Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on May 12, 2010.
As of Saturday, December 28th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModificationRemarks
Series 6700002001-2005 selected Honda PC vehiclesNoneContact manufacturer or distributor for specific vehicle application.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-665-4
  • Executive Order 665-4 / D665-4
  • ARB # D-665-4
  • Executive Order No: D-665-4
  • C.A.R.B. No. D-665-4
  • Resolution D-665-4
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Vehicle: ApplicationPart NumberType - LocationTotal CountCert Level / Class
2001 Honda Civic 1.70LALLEastern Catalytic 670001DIRECT FIT - Front of the vehicle1LEV1 ULEV / PC1HNXV01.7YJ9
2002 Honda Civic 1.70LALLEastern Catalytic 670001DIRECT FIT - Front of the vehicle1LEV1 ULEV / PC2HNXV01.7TA5
2003 Honda Civic 1.70LALLEastern Catalytic 670001DIRECT FIT - Front of the vehicle1LEV1 ULEV / PC3HNXV01.7WA5
Download: Executive Order D-665-4 PDF

D-665-4 Document:

CARB_D-665-4

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—665—4 Relating to Exemptions under Section 27156 and 38391 of the Vehicle Code Eastern Manufacturing, Inc. "Series 670000 Three—way Catalytic Converter" WHEREAS, Vehicle Code Sections 27156 and 38395, and Title 13, California Code of Regulations (hereafter "CCR") Section 2222(h), authorize the California Air Resources Board and its Executive Officer to exempt new aftermarket catalytic converters from the prohibitions of Vehicle Code Section 27156 and 38391. WHEREAS, Eastern Manufacturing, Inc. (Eastern) of 2151 Cabot Blvd., West Longhorne, Pennsylvania 19047, has applied to the Air Resources Board for exemption from the prohibitions in Vehicle Code Sections 27156 and 38391 to market its new aftermarket Series 670000 three—way catalytic converter (TWC) for installation on selected 2001 through 2005 Honda passenger cars (PC) equipped with on—board diagnostic II (OBD II) systems as specified in Appendix D—665—4 and incorporated herein. Series 670000 TWC will be used for a single (1 unit) close—coupled catalytic converter system application for the selected Honda PC. The catalytic converter will be sold as a direct fit system. WHEREAS, pursuant to the authority vested in the Executive Officer by Health and Safety Code Section 39515 and in the Chief, Mobile Source Operations Division by Health and Safety Code Section 39516 and Executive Order G—02—003, the Air Resources Board finds that the above aftermarket catalytic converter complies with the California Vehicle Code Sections 27156 and 38395 and Title 13, California Code of Regulations, Section 2222(h). Emission performance of the catalytic converter was based on durability bench—aging by Umicore Autocat USA Inc. using the Air Resources Board—modified RAT—A bench—aging cycle for 75 hours, as specified in Appendix A to the "California Evaluation Procedures for New Aftermarket Catalytic Converters" as adopted on October 25, 2007. WHEREAS, emissions tests conducted at Automotive Testing and Development Services, Inc., Ontario, California, using a 2002 1.7L Honda Civic, test group 2HNXVO1.7TAS, certified to the passenger car and Uitra Low Emission Vehicle emission standards (PC, ULEV), showed that the vehicle met the applicable emission standards with Series 670000 TWC (1 unit) installed. OBD II compatibility tests performed on the same test vehicle showed that Series 670000 TWC did not affect the vehicle‘s ability to perform OBD 11 system monitoring. The following are the test results in grams per mile: NMOG CO NOx 100K Standards 0.055 2.1 0.3 Series 670000 Test 1 0.037 0.6 0.1 Series 670000 Test 2 0.035 0.6 0.1

«9. WHEREAS, evaluation of Series 670000 TWC using the procedures and criteria specified in Section (5)(B) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters" as adopted on October 25, 2007, showed that the catalytic converter meets the requirements for proper MIL illumination demonstration. THEREFORE, IT 18 HEREBY RESOLVED that Eastern Manufacturing, Inc.‘s 670000 TWC is exempted from the prohibitions in Vehicle Code Sections 27156 and 38391 for installation on the approved vehicle applications specified in Appendix D—665—4 subject to the following conditions: 1. No changes are permitted to the catalytic converter as described in the application for exemption. Any changes to the catalytic converter or any of their components, and other factors addressed in this order must be evaluated and approved by the Air Resources Board prior to marketing in California. Marketing of the catalytic converter using identifications other than those shown in the exemption application, and in this Executive Order, or marketing of the catalytic converter for application other than the ones shown in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. Exemption of this product shall not be construed as an exemption to sell, offer for sale, or advertise any components of the catalytic converter as individual devices. Any oral or written references to this Executive Order or its content by Eastern Manufacturing, Inc., its principals, agents, employees, distributors, dealers, or other representatives must include the disclaimer that the Executive Order or the exemption it provides is not an endorsement or approval of any emission reduction claims for the catalytic converter and is only a finding that the catalytic converter is exempt from the prohibitions of Vehicle Code Sections 27156 and 38391. Eastern Manufacturing, Inc.‘s installation instructions for the new catalytic converter must conform to requirements in Section (h) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007. Installation of the catalytic converter shall not cause the relocation of an oxygen sensor. Oxygen sensors must be installed in the same location, position and orientation as prescribed in the original equipment manufacturer‘s configurations. Upon installation, the catalytic converter must carry a manufacturer‘s warranty for five (5) years or 50,000 miles as prescribed in Section (f)(2) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007. Eastern Manufacturing, Inc. and its vendors may not advertise the new aftermarket catalytic converter as "high flow or easy flow" catalytic converter or use any phrase that could make them appear to perform better than the original equipment manufacturer (OEM) catalytic converters. EASTERN MANUFACTURING, INC. — CATALYTIC CONVERTER — D—665—4

—3. 8. Any marketing arrangement of the new aftermarket catalytic converter by a third party, which involves the use of packaging identification different from the ones described in this Executive Order, must be approved by the Air Resources Board prior to shipment. 9. Eastern, its associates, vendors, other businesses, and individuals associated with Eastern, may not sell or supply new aftermarket catalytic converter substrates to a third party to be assembled in a different facility and marketed under this Executive Order without approval from the Air Resources Board. 10. Eastern Manufacturing, Inc. shall comply with the quality control procedures and reporting requirements in Section (1)(5) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted October 25, 2007. 11. Quality control reports must be submitted on a quarterly basis and warranty information reports must be submitted on a semi—annual basis. 12. Eastern Manufacturing, Inc. must provide a permanent label or stamp as specified under Section (1)(1) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted on October 25, 2007. 13. Eastern Manufacturing, Inc.‘s vehicle application catalog must conform with the requirements as specified under Section (f)(4) of the "California Evaluation Procedures for New Aftermarket Catalytic Converters," as adopted on October 25, 2007. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a 30—day written notice of intention to revoke it, during which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within 30 days of receipt of the request, and the order may not be revoked until a determination is made, after the hearing, that grounds for revocation exist. Executed at El Monte, California, this IZ day of May 2010. oASoae? Annette Hebert, Chief Mobile Source Operations Division EASTERN MANUFACTURING, INC. — CATALYTIC CONVERTER — D—665—4

Appendix D—665—4 Eastern Manufacturing, Inc. SERIES 670000 OBD i HONDA MANIFOLD/CONVERTER APPLICATION Model Year Vehicle Model Eg?Zige Engine Family Certification Level Weight Class Exhaust Type Total Converters| Converter Type Monitored| Universal# Direct Fit # 2001 CIVIC COUPE, SEDAN, DX, LX 1HNXVO1.7YJ9 N/A 670001 2002 CIVIC COUPE, SEDAN, DX, LX 2HNXVO1.7TAS N/A 670001 2003 CIVIC COUPE, SEDAN, DX, LX] 1.7L 3HNXVO1.7WAS ULEV PC S 1 TWC 1 N/A 670001 2004 CIVIC COUPE, SEDAN, DX, LX 4HNXVO1.7WA6G N/A 670001 2005 CIVIC COUPE, SEDAN, DX, LX 5BHNXVO1.7MA6 N/A 670001 REVISION 1.0


Document Created: 2010-06-29 12:21:30
Document Modified: 2010-06-29 12:21:30

Previous E.O. D-665-3 | Previous E.O. D-664 | Next E.O. D-665-5 | Next E.O. D-666