Approval Details

Valid E.O.

Validity

This Executive Order approved the specified parts on on September 5, 2008.
As of Thursday, December 26th, 2024 this Executive Order has not been overturned or superceeded.

Approved Parts

Part NumberModelsRemarks
See PDF2007 to 2009 model year 5.4L Shelby GT500 and 2005 to 2006 model year Ford Supercharged GTThe Whipple Supercharger Kit, part numbers WIK-5.4L-4VGT and WIK-5.4L-4VGT500, is a replacement supercharger for vehicles originally equipped with a stock supercharger. The kit includes a twin screw Whipple, new open element air filter with intake air tubing, 105mm mass air flow sensor, and a new ECM calibration. Maximum boost produced by the supercharger is around 16 pounds per square inch. No changes are made to the stock throttlebody or radiator thermostat and installation would not require any modification to any fuel or emission related tubing. Supercharger is designed to be a direct bolt-on replacement to the stock supercharger. The Whipple Pulley Kits, part numbers WIK-5.4L-4VPGT and WIK-5.4L-4VPGT500, utilize the stock supercharger and include a different size supercharger pulley, 105mm mass air flow sensor, new ECM calibration, and a new open element air filter with intake air tubing. Boost is increased to around 16 pounds per square inch. The new ECM calibration and/or programmer for both kits does not have any emission related user adjustments nor does it have capability to allow the user to upload new fuel and timing maps.

This Executive Order may be listed as:
  • C.A.R.B.E.O. D-231-29
  • Executive Order 231-29 / D231-29
  • ARB # D-231-29
  • Executive Order No: D-231-29
  • C.A.R.B. No. D-231-29
  • Resolution D-231-29
For Free CARB Executive Order Status verification, email an image of the device Executive Order label as well as the Year/Make/Model and Test Group # of the vehicle to [email protected]

Download: Executive Order D-231-29 PDF

D-231-29 Document:

CARB_D-231-29

State of California AIR RESOURCES BOARD EXECUTIVE ORDER D—231—29 Relating to Exemptions Under Section 27156 of the California Vehicle Code Whipple Industries, Inc. Whipple Supercharger and Pulley Kits Pursuant to the authority vested in the Air Resources Board by Section 27156 of the Vehicle Code; and Pursuant to the authority vested in the undersigned by Section 39515 and Section 39516 of the Health and Safety Code and Executive Order G—02—003; IT IS ORDERED AND RESOLVED: That the installation of the Whipple Supercharger and Pulley Kits, produced and marketed by Whipple Industries, Inc. of 3292 N. Weber, Fresno, California 93722, has been found not to reduce the effectiveness of the applicable vehicle pollution control systems and, therefore, is exempt from the prohibitions of Section 27156 of the Vehicle Code for the 2007 to 2009 model year 5.4L Shelby G1T500 and 2005 to 2006 model year Ford Supercharged GT as listed in Exhibit A. The Whipple Supercharger Kit, part numbers WIK—5.4L—4VGT and WIK—5.4L—4VGT500, is a replacement supercharger for vehicles originally equipped with a stock supercharger. The kit includes a twin screw Whipple, new open element air filter with intake air tubing, 105mm mass air flow sensor, and a new ECM calibration. Maximum boost produced by the supercharger is around 16 pounds per square inch. No changes are made to the stock throttlebody or radiator thermostat and installation would not require any modification to any fuel or emission related tubing. Supercharger is designed to be a direct bolt—on replacement to the stock supercharger. The Whipple Pulley Kits, part numbers WIK—5.4L—4VPGT and WIK—5.4L—4VPGT500, utilize the stock supercharger and include a different size supercharger pulley, 105mm mass air flow sensor, new ECM calibration, and a new open element air filter with intake air tubing. Boost is increased to around 16 pounds per square inch. The new ECM calibration and/or programmer for both kits does not have any emission related user adjustments nor does it have capability to allow the user to upload new fuel and timing maps. This Executive Order is valid provided that the installation instructions for the Whipple Supercharger and Pulley Kits will not recommend tuning the vehicle to specifications different from those of the vehicle manufacturer. Changes made to the design or operating conditions of the Whipple Supercharger and Pulley Kits, as exempt by the Air Resources Board, which adversely affect the performance of the vehicle‘s pollution control system shall invalidate this Executive Order.

2. This Executive Order shall not apply to any Whipple Supercharger and Pulley Kits advertised, offered for sale, sold with, or installed on a new motor vehicle prior to or concurrent with transfer to an ultimate purchaser. Marketing of the Whipple Supercharger and Pulley Kits using any identification other than that shown in this Executive Order or marketing of the Whipple Supercharger and Pulley Kits for an application other than those listed in this Executive Order shall be prohibited unless prior approval is obtained from the Air Resources Board. This Executive Order does not constitute any opinion as to the effect the use of the Whipple Supercharger and Pulley Kits units may have on any warranty either expressed or implied by the vehicle manufacturer. This Executive Order is granted based on submitted emission test data generated on a > 2007 model year 5.4L Ford Shelby GT500 certified to the Low Emission Vehicle II Low Emission Vehicle (LEV II LEV) emission standards and modified with the replacement Whipple Supercharger Kit, part number WIK—5.4L—4VGT500 using the 2.3L compressor and the 2.625 inch diameter supercharger pulley. Test results on the Shelby GT500 showed that emission levels, with Whipple Industries, Inc.‘s Whipple Supercharger installed, met the applicable emission standards when tested using the Cold—Start CVS—75 Federal Test Procedure (FTP) and the Supplemental Federal Test Procedure (SFTP USO6/S5C03) test cycles. Boost pressure was measured at 16 pounds per square inch, stock is rated at 9 pounds per square inch. Examination of the OBD II system showed the Whipple Supercharger did not affect OBD II system operation. Results from emission testing conducted at the Roush Emissions Laboratory, Livonia, Michigan are listed below with deterioration factors applied. 2007 model year Ford Shelby GT500 CVS—75 FTP NMOG CO NOx HCHO Standards ©0.075 3.4 0.05 — 0.015 Device Test 0.041 0.7 0.05 0.001 USO6/SC03 NMHC+NOx CO Standards 4k 0.14/0.20 8.0/2.7 Device 0.03/0.01 1.3/0.6 The Air Resources Board reserves the right in the future to review this Executive Order and the exemption provided herein to assure that the exempted add—on or modified part continues to meet the standards and procedures of Title 13, California Code of Regulations, Section 2222, et seq. THIS EXECUTIVE ORDER DOES NOT CONSTITUTE A CERTIFICATION, ACCREDITATION, APPROVAL, OR ANY OTHER TYPE OF ENDORSEMENT BY THE AIR RESOURCES BOARD OF ANY CLAIMS OF THE APPLICANT CONCERNING ANTI—POLLUTION BENEFITS OR ANY ALLEGED BENEFITS OF WHIPPLE INDUSTRIES, INC.‘S WHIPPLE SUPERCHARGER AND PULLEY KITS. No claim of any kind, such as "Approved by the Air Resources Board", may be made with respect to the action taken.herein in any advertising or other oral or written communication. WHIPPLE INDUSTRIES. INC. —WHIPPLE SUPERCHARGER — D—231—29

—3. Violation of any of the above conditions shall be grounds for revocation of this order. The order may be revoked only after a ten—day written notice of intention to revoke the order, in which period the holder of the order may request in writing a hearing to contest the proposed revocation. If a hearing is requested, it shall be held within ten days of receipt of the request and the order may not be revoked until a determination is made after the hearing that grounds for revocation exist. Executed at El Monte, California, this 5* day of September 2008. Annette Hebert, Chief Mobile Source Operations Division WHIPPLE INDUSTRIES. INC. —WHIPPLE SUPERCHARGER — D—231—29

— Exhibit A MAX CRANK ENGINE | COMPRESSOR SC YEARS MAKE WHIPPLE KIT # (LITER) B('))(S)IST SI7F PLSJII_;EY PULLEY 2005—2006|Ford GT WIK—5.4L—4VGT 5.AL 15 3.3L 6.500 3.500 2005—2006|Ford GT WIK—5.4L—4VGT 5.AL 15 3.3L 6.500 3.750 2005—2006|Ford GT WIK—5.4L—4VPGT 5.AL 16 2.3L 6.500 2.780 2005—2006|Ford GT WIK—5.4L—4VPGT 5.AL 15 2.3L. 6.500 2.870 2007—2009]|Shelby GT500 WIK—5.4L—4VPGT500 5.AL 15 2.1L 7.500 2.625 2007—2009 |Shelby GT500 WIK—5.4L—4VPGT500 5.AL 15 2.1L 7.500 2.750 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 2.3L 7.500 2.0625 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.4L 15 2.3L 7.500 2.750 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.4L 15 2.3L. 7.500 2.875 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 2.3L 7.500 3.000 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 2.9L 7.500 2.625 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.4L 15 2.9L 7.500 2.750 _ 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL _ 15 2.9L 7.500 2.875 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.4L 15 2.9L 7.500 3.000 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 S.AL 15 2.9L 7.500 3.125 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 2.9L 7.500 3.250 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 2.9L 7.500 3.375 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 2.9L 7.500 3.500 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 3.3L. 7.500 3.000 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 3.3L. 7.500 3.250 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 3.3L 7.500 3.500 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5.AL 15 3.3L 7.500 3.750 2007—2009 |Shelby GT500 WIK—5.4L—4VGT500 5AL 15 3.3L. 7.500 4.000


Document Created: 2008-10-31 14:16:14
Document Modified: 2008-10-31 14:16:14

Previous E.O. D-231-28 | Previous E.O. D-230 | Next E.O. D-231-30 | Next E.O. D-232