Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on June 15, 1999.
As of Wednesday, November 27th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsModification
38401989-98 4.0L Ford Ranger and Explorer66mm throttle body

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-215-41
  • Executive Order 215-41 / D215-41
  • ARB # D-215-41
  • Executive Order No: D-215-41
  • C.A.R.B. No. D-215-41
  • Resolution D-215-41
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-215-41 PDF

D-215-41 Document:


CARB_D-215-41

                                                                                  (Page 1 of 2)

                                                State of California
                                            AIR RESOURCES BOARD


                                         EXECUTIVE ORDER D—215—41
                                   Relating to Exemptions Under Section 27156
                                                 of the Vehicle Code


                                       EDELBROCK CORPORATION
                                62mm, 66mm, 7O0mm, & 75mm Throttle Bodies


Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and

Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and Safety
Code and Executive Order G—45—9;

IT IS ORDERED AND RESOLVED: That the installation of the 62mm, 66mm, 7Omm, & 75mm Throttle
Bodies, manufactured by BBK Performance, Inc. and marketed by the Edelbrock Corporation, 2700 California
Street, Torrance, California 90509—2936 has been found not to reduce the effectiveness of the applicable vehicle
pollution control system and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for
the following vehicle applications:

Part No.           Vehicle Application            Engine Disp.            Size               Model—Year

3840                Ranger, Explorer              4.0L                    6G6mm               1989—98
3842                Thunderbird SC                3.8L                    7Omm                1989—95
3871             Mustang & Passenger Cars         4.6L                    7Omm                1996—99
3872             Mustang & Passenger Cars         4.6L                    75ram               1996—99
3873             Mustang & Passenger Cars         4.6L                    7Omm                1990—95
3874             F—150 & Expedition               4.6/5 AL                T5mm                1997—99
3875             Mustang Cobra                    4.6L 4Valve        62mm Twin Valve          1996—99
3875             Truck                            6.8L v10          62mm Twin Valve           1996—99

This Executive Order is valid provided that the installation instructions for the 62mm, 66mm, 7Omm, & 75mm
Throttle Bodies will not recommend tuning the vehicle to specifications different from those of the vehicle
manufacturer.

Changes made to the design or operating conditions of the 62mm, 66mm, 7Omm, & 75mm Throttle Bodies, as
exempt by the Air Resources Board, which adversely affect the performance of the vehicle‘s pollution control
system shall invalidate this Executive Order.

This Executive Order shall not apply to any Edelbrock 62mm, 66mm, 7Omm, & 75mm Throttle Bodies
advertised, offered for sale, or sold with or installed on, a motor vehicle prior to or concurrent with transfer to an
ultimate purchaser.

Marketing of the 62mm, 66mm, 7Omm, & 75mm Throttle Bodies using any identification other than that shown
in this Executive Order or marketing of the 62mm, 66mm, 7Omm, & 75mm Throttle Bodies for an application
other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air
Resources Board. Exemption of the 62mm, 66mm, 7Omm, & 75mm Throttle Bodies shall not be construed as
exemption to sell, offer for sale, or advertise any component of the kit as an individual device.


EDELBROCK                                                                 Executive Order D—215—41
The 6Z2mm, 66mm, 7Omm, & 75mm Throttle Bodies                             (Page 2 of 2)




This Executive Order does not constitute any opinion as to the effect the use of the 62mm, 66mm, 7Omm, &
75mm Throttle Bodies may have on any warranty either expressed or implied by the vehicle manufacturer.

This Executive Order is granted based on the following submitted emissions test data using the 75mm
Edelbrock/BBK Throttle Body:

                     1998 5.4L LEV certified Ford Expedition
                     NMOG CO          NOX HCHO
Standards            0.195     50     06       0.022
Device w/ dfs         0.093      14     0.1      0.001

Test results showed that the 75mm throttle body when installed on the vehicle did not cause tailpipe emissions to
exceed the vehicle‘s applicable emission standard during a Cold Start CVS—75 Federal Test Procedure. This
Executive Order is also based on On Board Diagnostic II (OBD II) testing conducted on the same test vehicle.
Test data showed that the 75mm throttle body when installed on the vehicles did not affect the vehicle‘s ability to
perform its OBD II monitoring.

THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION,
APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY
CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED
BENEFITS OF THE EDELBROCK CORPORATION‘S 62MM, 66MM, 70MM, & 75MM THROTTLE
BODIES.

No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action
taken herein in any advertising or other oral or writter communication.

Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked
only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may
request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within
ten days of receipt of the request and the order may not be revoked until a determination after hearing that
grounds for revocation exist.




                                        R. B. Summerfield, Chief
                                        Mobile Source Operations Division



Document Created: 2005-09-01 12:14:22
Document Modified: 2005-09-01 12:14:22

Previous E.O. D-215-40 | Previous E.O. D-214 | Next E.O. D-215-42 | Next E.O. D-216