Approval Details

Unknown Validity

Validity


As of Thursday, November 28th, 2024 this Executive Order has not been overturned or superceeded. Warning: This Executive Order record has not yet been synced with arb.parts system.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-387-2
  • Executive Order 387-2 / D387-2
  • ARB # D-387-2
  • Executive Order No: D-387-2
  • C.A.R.B. No. D-387-2
  • Resolution D-387-2
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-387-2 PDF

D-387-2 Document:

CARB_D-387-2

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—387—2 Relating to Exemptions Under Section 27156 of the California Vehicle Code Brown Recycling & Manufacturing, Inc. Aftermarket Catalytic Converter Mat Wrap WHEREAS, Vehicle Code Sections 27156 and 38391, and Title 13, California Code of Regulations (hereafter "CCR") Section 2222(i), authorize the California Air Resources Board (ARB) and its Executive Officer to exempt used aftermarket catalytic converters from the prohibitions of Vehicle Code Section 27156. _ WHEREAS, Brown Recycling & Manufacturing, Inc. of 1274 Gravel Ridge Road, Somerville, Alabama 35670, has been issued an exemption from the prohibitions in Vehicle Code Section 27156 and 38391, through Executive Order Number D—387—1, to market used original equipment manufacturer (OEM) catalytic converters in California. Under the conditions of Executive Order Number D—387—1, Brown Recycling & Manufacturing, Inc. was permitted to salvage used OEM catalytic converters, test, replace the end pipes, as necessary, and re—sell them for installation on vehicles with the same engine family as the vehicles from which the catalytic converters have been recovered. WHEREAS, Brown Recycling & Manufacturing, Inc. has applied to the ARB for exemption from the prohibitions in Vehicle Code Section 27156 and 38391 to allow replacement of the OEM wrap with the Aftermarket Catalytic Converter Mat Wrap. The wrap replacement is allowed only on used catalytic converters that have been identified by Brown Recycling & Manufacturing, Inc. during its screening procedures to have worn—out or broken wrap. WHEREAS, pursuant to the authority vested in the Executive Officer by Health and Safety Code Section 39515 and in the Chief, Mobile Source Operations Division by Health and Safety Code Section 39516 and Executive Order G—02—003, the ARB finds that the installation of the Aftermarket Catalytic Converter Mat Wrap complies with the California Vehicle Code Sections 27156 and 38391, and Title 13, California Code of Regulations, Section 2222(1). The emissions performance of the used catalytic converter with the Aftermarket Catalytic Converter Mat Wrap was based on durability bench—aging by Delphi Engine and Chassis Systems using the ARB—modified RAT—A bench aging cycle for 100 hours as specified in the "Optional Evalaution Procedures for New Aftermarket Non—original Equipment Catalytic Converters Equipped with On—Board Diagnostic II (OBD I1) Systems." WHEREAS, emissions test conducted at the Automotive Testing and Development Services, Ontario, California, using a used OEM catalytic converter with its OEM wrap

replaced with the Aftermarket Catalytic Converter Mat Wrap showed the vehicle to meet the applicable emission standards. The vehicle used for emission testing was a 2000 model year 4.0L Jeep Cherokee, test group YCRXTO242230, certified to the Low Emission Vehicle emission standards (LEV, LDT2). Examination of the On—Board Diagnostic II (OBD 11) system showed that the used OEM catalytic converter with an Aftermarket Catalytic Converter Mat Wrap does not affect OBD II system operation. The following are the test results in grams per mile: Cold—Start CVS—75 Federal Test Procedure (in grams per mile) NMOG CO NOx Used Converter W the . aftermarket wrap 0.098 2.1 0.3 100k LEV Standards 0.130 5.5 0.5 T IS ORDERED AND RESOLVED: That the installation of the Aftermarket Catalytic Converter Mat Wrap on used OEM catalytic converters, by Brown Recycling & Manufacturing, Inc. of 1274 Gravel Ridge Road, Somerville, Alabama 35670, has been found not to reduce the effectiveness of the applicable vehicle pollution control systems and, therefore, is exempt from the profhiibitions of Section 27156 of the Vehicle Code subject to the following conditions: 1. Replacement of the OEM wrap with the Aftermarket Catalytic Converter Mat Wrap must be allowed only on used catalytic converters that have been identified by Brown Recycling & Manufacturing, Inc. as having worn—out or broken wrap. 2. Brown Recycling & Manufacturing, Inc.‘s Aftermarket Catalytic Converter Mat Wrap is made of Unifrax XPE Expanding Paper manufactured by Unifrax Corporation. Installation of the Aftermarket Catalytic Converter Mat Wrap shall follow installation procedures submitted by Brown Recycling & Manufacturing, Inc. in its exemption application. 3. Used catalytic converters with OEM wrap replaced with the Aftermarket Catalytic Converter Mat Wrap must follow screening procedures and meet the required conversion efficiencies and conditions, as specified under Executive Order No. D—382—1, before they can be marketed in California. 4. No changes are permitted to the Aftermarket Catalytic Converter Mat Wrap or the used catalytic converter as described in the exemption application. Any changes to the Aftermarket Catalytic Converter Mat Wrap or any other component of the used catalytic converter must be evaluated and approved by the ARB prior to marketing in California. v — 5. Marketing of the Aftermarket Catalytic Converter Mat Wrap for purposes other than shown in the exemption application and in this Executive Order, or marketing of the Aftermarket Catalytic Converter Mat Wrap for an application other than the ones BROWN RECYCLING & MANUFACTURING, INC. — AFTERMARKET CATALYTIC CONVERTER MAT WRAP — D—387—2

shown in this Executive Order shall be prohibited unless prior approval is obtained from the ARB. 6. Brown Recycling & Manufacturing, Inc.‘s installation instructions for used cataiytic converters with the Aftermarket Catalytic Converter Mat Wrap must conform to the requirements in paragraph | and X of the "Optional Evaluation Procedures for New Aftermarket Non—original Equipment Catalytic Converters Equipped with On—Board Diagnostics II (OBD I1) Systems." 7. Upon installation, the Aftermarket Catalytic Converter Mat Wrap must carry a Brown Recycling & Manufacturing, Inc.‘s warranty for 50,000 miles when installed on OBD l equipped vehicles and 25,000 miles when installed on non—OBD II equipped vehicles. | ' 8. Brown Recycling & Manufacturing, Inc. must provide a label on the used catalytic converter clearly showing that the OEM wrap has been replaced with the Aftermarket Catalytic Converter Mat Wrap. 9. Brown Recycling & Manufacturing, Inc. may not advertise a used catalytic converter with the Aftermarket Catalytic Converter Mat Wrap as a "remanufactured catalytic converter." Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the—hearing that grounds for revocation exist. Executed at El Monte, California, this ) 77 day of September, 2003. Allé//[yons, Chief Mobile Source Operations Division BROWN RECYCLING & MANUFACTURING, INC. — AFTERMARKET CATALYTIC CONVERTER MAT WRAP — D—387—2


Document Created: 2009-01-23 11:29:36
Document Modified: 2009-01-23 11:29:36

Previous E.O. D-387-1 | Previous E.O. D-386 | Next E.O. D-387-3 | Next E.O. D-388