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on August 14, 2015.
As of Wednesday, November 27th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModels
See PDFSee PDF

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-701-15
  • Executive Order 701-15 / D701-15
  • ARB # D-701-15
  • Executive Order No: D-701-15
  • C.A.R.B. No. D-701-15
  • Resolution D-701-15
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-701-15 PDF

D-701-15 Document:


CARB_D-701-15

                                  State of California
                              AIR RESOURCES BOARD

                            EXECUTIVE ORDER D—701—15

                     Relating to Exemptions Under Section 27156
                                of the California Vehicle Code

                            Pacific Performance Engineering
                              3" Stainless Steel Down Pipe


Pursuant to the authority vested in the Air Resources Board by Section 27156 of the
Vehicle Code; and               £

Pursuant to the authority vested in the undersigned by Section 39515 and Section
39516 of the Health and Safety Code and Executive Order G—14—012;

IT IS ORDERED AND RESOLVED: That the installation of the 3" Stainless Steel Down
Pipe, manufactured and marketed by Pacific Performance Engineering, 303 North
Placentia Avenue, Fullerton, California 92831, has been found not to reduce the
effectiveness of the applicable vehicle pollution control systems and, therefore, is
exempt from the prohibitions of Section 27156 of the Vehicle Code for the following
2001 to 2015 model year General Motors pickups, equipped with a 6.6L diesel engine:

Part Number         Application
117000400           2001 to 2004
117000500           2004.5 to 2010
117000600           2011 to 2015

The 3" Stainless Steel Down Pipe is a stainless steel down pipe that is attached to the
exhaust output of the stock turbocharger and the vehicle‘s under floor exhaust
system. The stock down pipe and the 3" Stainless Steel Down Pipe share the same
construction material, metal gauge, interior volume, length, and port size, the only
difference is the stock pipe is square in the middle section and the 3" Stainless Steel
Down Pipe is round throughout. The 3" Stainless Steel Down Pipe has no
mechanical or electrical user adjustments. No changes are made to any
component of the stock engine for installation, including engine calibration,
turbocharger, or any other component of the exhaust system.

This Executive Order is valid provided that the installation instructions for the 3"
Stainless Steel Down Pipe will not recommend tuning the vehicle to specifications
different from those of the vehicle manufacturer.

Changes made to the design oroperating conditions of the 3" Stainless Steel Down
Pipe as exempt by the Air Resources Board, which adversely affect the performance of
the vehicle‘s pollution control system shall invalidate this Executive Order.


                                              J.


Marketing of the 3" Stainless Steel Down Pipe using any identification other than that
shown in this Executive Order or marketing of the 3" Stainless Steel Down Pipe for an
application other than those listed in this Executive Order shall be prohibited unless
prior approval is obtained from the Air Resources Board.

This Executive Order does not constitute any opinion as to the effect the use of the
3" Stainless Steel Down Pipe may have on any warranty either expressed or implied by
the vehicle manufacturer.

This Executive Order is granted based on an engineering evaluation and information
supplied by Pacific Performance Engineering on the 3" Stainless Steel Down Pipe.
Comparisons made between the stock and modified part demonstrated similarity in
material type, port size, and basic design.

The Air Resources Board reserves the right in the future to review this Executive Order
and the exemption provided herein to assure that the exempted add—on or modified part
continues to meet the standards and procedures of Title 13, California Code of
Regulations, Section 2222, et seq.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION,
ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE
AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING
ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE 3" STAINLESS
STEEL DOWN PIPE.

No claim of any kind, such as "Approved by the Air Resources Board", may be made
with respect to the action taken herein in any advertisingor other oral or written
communication.

Violation of any of the above conditions shall be grounds for revocation of this order.
The order may be revoked only after a ten—day written notice of intention to revoke the
order, in which period the holder of the order may request in writing a hearing to contest
the proposed revocation. If a hearing is requested, it shall be held within ten days of
receipt of the request and the order may not be revoked until a determination is made
after the hearing that grounds for revocation exist.

Executed at El Monte, California, this        / T   day of August 2015.




              Annette Hebert, Chief
              Emissions Compliance, Automotive Regulations and Science Division




         PACIFIC PERFORMANCE ENGINEERING — DOWN PIPE —D—701—15



Document Created: 2015-08-18 10:36:33
Document Modified: 2015-08-18 10:36:33

Previous E.O. D-701-14 | Previous E.O. D-700 | Next E.O. D-701-16 | Next E.O. D-702