Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 9, 1991.
As of Tuesday, April 22nd, 2025 this Executive Order has not been overturned or superceeded.

Approved Parts

Models
1990-1992 Ford and mazda light-duty trucks powered by a 4.0 L V6 Gasoline engine.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-216-3
  • Executive Order 216-3 / D216-3
  • ARB # D-216-3
  • Executive Order No: D-216-3
  • C.A.R.B. No. D-216-3
  • Resolution D-216-3
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-216-3 PDF

D-216-3 Document:

CARB_D-216-3

(Page 1 of 2) State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—216—3 Relating to Exemptions Under Section 27156 of the Vehicle Code J. BITTLE AMERICAN, INC. SHORTY HEADER, MODEL NO. 1633 Pursuant to the authority vested in the Air Resources by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the undersigned by Section 39515 and 39516 of the Health and Safety Code and Executive Order G—45—5; IT 1$ ORDERED AND RESOLVED: That the installation of the Shorty Header Model No. 1633 manufactured by J. Bittle American, Inc. of 9630 Aero Dr., San Diego, CA 92123, has been found not to reduce the effectiveness of required motor vehicle pollution control devices, and therefore is exempt from the prohibitions of Section 27156 of the Vehicle Code for 1990—92 model—year Ford and Mazda light—duty trucks powered by a 4.0 liter V—6 gasoline engine. This Executive Order is valid provided that installation instructions for this device will not recommend tuning the vehicle to specifications different from those submitted by the device manufacturer. Changes made to the design or operating conditions of the device, as exempted by the Air Resources Board, that adversely affect the performance of a vehicle‘s pollution control system shall invalidate this Executive Order. Marketing of this device using an identification other than that shown in this Executive Order or marketing of this device for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. Exemption of a kit shall not be construed as an exemption to sell, offer for sale, or advertise any component of the product as an individual device. This Executive Order does not constitute any opinion as to the effect that the use of this device may have on any warranty either expressed or implied by the vehicle manufacturer. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF THE J. BITTLE AMERICAN, INC. SHORTY HEADER MODEL NO. 1633.

J. BITTLE AMERICAN, INC. EXECUTIVE ORDER D—216—3 (Page 2 of 2) No claim of any kind, such as "Approved by the Air Resources Board" may be made with respect to the action taken herein in any advertising or other oral or written communications. Section 17500 of the Business and Professions Code makes untrue or misleading advertising unlawful, and Section 17534 makes violation punishable as a misdemeanor. Section 43644 of the Health and Safety Code provides as follows: "43644, (a) No person shall install, sell offer for sale, or advertise or except in an application to the state board for certification of a device, represent, any device as a motor vehicle pollution control device for use on any used motor vehicle unless that device has been certified by the state board. No person shall sell, offer for sale, advertise, or represent any motor vehicle pollution control device as a certified device which, in fact, is not a certified device. Any violation of this subdivision is a misdemeanor." Any apparent violation of the conditions of this Executive Order will be submitted to the Attorney General of California for such action as he deems advisable. Executed at El Monte, California, this E day of September, 1991. /4 e R.B."Summerfield Assistant Division Chief Mobile Source Diviston

State of California AIR RESOURCES BOARD EVALUATION OF J. BITTLE AMERICAN, INC. SHORTY HEADER MODEL NO. 1633 FOR EXEMPTION FROM THE PROHIBITIONS OF VEMHICLE CODE SECTION 27156 IN ACCORDANCE WITH SECTION 2222, TITLE 13, OF THE CALIFORNIA CODE OF REGULATIONS September 1991

State of California AIR RESOURCES BOARD EVALUATION OF J. BITTLE AMERICAN, INC. SHORTY HEADER MODEL NO. 1633 FOR EXEMPTION FROM THE PROHIBITIONS OF VEMICLE CODE SECTION 27156 IN ACCORDANCE WITH SECTION 2222, TITLE 13, OF THE CALIFORNIA CODE OF REGULATIONS by Mobile Source Division State of California Air Resources Board 9528 Telstar Avenue: E1 Monte, CA 91731—2990 {This report has been reviewed by the staff of the California Air Resources Board and approved for publication. Approval does not signify that the contents necessarily reflect the views and policies of the Air Resources Board, nor does mention of trade names or commercial products constitute endorsement or recommendation for use.)

Page Number SUMMARY CONTENTS 11 1. INTRODUCTION II. CONCLUSION III. RECOMMENDATION IV. SHORTY HEADER DESCRIPTION DISCUSSION OF THE SHORTY HEADER —oro VI. APPENDIX «& CONTENTS LIST B 11

SUMMARY J. Bittle American, Inc. (JBA) of 9630 Aero Dr., San Diego, CA. 92123 has applied for an exemption from the prohibitions in Section 27156 of the California Vehicle Code (VC) for the Shorty Header, Model No. 1633. The Shorty Header is designed for installation on 1990—1992 Ford and Mazda light—duty trucks powered by a 4.0 liter Y—6 with EFI gasoline engine. JBA has submitted a completed application and all the required information including comparative exhaust emissions test data from an independent laboratory which shows that the Shorty Header does not have any adverse effects on the emissions of the applicable vehicles. The staff recommends that JBA be granted an exemption as requested and that Executive Order D—216—3 be issued for their Shorty Header, Model No. 1633.

EVALUATION OF J. BITTLE AMERICAN, INC. SHORTY HEADER MODEL No. 1633 FOR EXEMPTION FROM THE PROHIBITIONS OF VEKICLE CODE SECTION 27156 IN ACCORDANCE WITH SECTION 2222, TITLE 13, OF THE CALIFORNIA CODE OF REGULATIONS I. INTRODUGTION J. Bittle American, Inc. (JBA) of 9630 Aero Dr., San Diego, CA. 92123 has applied for an exemption from the prohibitions in Section 27156 of the California Vehicle Code (VC) for the Shorty Header, Model No. 1633. The Shorty Header is designed for installation on 1990—1992 Ford and Mazda light—duty trucks powered by a 4.0 liter V—6 with EFI gasoline engine. JBA has submitted a completed application and all the required information including comparative exhaust emissions test data performed at Milton Roy Company. 11. CONCLUSTONS Based on submitted data from emissions testing performed at an independent laboratory, the staff concludes that the Shorty Header does not have any adverse effects on emissions of the applicable vehicles. III. RECOMMENDATION The staff recommends that JBA be granted an exemption as requested and that Executive Order D—216—3 be issued for their Shorty Header, Model No. 1633. IV. SHORTYHEADERDESCRIPTIGN The JBA Shorty Header is designed to replace the original equipment manufacturer‘s (OEM) exhaust manifold. Compared to the OEM which has variable diameters and bottle necks, the tube diameter of Shorty Header‘s individual tubes remain constant from the engine block to the junction which connects to a single exhaust pipe. —1—

The manufacturer claims this feature enhances exhaust flow. All other characteristics of the OEM exhaust manifold are the same as the Shorty Header . v. DISCUSSIONOFTHESHORTYHEADER JBA Shorty Header, Model No. 1633 is designed for installation on 1990— 1992 model—year Ford and Mazda light—duty trucks powered by a 4.0 liter V—6 gasoline engine. A 1991 Ford Explorer powered by a 4.0 liter gasoline engine with Shorty Header, Model No. 1633 installed was used as the test vehicie. Testing consisted of one cold—start CVS—75 Federal Test Procedure with the JBA Shorty Header installed. Test results were compared against the vehicle‘s emission standards. The following are the emissions test results from testing conducted at Milton Roy Company. Independent Laboratory: Milton Roy Company, 1238 West Grove Ave., Orange, CA 92665—4134 Data THC co NOx Standard 0 .50 9.0 1.0 W/Device 0.13 2.25 0.29 D. F. 1.00 1.15 1.00 Results from test conducted at Milton Roy Company show the vehicle emissions with the JBA Shorty Header installed to be lower than the emission standards. Therefore, the Shorty Header kit Model No. 1633 has demonstrated compliance with the requirements for the VC 27156 exemption.

APPENDIX

J. Gittle American |nc. A JBA Shorty # 18633 consists of: Each of the following for the right and lefl side of the engine. One 3/8" mild steel head flange ow Three 1—1/2" diameter tubes o« One collector o# One collector flange o% One collector to exhaust—pipe sealing dome o# One high temperature head flange gasket % All fasteners required for installation % One Y—PIPE to connect manifolds to factory catalytic converters # The principle of operation is simple: The manifold collects the exhaust gases from the exhaust ports, collects them, and provides a single passage to deliver the gases to the OEM catalytic converters. These exhaust manifolds are to be buill exclusively by JBA J _ B J To T L OE A _M__E _R 1| C _A N 9630 Aaro Drive « San Diego, California 92123 » (619) 560—2030 » FAX (619) 560-‘64655 Cz w22z zs 10 .. Mucleg Into the futura


Document Created: 2005-09-01 12:40:43
Document Modified: 2005-09-01 12:40:43

Previous E.O. D-216-2 | Previous E.O. D-215 | Next E.O. D-216-4 | Next E.O. D-217